Solid Phase Extraction and Simultaneous Spectrophotometric Determination of Trace Amounts of Copper and Iron Using Mixture of Ligands

 A novel sensitive and simple method for rapid and selective extraction, preconcentration and determination of iron (as its bathophenanthroline complex) and copper (as its neocuproine complex) using octadecyl silica cartridges and dual wavelength spectrophotometry is presented. The dual wavelength method (533 nm for the iron-bathophenanthroline and 454 nm for the copper-neocuproine as the analytical wavelength) is used to eliminate spectral interferences. Extraction efficiency and the influence of flow rates of sample solution and eluent, pH, amount of neocuproine, bathophenanthroline and hydroxylamine hydrochloride, type and least amount of eluent for elution of iron and copper complexes from cartridge, break-through volume and limit of detection are evaluated. The effects of various cationic and anionic interferences on percent recovery of iron and copper are also studied. Extraction efficiencies >95% are obtained by elution of cartridges with minimal amount of organic solvent. Iron and copper were determined in the range of 3–100 ng mL⁻¹. The limits of detection are 0.98 and 1.13 ng mL⁻¹ for iron and copper, respectively. The proposed method is applied successfully to the determination of both analytes in river, tap and well water samples. Author for correspondence. E-mail: yyamini@modares.ac.ir Received September 18, 2002; accepted December 12, 2002 Published online May 5, 2003     

配位吸附波测定粮食中的痕量钼

在0.1 mol/L HAc-NaAc(pH=3.7)介质中,Mo(Ⅵ)-NCP配合物在2.5次微分极谱图上产生良好的吸附还原波。其峰电位为-0.54 V,峰电流与Mo(Ⅵ)浓度在8.0×10-8～6.0×10-6mol/L范围内呈良好的线性关系,检测限为5.0×10～8mol/L。应用该法测定了豆类样品中的微量钼,获得了满意的结果。研究了配合物的组成,极谱波的性质及其机理。     

离子对萃取原子吸收光谱法间接测定微量硫氰酸根和碘

研究了NCP-Cu(I)·SCN~-离子对的形成、萃取和测定条件;探讨了有机溶剂对测定灵敏度的影响.方法用于电镀厂排放水中微量硫氰酸根的测定,并取得满意的结果.当I~-与SCN~-共存时,通过改变试剂用量,可以对二者选择性地连续测定.     

Spectrophotometric total protein assay with copper(II)-neocuproine reagent in alkaline medium

Total protein assay was made using copper(II)–neocuproine (Nc) reagent in alkaline medium (with the help of a hydroxide-carbonate-tartarate solution) after 30 min incubation at 40 °C. The absorbance of the reduction product, Cu(I)–Nc complex, was recorded at 450 nm against a reagent blank. The absorptivity of the developed method for bovine serum albumin (BSA) was 0.023 l mg⁻¹ cm⁻¹, greater than that of Lowry assay (0.0098), and much greater than that of Cu(II)–bicinchoninic acid (BCA) assay (0.00077). The linear range of the developed method (8–100 mg l⁻¹ BSA) was as wide as that of Lowry, and much wider than that of BCA (200–1000 mg l⁻¹ BSA) assay. The sensitivity of the method was greater than those of Cu-based assays (biuret, Lowry, and BCA) with a LOD of 1 mg l⁻¹ BSA. The within-run and between-run precisions as RSD were 0.73 and 1.01%, respectively. The selectivity of the proposed method for protein was much higher than those of dye-binding and Lowry assays: Most common interferents to other protein assays such as tris, ethanolamine, deoxycholate, CsCl, citrate, and triton X-100 were tolerated at 100-fold concentrations in the analysis of 10 mg l⁻¹ BSA, while the tolerance limits for other interferents, e.g., (NH₄)₂SO₄ and acetylsalicylic acid (50-fold), SDS (25-fold), and glycerol (20-fold) were at acceptable levels. The redox reaction of Cu(II)–Nc as an outer-sphere electron transfer agent with the peptide bond and with four amino acid residues (cystine, cysteine, tryptophan, and tyrosine) was kinetically more favourable than that of Cu(II) alone in the biuret assay. Since the reduction product of Cu(II) with protein, i.e., Cu(I), was coordinatively saturated with Nc in the stable Cu(Nc)₂⁺ chelate, re-oxidation of the formed Cu(I) with Fenton-like reactions was not possible, thereby preventing a loss of chromophore. After conventional protein extraction, precipitation, and redissolution procedures, the protein contents of the minced meat (veal and turkey), sardine, various milk products, and egg white were analyzed with the proposed and Lowry methods, and the results correlated appreciably (r = 0.98). The method was validated by Kjeldahl analyses of the tested samples; the data sets of complex samples assayed by Cu(II)–Nc and Lowry correlated to the findings of Kjeldahl yielded correlation coefficients r = 0.96 and 0.97, respectively, with slopes being close to 1. Interferences of glucose and thiol compounds at relatively low concentrations could be compensated for by selecting a lower alkaline pH (i.e., pH 10) at a cost of slightly reduced sensitivity and adding an identical amount of interferent to the reagent blank, respectively, since the absorbances due to BSA and interferent were additive. Thus a novel spectrophotometric method for total protein assay using a stable reagent and chromophore, which was simple, rapid, sensitive, flexible, and relatively selective, was developed, and applied to a variety of food products.     

