MORPHOLOGY OF BLACK CARBON AEROSOLS AND UBIQUITY OF 50-NANOMETER BLACK CARBON AEROSOLS IN THE ATMOSPHERE

Different-sized aerosols were collected by an Andersen air sampler to observe the detailed morphology of the black carbon （BC） aerosols which were separated chemically from the other accompanying aerosols, using a Scanning Electron Microscope equipped with an Energy Dispersive X-ray Spectrometer （SEM-EDX）. The results indicate that most BC aerosols are spherical particles of about 50 nm in diameter and with a homogeneous surface. Results also show that these particles aggregate with other aerosols or with themselves to form larger agglomerates in the micrometer range. The shape of these 50-nm BC spherical particles was found to be very similar to that of BC particles released from petroleum-powered vehicular internal combustion engines. These spherical BC particles were shown to be different from the previously reported fullerenes found using Matrix-Assisted Laser Desorption/Ionization Time-Of-Flight Mass Spectrometry （MALDI-TOF-MS）.     

纳米累托石-TiO2光催化剂的制备及表征

以TiCl4和累托石为主要原料，制备出纳米累托石-TiO2粉末，并用X-衍射、透射电镜等对其进行表征．结果表明：纳米累托石-TiO2粉末平均直径为17．5nm当焙烧温度从500℃升至800℃时，累托石-TiO2粉末的比表面积从65．7m^2／g下降至3．3m^2／g，单位质量吸附剂的孔体积从0．1430cm。／u降到0．0213cm^3／g；当焙烧温度从300℃上升至500℃时，孔径变化不大，属中孔范围；当焙烧温度升至800℃时，一些孔道出现坍塌，不利于纳米累托石-TiO2粉末的光催化活性．     

纳米CaCO3/丙烯酸树脂浆液的流变性

制备了纳米CaCO3/丙烯酸树脂浆液,当浆液(48 gZ-26、50g纳米CaCO3和83.3 g二甲苯)中分散剂添加量为3 g时,Casson屈服应力τc值最小,浆液的稳定性最好,与工艺条件优化时所得到的一致.纳米CaCO3/丙烯酸树脂浆液的流变性研究表明:该体系的流动特性符合Casson模型,其屈服应力τC较小,稳定性较好;浆液的黏度随剪切速率增加而显著下降,具有明显的剪切稀化特性,且随着纳米CaCO3含量增加,其剪切稀化趋势增强;在所考察的低剪切速率范围内,纳米CaCO3浆液具有明显的触变性,且纳米CaCO3含量越大触变性越大.图10,表7,参8.     

Preparation of nanometer MgO by sol-gel auto-combustion

Nanometer MgO was prepared via a sol-gel auto-combustion technique using magnesium nitrate as raw material and citric acid as chelating agent. IR spectra of the dried gel were used to investigate the structure of the precursors. By studying the different TG curves of magnesium citrate gel prepared by different methods, we found that a combustion process occurred and the nitrate ions acted as an oxidant in the combustion process. TEM photographs of synthesized powders from the sol-gel auto-combustion showed that the crystallites were uniform in size. In addition, the XRD pattern of this sample showed that the particle size was 8.9 nm. The BET curves, in turn, showed that the specific surface of the sample was 26.34 m²/g. The mechanism of the frothing process in restraining agglomeration is discussed. __________ Translated from Journal of East China Normal University (Natural Science), 2007, (2): 52–57 [译自: 华东师范大学学报(自然科学版)]     

以钛氧有机物为前驱物制备具有高光催化活性的纳米二氧化钛晶体

 纳米二氧化钛的制备方法及前驱物的差别影响其光催化活性．将20ml钛酸丁酯及30ml乙酐在密闭容器中与50ml环己烷混合，在70～85℃反应30min，生成微细的非晶钛氧有机物；经FT－IR和TGA分析，该物质被确认为计量式是TiOOOCCH3）2和TiO（OC4H9）（OOCCH3）的混合体．该钛氧有机物前驱物经焙烧后得到具有高光催化活性的纳米二氧化钛晶体．表征结果表明，钛氧有机物在焙烧过程中，其表面的吸附物及键合有机基团在400℃以前发生脱附和氧化分解；在389～405℃间形成锐钛矿型晶体，在600℃出现金红石晶型；600℃焙烧3h所得样品的比表面积为86m2／g，其二次粒子呈200～300nm条形体，孔隙大于20nm；单分散粒子为球形单晶，粒径为22nm；表面物理吸附水量为1．21％，加热至800℃时失重1．48％，粉体稳定纯净．光催化实验结果表明，以钛氧有机物为前驱物制备的纳米二氧化钛晶体具有高的光催化活性，光降解丁基罗丹明溶液的反应速率常数约为溶胶－凝胶法制备的催化剂样品的4倍．表面氧空缺和一定量的表面羟基可能是粉体具有高光催化活性的重要因素．     

