|
|||||
|
|
Development of New Strain Gage for High-Pressure Hydrogen Gas Use |
|
| Authors: | T Matsuo J Yamabe H Furukawa K Seki K Shimizu S Watanabe S Matsuoka |
| Institution: | 1. Hydrogen Energy Test and Research Center (HyTReC), 915-1 Tomi, Itoshima-Shi, Fukuoka, 819-1133, Japan 2. International Research Center for Hydrogen Energy, Kyushu University, 744 Moto-oka, Nishi-ku, Fukuoka-shi, Fukuoka, 819-0395, Japan 3. International Institute for Carbon-Neutral Energy Research (WPI-I2CNER), Kyushu University, 744 Moto-oka, Nishi-ku, Fukuoka-shi, Fukuoka, 819-0395, Japan 5. Research Center for Hydrogen Industrial Use and Storage (HYDROGENIUS), Kyushu University, 744 Moto-oka, Nishi-ku, Fukuoka-shi, Fukuoka, 819-0395, Japan 4. Kyowa Electronic Instruments Co., Ltd., 3-5-1 Chofugaoka, Chofu-shi, Tokyo, 182-8520, Japan |
| Abstract: | The output changes of two conventional strain gages (Cu–Ni and Ni–Cr) and a newly-selected strain gage for high-pressure hydrogen gas use (Fe–Cr–Al) in 90 MPa hydrogen and nitrogen gases were measured under unloading conditions to find a high-performance strain gage for high-pressure hydrogen gas use. The changes in the outputs of the Cu–Ni and Ni–Cr gages in hydrogen gas were much larger than those in nitrogen gas, and the Fe–Cr–Al gage showed almost the same output changes in both gases. These results imply that the Fe–Cr–Al gage is superior to the others as a strain gage for high-pressure hydrogen gas use. A large amount of hydrogen entered the Cu–Ni and Ni–Cr foils, and the electrical resistances of these foils were significantly changed by hydrogen exposure, whereas almost no hydrogen entered the Fe–Cr–Al foil, and its electrical resistance was not changed. These resistance changes of the foils as a result of hydrogen entry were consistent with the gage output changes in hydrogen gas. |
| Keywords: | |
| 本文献已被 SpringerLink 等数据库收录！ | |