The Effect of Precursor Chemistry on the Crystallisation and Densification of Sol-Gel Derived Mullite Gels and Powders

Stoichiometric and silica-rich mullite gels and powders were prepared using four different sol-gel methods. Thermal analysis, X-ray powder diffraction and dilatometry techniques were used to investigate the thermal decomposition, crystallisation and sintering of these mullite precursor gels. The method of preparation, by controlled hydrolysis of various mixtures of tetraethylorthosilicate, aluminium sec-butoxide and aluminium nitrate, affected the texture of the gels, producing single-phase or diphasic samples.The crystallisation sequence of the gels depended on the composition and method of preparation. Single phase mullite crystallised from homogeneous gels at 980°C, while diphasic gels initially formed of a mixture of -Al₂O₃ spinel and mullite, or simple -Al₂O₃ spinel, which subsequently transformed to mullite at 1260°C.Dilatometry and density measurement were used to investigate the sintering of compacts formed by pressing powders prepared from gels precalcined at 500°C. Varying the heating rates from 2 to 10°C min^-1 had little effect on the densification to 1500°C. However, the densification rate was sensitive to the degree of crystallinity and the amount and type of phases present at the sintering temperature. The presence of -Al₂O₃ spinel in the structure initially promoted densification, but the sintering rate was reduced considerably after mullite crystallised. Diphasic materials, especially those with an excess amount of silica in the original gel, sintered to higher densities due to the presence of excess silica promoting densification by viscous phase sintering.