Mobility of water molecules in Li+, Na+ and Cs+ ionic forms of Nafion membrane studied by NMR

Correlation times and diffusion coefficients of water molecules were measured for the first time by ¹H spin relaxation and pulsed field gradient NMR in Li⁺, Na⁺ and Cs⁺ ionic forms of Nafion 117 membrane. Hydration numbers of Li⁺, Na⁺ and Cs⁺ cations were calculated. It was shown that at high humidity macroscopic transfer is controlled by the local translational motion of water molecules.     

Theoretical studies on the influence of metallic cations on ring opening of propylene oxide catalyzed by metal-salen complexes

We studied the ring opening of propylene oxide (PO) by salen-M coordinated OH⁻ group [M = Al(III), Sc(III), Cr(III), Mn(III), Fe(III), Co(II), Co(III), Ni(II), Cu(II), Zn(II), Ru(III) and Rh(III)]. The results show that the ring-opening energy barriers for M(II) complexes are much lower than those with M(III) complexes in the gas phase, and the barriers correlate linearly with the negative charges on the OH⁻ group and the Fukui function condensed on the OH⁻ group. The nucleophilicity ordering in the gas phase can be rationalized by the ratio of formal positive charges/radius of M cations. Solvent effect greatly increases the barriers of M(II) complexes but slightly changes the results of M(III) ones, making the barriers similar. Analysis indicates that the reaction heats are linearly proportional to the reverse reaction barriers. The relationships established here can be used to estimate the ring-opening barriers and to screen epoxide ring-opening catalysts.     

疏松砂岩油藏大孔道定性识别新方法研究

疏松砂岩油藏在长期注水开发过程中,往往伴随着大孔道的出现,这严重影响了油藏水驱开发效果,制约了采出程度的进一步提高,因此,大孔道识别及有效封堵成为该类油藏急需解决的关键问题.通过研究分析,确定了影响大孔道从形成到发展的7种主要静态因素,以及标志大孔道形成的6种主要动态因素.将层次分析法及灰色关联法相结合,分别计算静态及动态因素的权重,建立了全新的大孔道定性识别模型.示踪剂监测结果验证了该方法的实用性和有效性.     

3D‐morphology reconstruction of nanoscale phase‐separation in polymer memory blends

In many organic electronic devices functionality is achieved by blending two or more materials, typically polymers or molecules, with distinctly different optical or electrical properties in a single film. The local scale morphology of such blends is vital for the device performance. Here, a simple approach to study the full 3D morphology of phase‐separated blends, taking advantage of the possibility to selectively dissolve the different components is introduced. This method is applied in combination with AFM to investigate a blend of a semiconducting and ferroelectric polymer typically used as active layer in organic ferroelectric resistive switches. It is found that the blend consists of a ferroelectric matrix with three types of embedded semiconductor domains and a thin wetting layer at the bottom electrode. Statistical analysis of the obtained images excludes the presence of a fourth type of domains. The criteria for the applicability of the presented technique are discussed. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 1231–1237     

Morphology and microphase separation of star copolymers

Star copolymers have attracted significant interest due to their different characteristics compared with diblock copolymers, including higher critical micelle concentration, lower viscosity, unique spatial shape, or morphologies. Development of synthetic skills such as anionic polymerization and controlled radical polymerization have made it possible to make diverse architectures of polymers. Depending on the molecular architecture of the copolymer, numerous morphologies are possible, for instance, Archimedean tiling patterns and cylindrical microdomains at symmetric volume fraction for miktoarm star copolymers as well as asymmetric lamellar microdomains for star‐shaped copolymers, which have not been reported for linear block copolymers. In this review, we focus on morphologies and microphase separations of miktoarm (A_mB_n and ABC miktoarm) star copolymers and star‐shaped [(A‐b‐B)_n] copolymers with nonlinear architecture. © 2014 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 1–21     

上海黄浦江两支流河流甲烷含量研究

甲烷是一种重要的温室气体,虽然目前大气中含量远小于二氧化碳,但排放增长率却大于后者.研究区域为上海市黄浦江支流苏州河和淀浦河,通过实验数据对比城郊春夏的甲烷排放的差异,探讨甲烷产生的机制及其与环境因子的关系,这将有助于研究河流甲烷排放对于环境变化的影响.研究结果认为河流甲烷主要来源于水中沉积物,其产生与水质、温度等因素相关;同时甲烷摩尔浓度与硝酸根离子质量体积比存在负相关性,与铵根离子质量体积比和有机碳质量分数存在正相关性.     

