Methods for research on immune complement activation on modified sensor surfaces

We have developed a methodological system consisting of a new surface sensitive quartz crystal microbalance with dissipation monitoring (QCM-D) sensor surfaces together with different surface modification methods for the investigation of surface associated complement activation in human sera. The QCM-D surface, 10 mm in diameter, was modified by spin-coating of poly(urethane urea) (PUUR) and polystyrene (PS). Some sensor surfaces were also sputtered with titanium (Ti) or modified by hydrophobic self-assembled monolayer (SAM) of an 18-carbon alkane thiol with a ---CH₃ end group. The amount of surface deposited complement protein was investigated by incubation of the modified sensor surfaces in human sera, followed by incubation with antibodies directed against complement factor 3c (C3c). The amounts of bound anti-C3c were then used as an arbitrary measure of surface induced complement activation. The order of complement activation of the different surfaces, as judged by three separate measurements per surface modification, was PUUR>PS=SAM>Ti. The Ti surface had a similar low degree of anti-C3c binding as the negative controls (heat inactivated sera). The novel QCM-D methodology was found to be very simple, accurate, sensitive and well suited as a screening method for complement activation and protein adsorption on different materials. We also compared the sensitivity of QCM-D method with surface plasmon resonance (SPR) for the quantification of protein adsorption and complement activation on gold sensor surfaces. The QCM-D method was equally sensitive as the SPR for the detection of protein adsorption from a solution independently if low flow rate (5 μl/min) was used. A slight increase in sensitivity was found at higher flow rate (30 μl/min). However, we found it difficult to use the SPR method on the Ti, PS and PUUR surfaces due to decreased light penetration of the modified SPR sensor chip.