Effects of temperature and moisture on the mechanical properties of polyester resin in tension

The effect of environment on the physical and mechanical properties of composite materials in some cases is determined by the environmental sensitivity of the binder. The results of experimental investigation of the deformability and strength of polyester resin, widely used as a binder in composites, upon the action of stationary and quasi-stationary loads, temperatures, and moisture are presented. The ranges of acceptable values of these services factors are determined. The elastic modulus and tensile strength of the material are obtained from quasi-static tests. The viscoelastic behavior of the resin is investigated in creep tests. From the results of a short-term experiment with stepwise loading up to failure, it is found that the creep of specimens with a moisture content of 0.14% can be described by a linear viscoelastic model for stresses up to 20 MPa (two thirds of the strength). The action of single loading impulses is summarized according to the Boltzmann superposition principle. The temperature and absorbed moisture are considered as factors accelerating the relaxation processes in the material. The creep activation under the action of these factors is described using the methods of time-temperature and time-moisture equivalence. The results of short-term creep tests allow us to determine the relaxation characteristics of the material in stationary conditions. The long-term creep under close-to-service conditions is predicted using these data and quite good agreement with the control test is obtained. The sensitivity of the material characteristics (strength, elastic modulus, and creep strain) to the action of temperature and moisture is estimated. The creep strain is most sensitive to the action of environmental factors. For a fully saturated material (moisture content 1.64 wt.%), after one hour creep, this strain four times exceeds that of a dry one. The same growth in deformability is caused by an 18°C increase in temperature. A quantitative comparison of the characteristics of polyester and epoxy resins allows us to choose the binder for composites and to estimate the expected environmental effect. Presented at the 11th International Conference on Mechanics of Composite Materials (Riga, June 11–15, 2000). Translated from Mekhanika Kompozitnykh Materialov, Vol. 36, No. 3, pp. 395–406, May–June, 2000.