Surface segregation of polypeptide-based block copolymer micelles: An approach to engineer nanostructured and stimuli responsive surfaces

We describe the surface segregation of polypeptide-based block copolymer micelles to produce stimuli-responsive nanostructures at the polymer blend/air interface. Such structures were obtained by simultaneous surface migration and self assembly at the surface of diblock copolymer/homopolymer blends. We employed blends composed of homopolymer (PS) and an amphiphilic block copolymer polystyrene-b-poly(l-glutamic acid) (PS-b-PGA). The surface was functionalized based on the preferential segregation to the polymer blend/air interface of the hydrophilic PGA block of the diblock copolymer upon annealing to water vapor. The surface migration of the diblock copolymer to the interface was demonstrated both by XPS and contact angle measurements. As a consequence, the PGA interfacial attraction leads to a large surface excess on diblock copolymer which in turn, through macrophase and microphase separation, produced separated domains at the surface with regions composed either of homo or block copolymer. Herein we demonstrate that the use of asymmetric diblock copolymers with a higher content in PS lead to spherical micellar assemblies randomly distributed at the surface. As observed by AFM imaging the blend composition, i.e. the amount of block copolymer within the blend influences the density of micelles at the surface. Finally, when exposed to water, the pH affects the surface morphology. The PGA segments are collapsed at low pH values and extended at pH values above 4.8, thus inducing variations on the topography of the films at the nanometer scale.