Numerical study on thermal performance of TiO2, Fe3O4 and NiCr/engine oil in an inclined wavy pip

The essential intention of the existing article is to illustrate the effect of wall properties on flow and thermal behavior, through a sinusoidal inclined wavy pipe. To succeed this phenomena we assume a sinusoidal pipe consist of wavy surface, whose walls traveling down to its borders and located at an inclined position, moreover titanium dioxide (TiO₂), ferrosoferric oxide (Fe₃O₄) and nichrome (80% Ni and 20% Cr) are considered as nano-particles and unused engine oil is assumed as a base fluid. The arising mathematical equations for thermal and flow ratio with wall slip impact are solved by mathematica. Also, evaluate graphically the thermal and flow behavior of nanofluids for multi values of solid volume fractions (η), rigidity parameter (M₁), stiffness parameter (M₂), viscous damping parameter (M₃), Grashof number (G_r), slip parameter (β) and heat generation parameter (H) also discuss the streamlines for different values of solid volume fraction.     

煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

Morphologically controlled synthesis of 1-dimensional selenium dioxide and study of its application as catalyst for diesel fuel additive

In this research work, selenium dioxide (SeO₂) nanorods have been prepared by a solvothermal method in which a strong reducing agent (NaBH₄) was used to reduce precursor salt into SeO₂ nanorods. X-ray diffraction (XRD) technique was applied to observe the crystal structure which confirmed its tetragonal geometry. Moreover, morphology and particle size were studied by scanning electron microscopy (SEM). SEM fully described the 1-dimensional morphology of SeO₂ nanorods which then arranged themselves to create a 3-dimensional flower-like structure with an average particle size of 50 nm. Also, the catalytic activity of SeO₂ nanorods as diesel-additive was studied by defining different parameters such as fire and flash points, calorific value, cloud and pour points, specific gravity, and kinematic viscosity. Subsequently, SeO₂ nanorods proved to be an excellent diesel additive due to higher total heat content and lower value of kinematic viscosity which enhances the better performance of the diesel engine.     

110kv及其以下的油浸电力变压器的优化设计

变压器的优化设计是变压器设计的核心,根据变压器自身的特征,通常采用遗传算法进行优化。本系统通过采用改进GA的父代参与竞争的最优保存遗传算法进行优化,得到了几乎必然收敛的优化效果。     

用带时序子模块的系统动力学模型预测Brent原油价格

提出在系统动力学模型中加入时序自回归AR(p)子模块，并且自动确定每个AR(p)子模块的阶数p。带时序子模块的系统动力学模型既体现了因素问的横向因果关系，又体现了每个因素的纵向关系。建立欧佩克(OPEC)石油产量、世界GDP、煤炭产量与价格、天然气、需求量、供求差额、消费系数、非欧佩克石油产量、非欧佩克供求差额，石油库存和OPEC组织的期望油价共十一个因素影响下的Brent原油价格预测模型，模型的预测结果表明：在系统动力学模型中加入时序自回归AR(p)子模块的方法是可行的、有效的，并且能提高模型的预测精度。     

重油催化装置反应系统的技术改造

为了减少炼油厂高低并列式两段再生重油催化裂化装置频繁停工 ,降低干气产率 ,提高加工能力和掺渣能力 ,兰州石化公司炼油厂对该装置进行了技术改造 ,同时多产了液态烃和柴油 .新鲜原料和回炼油改由 BWJ型高效雾化进料喷嘴注入 ,沉降器由原来的三叶快分换为全封闭直联快速分离系统 ,在原来采用急冷油作终止剂的基础上 ,新增急冷水 .通过改造 ,有效地降低了干气产率 ,减少了结焦 ,增加了轻质油收率 ,提高了装置的加工能力、掺渣能力及柴汽比 ,较好地实现了预期目标     

志丹活性白土对食用油的脱色研究

以志丹白土为原料，经酸活化所得活性白土应用于食用油的脱色，详细研究了脱色工艺条件，并与浙江等地的活性白土产品的脱色效果进行比较，结果表明：志舟活化白土具有较好的脱色性能。     

高油玉米三种遗传效应综合利用模式研究

高油玉米三个遗传效应的综合利用生产模式是未来高油玉米生产的一种重要方式，而高油玉米雄性不育化研究又是实现三利用生产模式的关键技术环节，采用不育型高油玉米杂交种X超高油玉米杂交种的生产模式，可有效地提高高油玉米的含油量。     

200MW汽轮发电机组进油问题初析

对国产200MW汽轮发电机组普遍存在的向机内进油及密封油系统运行不稳定等问题进行了较为详细的分析,指出发电机氢侧回油腔窄小,回油不畅,密封瓦及内油挡安装不良;平衡阀灵敏度低,可靠性差;压差阀发卡发涩,跟踪性能差;密封油箱补排油不畅等因素是造成上述问题的主要原因,并提出了相应的改进措施。     

A MODEL OF TROPICAL MARINE RESERVE‐FISHERY LINKAGES

ABSTRACT. The excessive and unsustainable exploitation of our marine resources has led to the promotion of marine reserves as a fisheries management tool. Marine reserves, areas in which fishing is restricted or prohibited, can offer opportunities for the recovery of exploited stock and fishery enhancement. In this paper we examine the contribution of fully protected tropical marine reserves to fishery enhancement by modeling marine reserve‐fishery linkages. The consequences of reserve establishment on the long‐run equilibrium fish biomass and fishery catch levels are evaluated. In contrast to earlier models this study highlights the roles of both adult (and juvenile) fish migration and larval dispersal between the reserve and fishing grounds by employing a spawner‐recruit model. Uniform larval dispersal, uniform larval retention and complete larval retention combined with zero, moderate and high fish migration scenarios are analyzed in turn. The numerical simulations are based on Mombasa Marine National Park, Kenya, a fully protected coral reef marine reserve comprising approximately 30% of former fishing grounds. Simulation results suggest that the establishment of a fully protected marine reserve will always lead to an increase in total fish biomass. If the fishery is moderately to heavily exploited, total fishery catch will be greater with the reserve in all scenarios of fish and larval movement. If the fishery faces low levels of exploitation, catches can be optimized without a reserve but with controlled fishing effort. With high fish migration from the reserve, catches are optimized with the reserve. The optimal area of the marine reserve depends on the exploitation rate in the neighboring fishing grounds. For example, if exploitation is maintained at 40%, the ‘optimal’ reserve size would be 10%. If the rate increases to 50%, then the reserve needs to be 30% of the management area in order to maximize catches. However, even in lower exploitation fisheries (below 40%), a small reserve (up to 20%) provides significantly higher gains in fish biomass than losses in catch. Marine reserves are a valuable fisheries management tool. To achieve maximum fishery benefits they should be complemented by fishing effort controls.