共晶体组织对Ag-CdO触头感应钎焊剪切强度的影响

介绍了感应钎焊氧化镉Ag CdO12 触头剪切强度试验结果 ,探讨了组织形态对Ag CdO12 触头感应钎焊强度的影响。结果表明 :当触头钎着率在 75 %以上时 ,触头的剪切强度随着钎缝共晶体组织的减少而增大     

轴流风扇叶片端导叶作用的研究

本文采用数值方法研究了叶片端导叶对轴流风扇性能的影响。通过与普通开式轴流风扇比较,分析了叶片端导叶对内部流动作用的机理.数值计算结果表明:叶片端导叶的安装位置将影响轴流风扇气动效率,安装叶片端导叶不能提高风扇静压升,但是在压力面安装时能有效地减小风扇叶顶泄漏流与主流的掺混损失;在设计流量下,压力面安装叶片端导叶使泄漏涡的作用范围较小,涡核更靠近吸力面;吸力面安装叶片端导叶弱化了泄漏涡的强度但没有减小泄漏涡的作用范围。     

前缘弯掠斜流转子叶顶间隙流动特性数值分析

本文对前缘弯掠斜流转子叶顶间隙内的流动特性进行了数值分析。结果表明:叶顶间隙气流与主流发生卷吸而生成泄漏涡。泄漏涡作用的区域具有较低的压力分布。在叶片通道内,泄漏涡沿着与转子旋向相反的方向朝相邻叶片的压力面移动。大间隙时的泄漏涡比小间隙时强烈。低流量时泄漏涡的作用区域比高流量时大。在各种流量特性下,叶顶尾缘近吸力面区域都存在着二次间隙流。     

Rugged distal tips for CO2 laser medicine

Low-loss and rugged distal tips for CO₂ laser have been proposed and fabricated based on a commercially available stainless steel (St) pipe. A method of smoothening the inner surface of the St pipe with a rough inner surface is put forward. Fabrication parameters, transmission properties, and mechanical strength of the cyclic olefin polymer-coated silver hollow St distal tip are experimentally discussed.     

某轴流压气机叶尖间隙效应实验研究

本文对某低速轴流压气机叶尖间隙尺度对性能的影响进行了实验研究,并通过不同的机匣结构情况研究一种叶尖漏流不敏感机匣。实验表明,不同的间隙尺度对叶轮机总体性能存在十分明显的影响。对绝大部分运行状态,小间隙下的压升和效率均明显高于大间隙的情况。另外,所采用的毛刷式和篦齿式的机匣实验结果表明,不论毛刷式还是篦齿式机匣,在大流量负攻角情况下对性能的影响不大,但毛刷式机匣并不能达到提高失速裕度的目的,而篦齿式机匣在小流量情况下对压升有所提高,但对效率影响不大。     

软土中薄硬夹层的夯扩桩工程实践

结合工程实践对夯扩桩在软土中薄硬夹层的应用进行了探讨,提出薄硬夹层作为桩端持力层的加固方法.     

Study on the anodic reaction of Ni in an alkaline solution by transient pH detection based on scanning electrochemical microscopy (SECM)

The anodic reaction of Ni in an alkaline solution was studied by the tip–substrate voltammetry mode of scanning electrochemical microscopy (SECM) and cyclic voltammetry (CV). A platinum microdisc electrode was selected as the tip electrode, which functioned as a pH sensor with transient response capability. The pH value of the solution near the Ni electrode surface varied while the Ni substrate oxidation reaction occurred, and the pH variation could be detected by the tip faradic current. The cyclic voltammogram results showed that two types of hydroxides: i.e. α‐Ni(OH)₂ and β‐Ni(OH)₂ were formed during Ni oxidation in the lower potential region. In the proceedings of α‐Ni(OH)₂ → γ‐NiOOH and β‐Ni(OH)₂ → β‐NiOOH, the process of OH^? concentration decrease in the solution was ahead and behind of electron transfer in the solid phase, respectively. These results indicate that the OH^? adsorption process occurs as an elementary step in the former reaction and the H⁺ diffusion process from the inner to the outer layer of the solid phase occurs as a subsequent step in the latter reaction. The results also revealed that the oxide film on the Ni surface has a two‐layer structure. The real potential of the oxygen evolution reaction (OER) on the Ni surface with different cycles is also analyzed in the paper. Copyright © 2007 John Wiley & Sons, Ltd.     

正交激励超声切削装置的椭圆轨迹偏转与校正

为研究超声椭圆振动切削（ultrasonic elliptical vibration cutting,UEVC）刀尖轨迹形成及控制,解决刀尖轨迹非正椭圆问题,建立二维正交柔性导波UEVC装置刀尖轨迹的运动学模型;分析90°相位差下非正椭圆轨迹产生原因,建立刀尖轨迹校正模型,并推导出基于正椭圆轨迹下的刀尖轨迹偏转模型。通过实验对刀尖轨迹校正模型进行验证,校正后轨迹偏离坐标轴1.67°,小于校正前偏离角度。实验结果表明,该模型能够有效地校正刀尖轨迹,可在轨迹控制方面为后续研究刀尖轨迹偏转及变刀尖轨迹超声振动加工提供理论基础。     

甘薯（Ipomoea batatas（L.）lam）不定根根尖细微结构的初步研究

顶端分生组织细胞有高的核质比,胸质中可见前质体和其它细胞,器。分化的组织原细胞中,皮层原细胞较中柱原和根冠表皮原细胞内前质体增多明显。     

Stabilities in field electron emissions from noble‐metal covered W nano‐tips: apex structure dependence

We observed field emission microscopy (FEM) patterns of noble‐metal (NM) covered W nano‐tips with three different apex structures fabricated by field evaporation. Each of the three tips was terminated with a single atom, three atoms or ten atoms. We investigated the temporal changes in the FEM of these tips to discuss the stabilities in the spatial distributions of the field emission (FE) beams. The single‐atom tip showed two characteristics that were superior to the others. First, the beams emitted from the single‐atom tip were the most collimated among the three tips (the semi‐cone angle of 1.0° , FWHM). Second, adsorption of residual gas had little influence on FE from the single‐atom tip, while the other tips were easily contaminated even at ultra high vacuum, resulting in the emission fluctuation. Copyright © 2006 John Wiley & Sons, Ltd.