|
|||||
|
|
| 全光纤瓦级纳秒脉冲掺Yb放大器 | |
| 引用本文： | 刘丰年 徐玲玲 范万德 黄榜才 姜明顺 刘波 开桂云 袁树忠. 全光纤瓦级纳秒脉冲掺Yb放大器[J]. 光子学报, 2014, 38(12): 3057-3060 |
| 作者姓名： | 刘丰年 徐玲玲 范万德 黄榜才 姜明顺 刘波 开桂云 袁树忠 |
| 作者单位： | ( 1 南开大学 a.现代光学研究所 光电教育部重点实验室;b.物理科学学院 光电信息科学系,天津 300071 ) (2 中国电子科技集团公司第46 研究所,天津 300220) (3 山东大学 控制学院 光纤传感实验室,济南 250061) |
| 基金项目： | 国家自然科学基金(10674074)、国家973计划项目(2003CB314906)和天津自然基金项目(06YFJZJC00300)资助 |
| 摘 要： | 采用单模放大和包层抽运放大的级联方式,在主振荡功率放大系统中,将平均功率0.5 mW、脉宽20 ns以及重复频率为50 kHz的光脉冲安全放大到平均功率0.6 W、峰值功率600 W的脉冲输出.相应增益为30.8 dB.放大输出的脉冲信号信噪比为30 dB,脉冲形状基本没有发生畸变.在前置放大结构中抽运光通过级联熔融拉锥型波分复用器耦合,有效确保了抽运源(976 nm)的正常工作. |
| 关 键 词： | 光纤放大器 级联波分复用器 脉冲放大 隔离度 信噪比 信号增益 |
| 收稿时间： | 2007-09-25 |
All-fiber Watt-level Nanosecond Pulsed Yb-doped Fiber Amplifier |
|
| LIU Feng-Nian,XU Ling-Ling,FAN Wan-De,HUANG Bang-Cai,JIANG Meng-Shun,LIU Bei,KAI Gui-Yun,YUAN Shu-Zhong. All-fiber Watt-level Nanosecond Pulsed Yb-doped Fiber Amplifier[J]. Acta Photonica Sinica, 2014, 38(12): 3057-3060 | |
| Authors: | LIU Feng-Nian XU Ling-Ling FAN Wan-De HUANG Bang-Cai JIANG Meng-Shun LIU Bei KAI Gui-Yun YUAN Shu-Zhong |
| Affiliation: | (1 a.Key Laboratory of Opto-electronic Information and Technology,Ministry of Education,Institute of Modern Optics|b.Department of Optical-Electronic Information Science,Institute of Physics,Nankai University,Tianjin 300071,China) (2 Research Institutes 46th of Chinese Electronic Technology Group Company,Tianjin,300220,China) (3 Fiber Sensor Laboratory of Institute of Controlling,Shandong University,Jinan,250061,China) |
| Abstract: | The fiber-based amplification of a commercially packaged,fiber pigtailed pulsed diode laser operating at wavelength of 1 064 nm (bandwidth of 0.45 nm) was reported.The cascaded Yb-doped fiber amplifier could operate safely by using cascaded fused wavelength division multiplexing (WDM) in each single-mode amplification stage.The total isolation of cascaded WDM could protect the laser diodes from being destroyed by feedback of pump/signal power.At repetition rate of 50 kHz,pulse duration of 20 ns and average power of 0.5 mW,output power up to 0.6 W and peak power up to 600 W were obtained,with a high signal to noise ratio of 30 dB.The gain of the whole system is 30.8 dB and pulse distortion is not been observed. |
| Keywords: | Fiber amplifier Cascaded wavelength division multiplexing Pulse amplification Isolation Signal to noise ratio Gain of signal |
| 点击此处可从《光子学报》浏览原始摘要信息 | |
| 点击此处可从《光子学报》下载全文 | |