螺栓连接大变形梁非线性振动特性的实验研究

柔性机械臂、大型可展开天线等机械结构的动作精度受运动过程中大变形几何非线性和连接处接触非线性的影响十分显著。以含螺栓连接结构的大变形梁作为研究对象，针对动力学建模和振动特性开展了实验研究，通过数值计算验证了实验发现的非线性振动特性。搭建了含螺栓连接柔性大变形梁的实验台架，开展了敲击和正弦激振的实验测试。实验结果表明，螺栓连接的柔性梁较连续梁的（无螺栓连接）模态频率降低，阻尼增加，反映出随着激励能量增大，模态频率降低的非线性模态特征。改变螺栓连接位置会显著影响结构的模态频率，其变化规律可由求解线性矩阵特征值定性反映。     

轧制道次间插入冷却对特厚钢板组织与性能的影响

使用实验轧机旁冷却装置配合轧机进行轧制实验，研究轧制道次间不同冷却工艺对特厚钢板组织和性能的影响规律.研究结果表明:采用道次间冷却工艺可以在全厚度方向获得组织细化及强韧性提高效果，采用强冷道次间冷却实验钢1/4处晶粒尺寸可细化至10μm，强度为376MPa，-40℃冲击功为169J;心部晶粒尺寸可细化至15μm，强度为360MPa，-40℃冲击功为123J.本工艺可形成470μm厚表层细晶层，晶粒尺寸可细化至5μm;粗轧道次间插入冷却工艺轧制钢板强度和冲击韧性优于中间坯冷却工艺;随冷却强度增加，钢板内部组织明显细化且强度大幅提高.     

Maximal Subrings and Covering Numbers of Finite Semisimple Rings

We classify the maximal subrings of the ring of n×n matrices over a finite field, and show that these subrings may be divided into three types. We also describe all of the maximal subrings of a finite semisimple ring, and categorize them into two classes. As an application of these results, we calculate the covering number of a finite semisimple ring.     

Formation of low-temperature deformation-induced segregations of nickel in Fe–Ni-based austenitic alloys

ABSTRACT

The authors present the results of an investigation in Fe–Ni-Cr austenitic alloys of the low-temperature deformation-induced segregations of nickel that form in the micro regions being (i) located close to grain- and subgrain boundaries and (ii) characteristic of the concentration and magnetic inhomogeneities indicated by the appearance of a dark diffraction contrast at the electron diffraction patterns taken from these regions typical (at the same time) of an enhanced value of Curie temperature. The observed effects were connected with the micro distortions caused by the local change of lattice parameter because of an increase in nickel concentration, as well as in the result of a magnetostriction dilatation. Using methods of the X-ray energy dispersive spectroscopy (XEDS) and atomic-probe body-section radiography (tomography – APT) has made it possible to determine the borders of those regions of austenite that were characteristic of an enhanced concentration of nickel in the fields of the localisation of a deformation-induced segregation of nickel in the vicinity of grain (subgrain) boundaries of austenitic alloys of the types Fe–13Cr–30Ni and Fe–37Ni–3Ti.     

ZnO nanowire lines and bundles: Template-deformation-guided alignment for patterned field-electron emitters

One-dimensional ZnO materials have been promising for field-emission (FE) application, but how to facially control the alignment of ZnO emitters is still a great challenge especially for patterned display application. Here, we report the fabrication of novel ZnO nanowire (NW) line and bundle arrays for patterned field-electron emitters. The effects of PS template size and heating time on the resulted ZnO nanoarrays were systematically studied. The deformation degree of PS templates was controlled and hence utilized to adjust the alignment of electrochemically deposited ZnO arrays. It was found that the length of NW lines and the density of NW bundles can effectively tuned by the PS template heating time. The optimal FE performance with turn-on electric field as low as of 4.4 V μm⁻¹ and the field-enhancement factor as high as of 1450 were achieved through decreasing the screening effect among the patterned field-electron emitters.     

网络计划最低费用日程的一种新解法

根据网络计划的特点,在求解其最低费用日程时,引入最小割的概念,从而改进了该问题的求解方法。文中给出了解决问题的算法流程,并附有算例.此法运用较简便,且易于计算机计算,自动化水平高,因而便于有关人员采用.     

Well-Posedness by Perturbations of Variational Problems

In this paper, we consider the extension of the notion of well-posedness by perturbations, introduced by Zolezzi for optimization problems, to other related variational problems like inclusion problems and fixed-point problems. Then, we study the conditions under which there is equivalence of the well-posedness in the above sense between different problems. Relations with the so-called diagonal well-posedness are also given. Finally, an application to staircase iteration methods is presented.     

Uniform bounds under increment conditions

We apply a majorizing measure theorem of Talagrand to obtain uniform bounds for sums of random variables satisfying increment conditions of the type considered in Gál-Koksma Theorems. We give some applications.

     

一类(0,1)-矩阵的最大积和式的积分表达式

给出了线和n-2的n阶（0，1）－矩阵的最大积和式的积分表达式，并证明了该积分表达式与[1]得到的组合表达式等价。     

借助Matlab遗传算法反演火山区压力源参数

首先分析了Mogi模型的经典最小二乘反演由于出现矩阵奇异或接近奇异而发散的局限性,决定采用具有全局高效搜索性和优化计算时不需要求导的遗传算法来反演火山区压力源参数。反演程序调用Matlab7.0 Release14工具箱中的选择、交叉和变异等相关程序。最后应用该程序和长白山天池火山区水准和GPS观测资料联合反演火山区压力源参数,经过比较遗传算法和阻尼最小二乘方法的反演结果,可看出2种方法结果近似,可见此方法方便快捷地实现了目标函数的最小化。