用于波分复用系统的多峰干涉滤光片

介绍了用于波分复用系统的多峰干涉滤光片的设计原理,提出了滤光片透射峰位置的确定方法,讨论了影响滤光片半宽度和截止度的因素,给出了滤光片的膜厚容差分析结果,表明透射率监控标准偏差在<0.5%范围内,可以得到波形良好的多峰滤光片,最后给出了实验结果.     

磁控溅射技术制备ZnO透光薄膜

采用RF磁控溅射方法,在玻璃衬底上制备了择优取向的ZnO薄膜;通过台阶仪、X射线衍射技术、原子力显微镜和分光光度计分别测量了不同溅射功率条件下淀积的ZnO薄膜厚度(淀积速率)、结晶质量、表面形貌与粗糙度、透光光谱,报道了该薄膜结晶质量、薄膜粗糙度与其在可见光区透光率的关系.     

Contour lines of the optical functions for solids

The well-known equations for the optical functions of reflectance, transmittance and phase changes on reflection and transmission for a solid material have been rearranged into the form of simple geometric figures in the u, v (n, k) plane. The curves for F_p show a singularity on the n-axis.     

The microstructure and optical transmittance thermal analysis of sodium borosilicate bio-glasses

The conditions to fabricate the bulk porous specimens have been studied on account of sodium borosilicate (NBS) glasses. Glass composition, heat treatment at phase separation and TiO₂ addition have been considered in this study. Original glass samples of composition in mol%: sample A: 9.19 Na₂O - 23.58 B₂O₃ - 67.23 SiO₂, sample B: 9.29 Na₂O - 3.17 TiO₂ - 23.82 B₂O₃ - 63.72 SiO₂ were prepared by melting reagent grade chemicals (Na₂CO₃, HBO₃, SiO₂ and AgNO₃) in platinum crucibles at 1480°C for 1 h in air. The melts were poured onto stainless steel plates and were annealed at 500°C for 0.5 h after cooling. Thus, obtained samples were phase separated at 700°C for 2, 15, 25 and 50 h to study their microstructure by scanning electron microscope (SEM). Besides the direct study of the microstructure by SEM, information on glass structural changes of samples are provided by measuring in situ changes by the optical transmittance thermal analysis. The isothermal measurements were carried out at 700, 720 and 740°C. The temperature of phase separation, the leaching and nucleator addition (TiO₂), significantly influence the microstructure of the resulting leached product. TiO₂ additive seems to suppress crystallization of cristobalite: especially at the extended above heat treatment phase separation runs. The phase-separated domains of glasses containing above 80 moles of SiO₂ are so small that it is very hard to observe them by SEM. The glass composition in our case was selected in a way to have relatively large phase separated areas easily observed by SEM at magnification 20 000·. The influence of TiO₂ is not too pronounced. It seems to suppress the cristobalite crystallization, especially of longer heating runs. The image analysis of leached glasses shows the prevailing content of the skeletal phase in a comparison to pores. The TiO₂ content diminishes the content of the skeletal phase. This revised version was published online in July 2006 with corrections to the Cover Date.     

含氟聚合物在赤磷基抗红外发烟剂中的应用

在实验室条件下利用多波段红外辐射仪，测试了含四种不同聚合物的赤磷发烟剂燃烧产生的烟雾在远红外波段的透过率，并使用粉尘取样仪测试了烟雾的质量，计算出了各种烟雾质量消光系数．试验结果和计算表明：以含氟聚合物的赤磷发烟剂燃烧产生烟雾在远红外波段的质量消光系数最高，透过率最低，并分析了上述烟雾在远红外波段具有不同质量消光系数的原因．     

SnO_2 薄膜光谱透过率及气敏特性研究

研究了半导体氧化物ＳｎＯ２膜及其掺杂薄膜的光谱透过率气敏特性，导出了光波在固体介质中传播时的光折射率、消光系数、吸收系数的表示式，以及在“空气—薄膜—玻璃”三元系统中光透过率的近似表达式；解释了气敏使半导体氧化物薄膜系统光透过率变化的原因。所有这些结果与解释，与我们的实验结果相一致，也与一些文献报导的实验结果相符合［１，２］。     

Optochemical Sensor for Ammonia Based on a Lipophilized pH Indicator in a Hydrophobic Matrix

Abstract

An optical sensor for the determination of ammonia in water based on ion pairing has been investigated. A pH-sensitive dye is immobilized as an ion pair in a silicone matrix. The colour of the dye changes from yellow to blue depending on the concentration of ammonia in the sample solution. This change is reversible. The concentration of ammonia can be determined by measuring the transmittance at a given wavelength.

All measurements were performed with a dual-beam optical meter. The measurement range was from 5.9 × 10^?7 to 1 × 10^?3 M (0.01 to 17 mg/l) in 0.1 M phosphate buffer of pH 8. The detection limit was 10 μg/l. The response times at a flow rate of 2.5 ml/min were 4 min for t₉₀ and 10 min for t₁₀₀ at a change from 41.9 to 82.5 μM ammonia and 12 min for t₉₀ and 48 min for t₁₀₀ at a change from 160 to 0 μM ammonia. The operational lifetime of the ammonia sensor was limited to a period of a few days only. A continuous decrease in baseline signal and relative signal change was observed over the whole measurement. The storage stability was more than 10 months (dry). With respect to possible application of the ammonia sensor to environmental analysis, the influence of pH, typical interferences, such as amines and various detergents on the sensor response was investigated. No interference due to pH was observed in the range from pH 5 to pH 9. With methyl- and ethylamine the response was not completely reversible. The sensor was affected by cationic detergents, but not by anionic or neutral detergents.     

Side-lobeless far-field spectrum of a short pulse from a circular aperture with Gaussian form of transmittance

The spectrum change of a Gaussian pulse in the far field is studied with the Fresnel diffraction integral when it is incident on an aperture with Gaussian form transmittance. It is found that the side-lobes of the diffracted spectral intensity, which exist in a normal circular aperture with unit transmittance, can be eliminated completely under such a condition. Also, the red shift and blue shift of the spectral intensity maximum of the incident pulse are presented.     

The effect of terminal chain modifications on the mesomorphic properties of 4,4′-disubstituted diphenyldiacetylenes

The typical sidewalls produced in the fabrication of protrusion electrodes are proposed to create a low voltage (4.5 V_rms) and high transmittance (93%) blue-phase liquid crystal display (BP-LCD). The tilted electrodes produce a strong horizontal electrical field that reduces the operating voltage considerably. The common problem of the ‘dead zones’ is solved by reflecting the light onto the electrodes. In order to estimate the phase retardation of the reflected light, a ray tracing simulation program for anisotropic mediums has been developed. The proposed device is more competitive than vertical field switching based BP-LCD and also, has the advantages of protruded in-plane-switching structures. These facts make this technology a potential candidate for the next generation of BP-LCDs.     

射频磁控溅射透明ZnO薄膜的退火性质分析

采用射频(RF)磁控溅射法在玻璃衬底上制备了c轴择优取向的ZnO薄膜。对所制备的ZnO薄膜在空气气氛中进行不同温度(350~600℃)的退火处理。利用XRD研究退火对ZnO薄膜晶体性能和应力状态的影响;用扫描电子显微镜(SEM)观察薄膜的表面形貌;用分光光谱仪测试薄膜的透光率。研究表明,随退火温度的升高,ZnO薄膜(002)衍射峰强度不断增强,半高宽逐渐减小;ZnO薄膜中沿c轴方向存在着的张应力在500℃退火时得到松弛;退火处理后薄膜的平均透光率变化不大,但透射光谱出现了“红移”现象。