轧制道次间插入冷却对特厚钢板组织与性能的影响

使用实验轧机旁冷却装置配合轧机进行轧制实验，研究轧制道次间不同冷却工艺对特厚钢板组织和性能的影响规律.研究结果表明:采用道次间冷却工艺可以在全厚度方向获得组织细化及强韧性提高效果，采用强冷道次间冷却实验钢1/4处晶粒尺寸可细化至10μm，强度为376MPa，-40℃冲击功为169J;心部晶粒尺寸可细化至15μm，强度为360MPa，-40℃冲击功为123J.本工艺可形成470μm厚表层细晶层，晶粒尺寸可细化至5μm;粗轧道次间插入冷却工艺轧制钢板强度和冲击韧性优于中间坯冷却工艺;随冷却强度增加，钢板内部组织明显细化且强度大幅提高.     

机载海洋激光测深系统参量设计与最大探测深度能力分析

详细讨论了机载海洋激光测深系统最大测量深度与相关因子之间的关系，并利用最小可探测信噪比为判据，对机载海洋激光测深系统在白天和晚上工作进行了数值模拟，通过比较最大测量深度与激光脉冲峰值功率、接收视场角、接收口径和光谱接收带宽等关系，确定了系统的主要参量。以确定的参量建立的系统具有白天49m和晚上65m的最大测深能力，可完全满足在沿岸带以及岛礁的测量要求。     

Real-time onboard wind and windshear determination,part 2: Detection

This paper is concerned with windshear detection in connection with real-time wind identification (Ref. 1). It presents a comparative evaluation of two techniques, one based on the shear/downdraft factor and one based on the wind difference index. The comparison is done with reference to a particular microburst, that which caused the 1985 crash of Flight Delta 191 at Dallas-Fort Worth International Airport.The shear/downdraft factor has the merit of combining the effects of the shear and the downdraft into a single entity. However, its effectiveness is hampered by the fact that, in a real situation, the windshear is accompanied by free-stream turbulence, which tends to blur the resulting signal. In turn, this results in undesirable nuisance warnings if the magnitude of the shear factor due to free-stream turbulence is temporarily larger than that due to true windshear. Therefore, proper filtering is necessary prior to using the shear/downdraft factor in detection and guidance. One effective way for achieving this goal is to average the shear/downdraft factor over a specified time interval . The effect of on the average shear/downdraft factor is studied.     

Real-time onboard wind and windshear determination,part 1: Identification

Standard wind identification techniques employed in the analysis of aircraft accidents are post-facto techniques; they are processed after the event has taken place and are based on the complete time histories of the DFDR/ATCR data along the entire trajectory. By contrast, real-time wind identification techniques are processed while the event is taking place; they are based solely on the knowledge of the preceding time histories of the DFDR/ATCR data.In this paper, a real-time wind identification technique is developed. First, a 3D-kinematic approach is employed in connection with the DFDR/ATCR data covering the time interval preceding the present time instant. The aircraft position, inertial velocity, and accelerometer bias are determined by matching the flight trajectory computed from the DFDR data with the flight trajectory available from the ATCR data. This leads to a least-square problem, which is solved analytically every seconds, with / small.With the inertial velocity and accelerometer bias known, an extrapolation process takes place so as to predict the inertial velocity profile over the subsequent -subinterval. At the end of this subinterval, the extrapolated inertial velocity and the newly identified inertial velocity are statistically reconciled and smoothed. Then, the process of identification, extrapolation, reconciliation, and smoothing is repeated. Subsequently, the wind is computed as the difference between the inertial velocity and the airspeed, which is available from the DFDR data. With the wind identified, windshear detection can take place (Ref. 1).As an example, the real-time wind identification technique is applied to Flight Delta 191, which crashed at Dallas-Fort Worth International Airport on August 2, 1985. The numerical results show that the wind obtained via real-time identification is qualitatively and quantitatively close to the wind obtained via standard identification. This being the case, it is felt that real-time wind identification can be useful in windhsear detection and guidance, above all if the shear/downdraft factor signal is replaced by the wind difference signal (Ref. 1).This paper and its companion (Ref. 1) are based on Refs. 2–4.This research was supported by the Aviation Research and Education Foundation and by Texas Advanced Technology Program, Grant No. TATP-003604020.     

A stratospheric chemical reaction controlling climatic change

It has been established from geological studies that change in the atmospheric content of carbon dioxide gas commenced about one hundred million years ago. The likely origin of this change is advanced as being the onset of the Brewer circulation caused by the rise in terrain induced by tectonic plate movement. It is demonstrated that tectonic plate movement can be affected by impacts from external bodies which penetrate the crust of the Earth. The consequences of the change in atmospheric concentration of carbon dioxide are proposed as first, extinctions and reductions in animal numbers, including primates, as a result of changes in body chemistry of these animals and second, a change in the rate of weathering of rocks giving rise to changes in the availability of chemicals such as calcium and potassium which are essential for plant and animal life. This latter change contributing to the extinctions and reductions in animal numbers. It is shown that the change in weathering can account for the rise to dominance of angiosperm plants. It is concluded that there were several simultaneous evolutionary environments on Earth which were a function of altitude which gave rise to a vertical variation in atmospheric content of carbon dioxide. This variation disappeared with rise of terrain and the onset of the Brewer circulation. Such changes are advanced and being much more important than any changes in temperature caused by greenhouse effects since the disappearance of atmospheric variations in carbon dioxide allowed animal migration. It is demonstrated that the conditions of extinction could be reintroduced by human activities.     

强夯—塑料板排水法在粉土和粉质粘土地基加固中的试验研究

针对黄河中下游粉土、粉质粘土成层地基,通过插设塑料排水板和不插排水板条件下强夯对比试验研究,证实了插设塑料排水板可以有效的降低强夯时超静孔隙水压力峰值,加快其消散,缩短强夯施工工期;提高强夯夯沉,减少振动对土体的扰动,缩短触变恢复时间,因而人工塑料排水板在强夯处理此类地基中是十分有效的。     

在液化粉土中标准贯入与微型贯入试验的关系研究

本文以试验为基础，论述了野外标准贯入击数与室内微型贯入击数的统计关系，提出了在粉土液化判别上，室内微型贯入试验可替代野外标准贯入试验的新观点。     

沥青材料的感温性分析

在分析现有沥青感温性指标的基础上，讨论了针入度指数的局限性，认为采用粘温指数[VTS]能够合理表征沥青在路面服务温度内的感温性。并建立了针入度和粘度的换算关系，通过3种沥青实例计算了其[VTS]，再分析了计算模型的局限性和改性措施。结果表明，通过采用动态剪切流变仪或针入度试验结果换算出沥青粘度，来求算[VTS]是可行的。     

弹体对岩石的侵彻深度

采用统一强度理论作为岩石的破坏准则,基于动态空腔膨胀理论研究了弹体侵彻岩石靶时所受的阻力,以及刚性弹体对岩石的侵彻深度,并分析了破坏准则、弹头形状、摩擦系数等因素对侵彻深度的影响,与试验资料进行了比较。结果表明,当弹体初始速度低于1200m·s-1时,采用双剪强度理论的计算结果与试验资料符合较好,该模型是合理的,可作为相关问题研究的参考。