Gelation in free-radical terpolymerization of poly(allyl methacrylate) crosslinked polymer nanosphere with allyl benzoate and vinyl benzoate

Microgel-like poly(allyl methacrylate) (PAMA nanosphere) was prepared by the emulsion polymerization of AMA as the reactive crosslinked polymer nanosphere with abundant pendant allyl groups. The terpolymerization of PAMA nanosphere with allyl benzoate (ABz) and vinyl benzoate (VBz) was conducted in bulk using benzoyl peroxide as initiator at 80 °C. The gelation depended on the feed ABz/VBz molar ratio since the molecular weights of resulting poly(ABz-co-VBz)s that act as the bridges increased with an increase in the mole fraction of VBz in the feed monomer. Beyond the gel point, the sol was rapidly incorporated into the gel and the increasing tendency of the gel fraction became steeper from 70 to 95 mol% of VBz as a reflection of increased chain length of bridge between PAMA nanospheres. Moreover, the swelling ratio became lower with increasing the mole percentage of VBz in the feed monomer. These results would support the preferential incorporation of PAMA nanosphere into the gel and the longer bridge can capture more nanospheres to give a much shrunken gel.     

Morphology, crystallization behavior and properties of impact-modified polypropylene copolymer with or without sodium benzoate as a nucleating agent

 The morphology, crystallization behavior, and properties of an impact-modified polypropylene (PP) copolymer with or without sodium benzoate were investigated. The contents of ethylene–propylene rubber (EPR) in the reactor-made PP copolymer is about 15 wt%. For comparison, blends of PP and EPR containing the same EPR composition were prepared by melt-mixing. Morphological studies by scanning probe microscopy indicated that the impact-modified copolymer consists of three different phases, i.e., polyethylene, PP, and EPR phases, which is considerably different from the morphology of the conventional PP/EPR blend of the corresponding composition. The impact-modified PP copolymer exhibited a higher crystallization rate in terms of the lower crystallization half-time and thus higher thermal and mechanical properties, such as impact strength and hardness, than the PP/EPR blend did. The addition of sodium benzoate as a nucleating agent to the copolymer increased the crystallization rate and the mechanical properties. Received: 4 June 2001 Accepted: 31 October 2001     

用色谱-质谱和质量色谱研究苯甲酸钐热分解反应

为合成某些芳香族有机化合物提供一种新途径，用色谱－质谱联用技术和质量色谱法研究了苯甲酸钐的热分解反应产物。其热分解产物溶入丙酮后有大量９，１０－蒽醌析出，其丙酮溶液中还含有１，２－二苯甲酰基苯（２５６％）、苯甲酸（１８７％）、二苯酮（１４４％）、９－芴酮（８２％）、９－苯基芴（４９％）、联苯（３６％）、二苯甲烷（２３％）、３－甲酰苯基联苯（２１％）、二苯基乙二酮（１９％）、４－甲酰苯基联苯（１８％）、芴（１７％）、ｍ－二苯甲酰基苯（１１％）和ｐ－二苯甲酰基苯（０２％）等５５种化合物。讨论了苯甲酸盐的热分解反应机理。     

Solute-solvent interactions in water-tert-butyl alcohol mixtures. VI. Enthalpies of solution for halo-para-substituted benzoates

Enthalpies of solution of sodium benzoate, potassium benzoate, and potassium halo-substituted benzoates are reported at 298.15°K in water and in nine water-tert-butyl alchol mixtures. Transfer enthalpies from water to the mixed solvent go through a maximum for about 0.055 mole fraction of alcohol. Additivity of ionic contributions in the enthalpies of transfer is verified. Substituent effects on the transfer enthalpies of benzoates are discussed in terms of size of the solutes and cohesion of the solvent mixtures. For Part V, see ref. 1.     

Binary and Ternary Complexes Between Lauryl Hexaoxyethylene, Benzoate and Cyclodextrin. Part II. β-CD

The characterization of binary and ternary complexes of benzoate, lauryl hexaoxyethylene (C₁₂E₆) and -CD is presented. The complexation equilibrium was characterized by UV-Vis spectrophotometry, titration microcalorimetry, capillary electrophoresis, and 2D ROESY ¹H-NMR. Results suggested that -CD forms one complex with C₁₂E₆in the stoichiometric ratio of -CD : C₁₂E₆1.5 : 1, with a stability constant 1.3 × 10⁵ M^-1.5. The 2-D ROESY ¹H-NMR spectrum indicated that C₁₂E₆is included inside the -CD cavity. The primary binding site of C₁₂E₆ is on the lauryl subunit of this molecule. Analogous to a previously reported study of -CD, the combination of -CD and C₁₂E₆precipitated from the solution. Addition of benzoate seemed to dissolve the precipitate and nearly doubled the apparent stability constant of the complex. Results from the various techniques supported formation of ternary complexes between -CD, C₁₂E₆, and benzoate.     