Formation of porous polymer morphology by microsyneresis during divinylbenzene polymerization

This article describes the investigation of the importance of various reaction conditions on microsyneretic pore formation during polymerization of divinylbenzene (DVB) under so‐called “solvothermal” conditions. To induce microsyneretic pore formation, the most important parameter is an unusually high dilution of monomers with a “good” porogen solvating the polymer chains. High dilution and solvation of the growing poly(DVB) chains promote the prolongation of the polymer chains rather than their interconnection by crosslinking. Consequently, when the polymer gel density reaches the point where syneresis starts, the polymer network is geometrically too extensive to be broken up into precipitating entities and, instead, porogen droplets are formed within the continuous polymer gel. The pore geometry created by microsyneresis offers high surface area in wide mesopores and hence, high capacity for supporting functional groups or reactions with much better accessibility than narrow pores between polymer microspheres produced by macrosyneresis in conventional styrenic polymer supports. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 774–781     

高静态动作压力下粉尘爆炸泄放标准的可靠性

粉尘爆炸泄放设计标准的可靠性对能否实现爆炸防护尤为关键.以中径70μm石松子粉尘为介质,采用20 L球形粉尘爆炸装置进行了4种泄放口径、静态动作压力在0.12~0.6 MPa的爆炸泄放实验,对比了实验值与NFPA 68和EN 14491计算值.结果表明,NFPA 68在预测高静态动作压力下的泄放面积时,随着泄放口径的增大,预测结果由保守变为危险,但预测结果精度较好且数值稳定;EN 14491在预测高静态动作压力下的泄放面积时非常保守,预测精度较差,数据不可靠.依据两种标准推荐的经验函数关系,分析了NFPA 68和EN 14491在预测高静态动作压力时产生这种差异的原因.     

Pattern universes

In this essay we explore analogies between macroscopic patterns, which result from a sequence of phase transitions/instabilities starting from a homogeneous state, and similar phenomena in cosmology, where a sequence of phase transitions in the early universe is believed to have separated the fundamental forces from each other, and also shaped the structure and distribution of matter in the universe. We discuss three distinct aspects of this analogy: (i) Defects and topological charges in macroscopic patterns are analogous to spins and charges of quarks and leptons; (ii) Defects in generic 3+1 stripe patterns carry an energy density that accounts for phenomena that are currently attributed to dark matter; (iii) Space-time patterns of interacting nonlinear waves display behaviors reminiscent of quantum phenomena including inflation, entanglement and dark energy.     

Assessing the nucleophilic character of 2-amino-4-arylthiazoles through coupling with 4,6-dinitrobenzofuroxan: Experimental and theoretical approaches based on structure-reactivity relationships

A kinetic study of the reactions of potentially bioactive 2-amino-4-arylthiazoles with highly reactive 4,6-dinitrobenzofuroxan (DNBF) is reported herein in acetonitrile solution. The complexation reaction was followed by recording the UV–vis spectra with time at λ_max = 482 nm. Electronic effects of substituents influencing the rate of reaction have been studied using structure-reactivity relationships. It is shown that the Hammett plot relative to the reaction of DNBF with 2-amino-4-(4-chlorophenyl)thiazole exhibit positive deviation from the log k₁ versus σ correlation, while it showed excellent linear correlation in terms of Yukawa–Tsuno equation. It has be noticed that the nonlinear Hammett plot observed for 2-amino-4-(4-chlorophenyl) thiazole is not attributed to a change in rate-determining step but is due to nature of electronic effect of substituent caused by the resonance of stabilization of substrates. The second-order rate constant (k₁) relating to the bond C–C and C-N forming step of the complexation processes of DNBF with 4-substituted-aminothiazoles and 2-amino-5-methyl-4-phenylthiazole, respectively, is fit into the linear relationship log k = s_N (N + E), thereby permitting the assessment of the nucleophilicity parameter (N) of the 2-amino-4-arylthiazoles of the range (4.90 < N < 6.85). 2-amino-4-arylthiazoles is subsequently ranked by positioning its reactivity on the general nucleophilicity scale developed recently by Mayr and coworkers (2003) leading an interesting and a direct comparison over a large domain of π-, σ -, and n-nucleophiles. The global electrophilicity/nucleophilicity reactivity indexes of the 2-amino-4-arylthiazoles have been investigated by means of a density functional theory (DFT) method. .