The mass normalization of the displacement and strain mode shapes in a strain experimental modal analysis using the mass-change strategy

The classic experimental modal analysis (EMA) is a well-known procedure for determining the modal parameters. The less frequently used strain EMA is based on a response measurement using strain sensors. The results of a strain EMA are the modal parameters, where in addition to the displacement mode shapes the strain mode shapes are also identified. The strain EMA can be used for an experimental investigation of a stress–strain distribution without the need to build a dynamical model. It can also be used to determine the modal parameters when, during modal testing, a motion sensor cannot be used and so a strain sensor is used instead. The displacement and strain mode shapes that are determined with the strain EMA are not mass normalized (scaled with respect to the orthogonality properties of the mass-normalized modal matrix), and therefore some dynamical properties of the system cannot be obtained. The mass normalization can be made with the classic EMA, which requires the use of a motion sensor. In this research a new approach to the mass normalization in the strain EMA, without using a motion sensor, is presented. It is based on the recently introduced mass-change structural modification method, which is used for the mass normalization in an operational modal analysis. This method was modified in such a way that it can be used for the mass normalization in the strain EMA. The mass-normalized displacement and strain mode shapes were obtained using a combination of the proposed approach and the strain EMA. The proposed approach was validated on real structures (beam and plate).