Spectrophotometric resolution of ternary mixtures of pseudoephedrine hydrochloride, dextromethorphan hydrobromide, and sodium benzoate in syrups using wavelength selection by net analyte signals calculated with hybrid linear analysis

Hybrid linear analysis (HLA), as a recent factor-based multivariate calibration technique, was applied for the spectrophotometric determination of ternary mixtures of pseudoephedrine hydrochloride (PSU), dextromethorphan hydrobromide (DXT), and sodium benzoate (BNZ). The utilized HLA was assisted by a wavelength selection procedure which was based on the calculation of the net analyte signal (NAS) regression plot in any considered wavelengths window for each test sample, in addition to a moving window strategy for searching the region with maximum linearity of NAS regression plot (minimum error indicator (EI)). HLA was applied because it was simpler to adapt to the NAS regression plot methodology, and also used less factors than partial least squares (PLS). An orthogonal array design was applied for formation of calibration and prediction sets in the concentration ranges 0-7500 μmol L⁻¹ for PSU, 0-300 μmol L⁻¹ for DXT, and 0-1400 μmol L⁻¹ for BNZ. The method had the ability to select wavelength regions that minimize the effect of non-linearity of the spectral data, in addition to that of non-modeled interferences. The application of the selected wavelength regions improved the obtained relative standard error of predictions for PSU, DXT, and BNZ, respectively, from 5.24, 8.67, and 5.48% to 2.19, 5.21, and 3.62% (using lower number of factors). To check the ability of the proposed method in selection of linear regions of spectra, a test for detecting non-linear regions of spectral data in multivariate spectroscopic assays was also described. Additives in the commercial syrup samples did not interfere with their determinations. The method was successfully applied for the determination of pseudoephedrine HCl, dextromethorphan HBr, and sodium benzoate in cough suppressant syrup samples.     

气相-质谱联用分析冠心苏合丸中的挥发性组分

 采用气相 质谱联用对冠心苏合丸及药材中的挥发性成分进行了分析。采用选择离子监测法 ,以水杨酸甲酯为内标 ,对冠心苏合丸中的两个指标成分冰片和苯甲酸苄酯进行了定量测定。冰片和苯甲酸苄酯的平均加标回收率分别为 91 7%和 89 7% ,RSD分别为 5 6 %和 2 3%。     

A new route for the functionalisation of wood through transesterification reactions

A novel transesterification reaction between acetylated maritime pine sapwood (Pinus pinaster Soland) and methyl benzoate (MB), in the presence of dibutyltin oxide (DBTO) as a catalyst, was performed. Reaction was confirmed by Fourier-transform infrared spectroscopy (FTIR) and ¹³C nuclear magnetic resonance cross-polarisation with magic-angle spinning (NMR CP MAS) analysis: signals corresponding to benzoylated wood were identified and, when transesterification was performed with ethyl trimethylsilylacetate (ETMSA), characteristic trimethylsilyl groups were detected. The acetyl/benzoyl exchange rate was found to increase with increasing amount of DBTO, temperature and reaction time and a concurrent deterioration of the woody material was evidenced.     

无水氯化亚锡催化合成苯甲酸乙酯

以无水氯化亚锡为催化剂催化合成了苯甲酸乙酯．实验结果表明，采用氯化亚锡催化，催化剂易得，酯的收率较高，操作简便，腐蚀污染小，是苯甲酸和乙醇酯化较好的催化剂．     

用气相色谱法测定液状食品中四种对羟基苯甲酸酯类防腐剂

用毛细管气相色谱法实现了液状食品中4种防腐剂(对羟基苯甲酸甲酯、对羟基苯甲酸乙酯、对羟基苯甲酸丙酯、对羟基苯甲酸丁酯)的分离测定，各组分回收率为91．15～107．7％，检出限为0．5μg／mL，线性范围为0．2μg／mL～80μg／mL．线性相关系数大于0．999。