空调冷凝器、蒸发器残留水分量检测系统

本文介绍了空调冷凝器、蒸发器残留水分量检测系统的组成和工作原理、技术指标、系统的工艺过程，最后说明了系统的考核和应用情况。     

Effects of Moisture and Stresses on the Structure and Properties of Polyester Resin

The results of a complex study of structural changes in a cured Norpol 440 polyester resin under the action of damp environment and mechanical loading are presented. A considerable effect of absorbed moisture on the structure and some characteristics of the material is revealed by using thermophysical methods and X-ray diffractometry. The joint effect of moisture and mechanical stress is estimated by investigating the creep in stationary and nonstationary moisture conditions. The anisotropy of the material structure formed during creep is evaluated from the results of dilatometric measurements. It is found that the degree of anisotropy of the material after creep accompanied by moisture sorption is higher than that after creep in the conditions of moisture equilibrium with atmosphere. It is established that the aftercure and relaxation of the residual creep deformation come to an end at heating to 80-85°C. At a further rise in temperature and repeated heating, changes in the material structure are not observed.     

人工气候条件下的人体着装试验的研究

本文通过物理试验方法对棉、毛、丝、棉麻及毛涤五种面料进行性能测试,得出其风格数值、透湿阻抗.为了反映面料对人的生理、心理的影响,有必要在人工气候条件下进行人体模拟着装试验,得出面料的人体舒适感觉值。借助多元线性回归方法,通过物理测试与人体试验的对照分析,发现它们之间具有良好的一致性。     

Influence of moisture on the viscoelastic relaxations in long aliphatic chain contained semiaromatic polyamide, (PA9‐T) fiber

The effect of moisture on the mechanical relaxation processes of semiaromatic semicrystalline polyamides synthesized by a long‐chain aliphatic diamine and terephthalic acid was investigated by dynamic viscoelastic analysis (DVA) and differential scanning calorimetry (DSC). Moreover, the implication of moisture with the amorphous and crystalline domains was also examined by temperature‐dependent wide‐angle X‐ray diffraction and Fourier transform infrared spectra. The characteristics of the relaxations such as α, β, γ, and the pronounced peak shoulder appeared at 25–100 °C in DVA tan δ curves were found to be strongly susceptible to the presence of moisture. With moisture evaporation, the peak shoulder of 25–100 °C and the β‐relaxation disappeared. The former is anticipated to originate from to the side group motion of hydrogen‐bonded water, whereas the later one is from the motions of the amide–water complex units. With the disappearance of the β‐relaxation, the γ‐relaxation appeared simultaneously in much lower temperatures and ultimately coupled with the δ‐relaxation. The γ‐relaxation is attributed to be associated with the molecular motion of the amide group and δ‐relaxation with for the motion of the methylene units. The existence of two types of water was identified in the polymer, namely, tightly bound and loosely bound. The tightly bound water is believed to be directly connected by hydrogen bonding with the strong polar groups and the loosely bound water weakly links with those connected water making hydrogen bridges. The moisture acts as a plasticizer in the polymer matrix, which causes quite a large depression in its glass transition temperature (T_g). WAXD and FTIR studies corroborated the existence of water solely in amorphous regions, i.e., no rapport of water with the crystalline parts. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 2878–2891, 2003     

经编针织运动服装的织物性能研究

从人体穿着舒适性能考虑,织物的热湿舒适性越来越成为人们重视的服用性能.本文针对功能性的针织运动服的原料选用和织物组织结构,分析其导湿性.     

Computation of moisture and temperature profiles in soil—The coupled model

The coupled model has been developed in this study for moisture transport and beat exchange in soil. The model is driven by atmospheric conditions measured in a field. The concept that soil has a surface resistance to evaporation is introduced in order to relate the evaporation from surface with the vapour flux in air. With the use of this concept, the simulation results agree quite well with the measured data.     

INTROMISSION OF WATER-REPELLENT AND HYDROSCOPIC PROPERTIES SIMULTANEOUSLY TO PP BY PLASMA DISCHARGE METHOD

Plasma-induced surface graft copolymerization of acrylic acid on polypropylene non-woven fabric (PP-g-AA) and polypropylene membrane were reported. The extents of grafting were controlled by the plasma and polymerization condition. Hexadecyltrimethyl ammonium bromide was then coupled with the carboxyl group of PP-g-AA to obtain a polyion complex (PIC). At last, CF4 plasma was used to give PICs hydrophobic property. The moisture regain and water-repellency of the processed PICs was investigated. The surfaces were characterized using ATR FT-IR and XPS. The result indicates that the products have very high ability to adsorb moisture, even better than cotton fiber. At the same time, the products show excellent hydrophobic property, which can‘t be wetted by those reagents whose surface tensions were higher than 327mN/m.     

2-羟丙基三甲基氯化铵壳聚糖的制备及其性能研究

以脱乙酰度为95.37%的壳聚糖(CTS)为原料,异丙醇为溶剂,2,3-环氧丙基三甲基氯化铵为改性剂,于80℃反应12 h合成了水溶性季铵盐2-羟丙基三甲基氯化铵壳聚糖(HACC)。HACC的吸水保水性是CTS的2倍～3倍,加入化妆品中培养2周后菌落总数少于100 CFU.g-1。     

Determining moisture absorption/desorption properties of commercial membranes by thermogravimetry (TG)

A series of different commercial membranes were characterized by their moisture absorption and desorption properties under controlled humidity and temperature conditions. This work was made possible by combining the features of a constant humidity conditioning chamber with those of a thermogravimetric (TG) apparatus. These two modules were interconnected by tubing, rotameters, an atmosphere-recycling microbellows pump and switching valves. Under programmed heating and isothermal conditions reproducible data were obtained in terms of weight-gain or weight-lossvs. time and pore size. Evaluation of the resulting TG curves allowed us to report reasonable differences in the materials, some of which had been previously surface-modified by the manufacturer.