离子交换-双氧水氧化法制备纳米CeO2晶体

以99.995% Ce(NO₃)₃和强碱性阴离子交换树脂为原料，采用离子交换-双氧水氧化法合成制备出纳米CeO₂晶体。并就离子交换反应中的Ce³⁺浓度、树脂加入速度和离子交换温度及H₂O₂加入速度等条件对CeO₂粒径的影响进行了探讨，得出了离子交换-双氧水氧化法制备纳米CeO₂晶体的最佳工艺条件。FTIR、TEM分析表明，离子交换法无需对合成的Ce(OH)₃溶胶进行洗涤即可去除NO₃^-、CO₃^2-等阴离子杂质，并用H₂O₂将该溶胶氧化，经真空干燥可制得粒径分布均匀，平均晶粒尺寸约3 nm，高纯度的CeO₂粉体。     

纳米级二氧化硅玻璃粉的制备及其特性

采用正硅酸乙脂为前驱物,用溶胶－凝胶法制备纳米级二氧化硅（ＳｉＯ２）粉,分别用Ｘ射线衍射仪、透射电子显微镜、红外光谱仪、差热扫描量热分析仪和白度测试仪对凝胶粉随温度变化的特征进行了分析测试．结果表明干凝胶在１２００℃热处理１ｈ仍是无定型的ＳｉＯ２粉,其粒度大小为４０ｎｍ左右,白度为９２．１％．     

Preparation and Characterization of Nanotitanium Dioxide Coating Film Doped with Fe^3＋ Ions on Porous Ceramic

The nanotitanium dioxide （TiO2） photocatalytic and porous ceramic filtering technique is one of the advanced methods to effectively treat organic wastewater. The TiO2 sol doped with Fe^3＋ ions was prepared by sol-gel processing. The influences of the process conditions of coating nanophotocatalytic material- Fe^3＋-TiO2 film on the surface of porous ceramic filter by dipping-lift method on the performance of porous ceramic filter were studied. The porous ceramic filters have two functions at the same time, filtration and photocatalytic degradation. The results of this study showed that the pH and viscosity of the sol, amount of Fe^3＋ ions doped as well as the coating times greatly affect the quality of coating film, the performance parameters and the photocatalytic activity of the porous ceramic filter. When the pH of the sol is 3-4, the viscosity is about 6 mPa.S, the amount of doped Fe^3＋ ions is about 2.0 g/L, the porous ceramic filter has been shown to have the best filtering performance and photocatalytic activity. In this condition, the porosity of porous ceramic is about 42.5%, the pore diameter is 8-10μm. The degradation of methyl-orange is 74.76% under lighting for 120 rain.     

制备纳米氧化锌的新方法

以草酸和醋酸锌为原料，用室温固相化学反应首先制备前驱物二水合草酸锌，后者在微波场辐射分解得到产物纳米氧化锌。用XRD，TEM和IR等技术对产物的组成，大小及形貌进行了表征。结果表明：产物纳米氧化锌为粒度分布均匀的球形六角晶系结构，平均粒径约为8nm。     

电化学合成镍配合物的研究

采用金属镍为“牺牲”阳极，首次在无隔膜电解槽中，电化学溶解金属镍一步 制备了纳米NiO前驱体Ni(Oet)2,Ni(Obu)2,Ni(Oet)2(acac)2，Ni(Obu)2(acac)2 [acac为乙酰丙酮基].产物通过红外光谱（FT-IR）、拉曼光谱（Raman spectrum） 进行表征。同时讨论了影响电合成镍醇盐及其配合物的关键因素。实验表明，防止 阳极钝化，温度控制在30-40℃，采用有机胺溴化物为导电盐，可以提高电合成效 率。