反渗透系统的设计思路探讨

反渗透作为一种重要的水处理技术,越来越广泛地应用到各种领域,其处理水源也变得复杂多样化,因此要求在反渗透系统和反渗透预处理设计时予以高度关注。本文主要讨论针对不同水源时反渗透系统的设计思路。     

反渗透法制纯净水的原理及工艺流程

简述了反渗透法制取纯净水的工艺流程，重点对预处理部分和反渗透除盐部分所用设备情况及其工作原理进行了分析和介绍。     

Some results from 50 years' research on surface forces

A review is presented about research on surface forces and surface interactions conducted over the past half-century, with some emphasis on the pioneering contributions of the Department of Surface Phenomena at the Institute of Physical Chemistry of the USSR Academy of Sciences.     

Effect of solution chemistry on the surface charge of polymeric reverse osmosis and nanofiltration membranes

A streaming potential analyzer has been used to investigate the effect of solution chemistry on the surface charge of four commercial reverse osmosis and nanofiltration membranes. Zeta potentials of these membranes were analyzed for aqueous solutions of various chemical compositions over a pH range of 2 to 9. In the presence of an indifferent electrolyte (NaCl), the isoelectric points of these membranes range from 3.0 to 5.2. The curves of zeta potential versus solution pH for all membranes display a shape characteristic of amphoteric surfaces with acidic and basic functional groups. Results with salts containing divalent ions (CaCl₂, Na₂SO₄, and MgSO₄) indicate that divalent cations more readily adsorb to the membrane surface than divalent anions, especially in the higher pH range. Three sources of humic acid, Suwannee River humic acid, peat humic acid, and Aldrich humic acid, were used to investigate the effect of dissolved natural organic matter on membrane surface charge. Other solution chemistries involved in this investigation include an anionic surfactant (sodium dodecyl sulfate) and a cationic surfactant (dodecyltrimethylammonium bromide). Results show that humic substances and surfactants readily adsorb to the membrane surface and markedly influence the membrane surface charge.     

Synthesis and characterization of poly(amide sulfonamide)s (PASAs)

New diamino monomers IIa – IIg were synthesized in a two-step reaction sequence starting from p-acetamidobenzenesulfonyl chloride. Solution polymerization of these monomers in DMAC with terephthaloyl or isophthaloyl chloride resulted in the formation of a series of 14 poly(amide sulfonamide)s (PASAs) in excellent yield (> 95%). The polymers have in-trinsic viscosities of 0.32–1.11 dL g^?1. Except for polymers IIIa ? p and IIId - p , all other PASAs were readily soluble in aprotic polar solvents including DMAC, DMF, and DMSO. Thermogravimetric analyses of the polymers showed moderate thermal stability with 10% weight loss being recorded in the range of 325–408°C. In addition, these polymers exhibit moderate chemical stabilities toward alkali, acidic, and chromic acid solution. © 1995 John Wiley & Sons, Inc.     

等离子体聚合及其聚合物的应用

本文着重综述了烃,含氮、氧的有机化合物,碳氟化合物以及有机硅化合物的等离子体聚合。同时还系统地介绍了等离子体聚合物在制备反渗透膜、分离膜、材料表面的涂层等方面的国内外的最新研究成果。     

羟丙基醋酸纤维素的合成及其膜的反渗透性

研究了羟丙基纤维素和羟丙基醋酸纤维素的合成。制备羟丙基纤维素的较佳反应温度为40℃左右和2小时或稍长,羟丙基含量随环氧丙烷浓度的增加而增加。在制备羟丙基醋酸纤维素时,随羟丙基含量的增加,所需醋化和水解的时间减少。以甘油-正丙醇或磷酸为添加剂,丙酮为溶剂经30～60s蒸发后制得了羟丙基醋酸纤维素反渗透膜。后者在20kg/cm~2下对氯化钠脱盐率可达95～98％,水通量1.0～2.1mL/cm~2·h,其使用温度上限比醋酸纤维素反渗透膜提高10℃以上。     

壳聚糖在膜分离上的应用

膜分离是工业上能耗最低的一种分离过程，选择合适的膜材料和制膜工艺，一直是分离膜研究的核心．随着全球新材料的开发朝着环境友好材料方向的发展，壳聚糖作为一种无毒、无污染、可生物降解的天然高分子，受到了国内外学者的广泛关注．文章综述了壳聚糖在反渗透膜、超滤膜、渗透-蒸发膜和气体分离膜上的应用及其研究进展．     

反渗透过程中的浓差极化的研究

文章以海水经反渗透脱盐转化为净化水为例，讨论了影响反渗透过程中浓差极化的因素及降低浓差极化程度的途径。     

Mixed Polymer‐Coated Magnetic Nanoparticles as Forward Osmosis Draw Agents of Tuned Hydrophilicity

We recently reported a polymer‐coated magnetic nanoparticle (MNP) draw agent for the forward osmosis (FO) water desalination process. The water flux was found to increase when the polymer poly(sodium acrylate) (PSA) was anchored to the MNP surface as compared to the polymer (or polyelectrolyte solution) alone, due to the polymer chains being stretched out and most of the hydrophilic groups on the polymer contributing to water flux. We herein report the use of a secondary polymer poly(N‐isopropylacrylamide) PNIPAM to manipulate the PSA polymer conformation and influence inter‐ and intrachain interactions to enhance the efficiency of the FO draw agent. These PSA–PNIPAM‐coated MNPs generated a much higher water flux of ～11.66 LMH when compared to the 100 % PSA‐coated MNPs featuring a value of ～5.32 LMH under identical FO conditions. The osmotic pressure and water flux driven by the mixed polymer‐coated MNPs were found to be a strong function of the net polymer coverage on MNPs, that is, net available hydrophilic groups. Our new draw agent demonstrates potential for use in the water industry due to its improved efficiency and cost effectiveness as it uses only ～0.062 % (w/v) of the draw agent solution.