Determination of N-Acetyl-l-cysteine Ethyl Ester (NACET) by Flow Injection Analysis and Spectrophotometric Detection Using Different Thiol-Sensitive Ligands

A new flow injection spectrophotometric method for the determination of N-acetyl-l-cysteine ethyl ester (NACET) was developed and validated. The method is based on the reduction of Cu(II)-ligand complexes to chromophoric Cu(I)-ligand complexes with the analyte. The studied ligands were neocuproine (NCN), bicinchoninic acid (BCA) and bathocuproine disulfonic acid (BCS). The absorbance of the Cu(I)-ligand complex was measured at 458, 562 and 483 nm for the reactions of NACET with NCN, BCA and BCS, respectively. The method was validated in terms of linear dynamic range, limit of detection and quantitation, accuracy, selectivity, and precision. Experimental conditions were optimized by a univariate method, yielding linear calibration curves in a concentration range from 2.0 × 10⁻⁶ mol L⁻¹ to 2.0 × 10⁻⁴ mol L⁻¹ using NCN; 2.0 × 10⁻⁶ mol L⁻¹ to 1.0 × 10⁻⁴ mol L⁻¹ using BCA and 6.0 × 10⁻⁷ mol L⁻¹ to 1.2 × 10⁻⁴ mol L⁻¹ using BCS. The achieved analytical frequency was 90 h⁻¹ for all three ligands. The method was successfully employed for NACET determination in pharmaceutical preparations, indicating that this FIA method fulfilled all the essential demands for the determination of NACET in quality control laboratories, as it combined low instrument and reagent costs with a high sampling rate.     

Site-Selective Artificial Ribonucleases: Renaissance of Oligonucleotide Conjugates for Irreversible Cleavage of RNA Sequences

RNA-targeting therapeutics require highly efficient sequence-specific devices capable of RNA irreversible degradation in vivo. The most developed methods of sequence-specific RNA cleavage, such as siRNA or antisense oligonucleotides (ASO), are currently based on recruitment of either intracellular multi-protein complexes or enzymes, leaving alternative approaches (e.g., ribozymes and DNAzymes) far behind. Recently, site-selective artificial ribonucleases combining the oligonucleotide recognition motifs (or their structural analogues) and catalytically active groups in a single molecular scaffold have been proven to be a great competitor to siRNA and ASO. Using the most efficient catalytic groups, utilising both metal ion-dependent (Cu(II)-2,9-dimethylphenanthroline) and metal ion-free (Tris(2-aminobenzimidazole)) on the one hand and PNA as an RNA recognising oligonucleotide on the other, allowed site-selective artificial RNases to be created with half-lives of 0.5–1 h. Artificial RNases based on the catalytic peptide [(ArgLeu)₂Gly]₂ were able to take progress a step further by demonstrating an ability to cleave miRNA-21 in tumour cells and provide a significant reduction of tumour growth in mice.     

Spectroscopic Study of the Interaction of Mitoxantrone with Copper(I), Copper(II), and Neocuproine

Both reductive and oxidatlve mode of metabolism have been hypothesized for the antitumor agent mitoxantrone. This work aims to better understand the redox properties of mitoxantrone in the presence of the physiological redox couple, copper(I)/copper(II), by means of polarograpy and spectrophotometry. The first quasi-reversible one-electron reduction of mitoxantrone to the semiquinone and the second reduction to the hydroquinone have been shown to be considerably affected by copper. Visible spectra of mitoxantrone-copper mixtures in nitrogen and oxygen purged solutions taken in a one-week period exhibit varying degrees of complexation and oxido-reduction.

When copper(II), neocuprolne and mitoxantrone are mixed in a certain ratio in pH 7. 4 phosphate buffer solution, two new peaks at 584 and 632 nm emerge in the spectra indicating a ternary charge transfer complex. The complex atoichiometry was established as Cu(IT): neocuproine: tritoxan-trone = 2:4:1 by Job's method of continuous variations. The ternary complex is sensitive to the relative concentrations of mitoxantrone and copper(II), an excess of the latter giving rise to complete red ox products. This complex may be important in modeling the drug's oxidative mode of ant tumor action.     

The effect of Fe(II) ions on the 1,10-phenanthroline and neocuproine intercalates of γ-zirconium phosphate

1,10-Phenanthroline (phen), 2,9-dimethyl-1,10-phenanthroline (neocuproine), and 4,7-dimethyl-1,10-phenanthroline have been intercalated between layers of -zirconium phosphate (-ZrP). The observed interlayer distances are not a simple function of the size of guest molecules. Despite the fact that -ZrP takes up very few Fe²⁺ ions, the phen and neocuproine intercalates do take up some Fe²⁺ ions without further changes in the interlayer distances. The chemical environments around Fe²⁺ ions between layers of the intercalates were investigated by⁵⁷Fe Mössbauer spectroscopy. A fairly large fraction of the Fe²⁺ ions was found to be in a high-spin state. The low-spin [Fe(phen)₃]²⁺ ions are also ion exchanged on -ZrP, with the expansion of the interlayer up to 19.9 Å.     

异烟肼的Cu2+-新亚铜试剂分光光度法测定

异烟肼还原Cu^2＋为Cu^＋,以新亚铜试剂为显色剂,Cu^＋与新亚铜试剂生成黄色络合物,借以分光光度测定.研究结果表明：在优化的实验条件下得到测定异烟肼的线性范围为0.1～1.8μg/mL,回归方程为A=0.174X＋0.012,相关系数r=0.999 0.检出限为0.02 μg/mL,对1 μg/mL异烟肼进行11次平行测定,其相对标准偏差（RSD）为0.5%.平均回收率为99.5%.