Transverse heated filter atomizer for electrothermal atomic absorption spectrometry

The filter furnace atomization concept was applied for the transverse heated atomizer. A graphite filter with graphite fiber reeled onto it was inserted into the tube of the standard transverse heated graphite atomizer (THGA) in the place of the platform. Automatic plugging of the sampling hole was applied during the atomization stage. The performance of the filter atomizer (THFA), compared with the THGA, was tested for the determination of Ag, As, Au, Bi, Cd, Cu, Ga, In, Mn, Pb, Sb, Se and Tl. The analytical performances of the THFA displayed some advantages in comparison with the THGA. The sampling volume varied in the range of 5–90 μl, while drying time for any volume was less than half of that used for the THGA. Owing to the reduced diameter of the analytical zone (2 mm) along the filter axis, a sensitivity improvement was observed for all elements, 1.3–2.8-fold without plugging and 4.3–4.8-fold for Bi, Cd, Pb and Tl with plugging of the dosing hole. An increased peak width (by two to five times for the elements tested) limited the determination of less-volatile metals. The intensity of light decreased by 20–30% in comparison with the THGA. Taking into account the sensitivity, sampling volume, light loss and signal width, the calculated gain in relative detection limit is substantial (about 2.5–7 times) only for volatile elements when the plugging is applied. The pyrolysis temperatures for Ag, As, Au, Cd, Cu and Se in the THFA without addition of modifier were by 200–600°C higher than in the THGA using Pd/Mg modifier. The lifetime of THFA tubes was similar to that of THGA tubes.