Effect of cold plasma process on the surface wettability of NBR and the kerosene resistance of NBR/PTFE composites

In this study, first the acrylonitrile‐butadiene rubber (NBR5080) was modified by argon (Ar), air, and oxygen plasma at low temperature, and the effect of plasma process (power, time, and pressure) on the surface properties of NBR5080, the interfacial properties, physical properties, and the mechanical properties of NBR5080/polytetrafluoroethylene (PTFE) composites were investigated. The state contact angle and the surface free energy were applied to characterize the surface wettability of NBR5080. The scanning electron microscope and the atomic force microscope were used to observe the surface morphology of the NBR5080. The chemical changes on the NBR5080 surface were verified by X‐ray photoelectron spectroscopy. The average water contact angle the NBR5080 declined obviously when NBR5080 was treated by Ar (100 W/600 s/30 Pa). The active oxygen groups were introduced onto the surface of NBR5080 by cold plasma treatment and more active group containing oxygen were observed on the samples treated by Ar plasma. The peel strength between the NBR5080 and the PTFE was increased obviously, which increased from 0 to 44.2 N?m^?1 for Ar plasma treatment. The mass and the dimension of NBR5080 increase sharply after immersing in kerosene, whereas the NBR5080/PTFE composites changed a little. The mechanical properties of NBR5080 and NBR5080/PTFE composites decreased as the immersion time in kerosene increased, but the decreased degree of NBR5080 is higher than NBR5080/PTFE composites.