Compatibilization by Olefin Block Copolymer (OBC) in Polypropylene/Ethylene-Propylene-Diene Terpolymer (PP/EPDM) Blends

The compatibilization by olefin block copolymer (OBC) in the blends of polypropylene (PP)/ethylene-propylene-diene terpolymer (EPDM) and the phase morphology of the ternary blends were investigated by rheology, scanning electron microscopy (SEM), differential scanning calorimetry (DSC) and wide-angle X-ray diffraction (WAXD) measurements. It was found that the PP/EPDM blends exhibited enhanced mechanical properties in the presence of OBC. The addition of OBC had a significant influence on the phase separation behavior of the blends. For the PP/EPDM-50/50 heterogeneous blends, the addition of 15 phr OBC enabled the two-phase morphology to change from a droplet-matrix structure to a co-continuous one. In the temperature range of 150 to 200 °C, OBC was shown to have a better compatibility with PP than EPDM. The changes in viscosity ratio of the dispersed phase to matrix phase caused by adding OBC might be the dominant factor in controlling the coalescence of the dispersed phase domains. For the crystallization behavior of PP/EPDM/OBC ternary blends, OBC was found to have an induction effect on the formation of β-crystals of PP that was not proportional to the volume of OBC addition. In addition, DSC results showed that PP could induce the OBC crystallization and improve the crystallization temperature of OBC. The existence of simultaneous crystallization behavior between PP and OBC was also observed. A possible mechanism of phase evolution induced by crystallization was proposed.