集成有源负载放大器的研究

本文重点介绍了集成有源负载放大器的分析方法,并以镜像电流源为例详细介绍、对比了两种方法(图解分析法和微变等效电路分析法)。此外,介绍了用厄雷电压计算 Av 的简便方法。     

利用振幅调制器进行光电负反馈抑制激光强度噪声

采用振幅调制器作为抑制激光强度噪声的元件，首先对光电负反馈回路进行了简要的理论分析，然后利用该光电负反馈进行抑制激光二极管抽运全固化单频环形Nd:YVO4红外激光器强度噪声的实验。结果表明，在0－1MHz的低频段，强度噪声大幅度降低，最大降低约15dB。     

运用量子约束动力学对具有耗散的量子位的追踪控制

在有限温度环境内，量子约束动力学及其追踪控制可使退相干系统的相干性稳定一段时间.约束方程产生的控制场能够按量子比特的动力学状态进行控制(量子动力学轨道的反馈控制)；依靠量子比特的这种反馈效应，可使量子位稳定在设定的时间内.同时，在量子位的稳定方面，温度扮演一种消极的角色. 关键词： 量子约束动力学 耗散量子位的控制 追踪控制 量子比特的反馈效应     

Commuting and stable feedback design for switched linear systems

In the paper, commuting and stable feedback design for switched linear systems is investigated. This problem is formulated as to build up suitable state feedback controller for each subsystem such that the closed-loop systems are not only asymptotically stable but also commuting each other. A new concept, common admissible eigenvector set (CAES), is introduced to establish necessary/sufficient conditions for commuting and stable feedback controllers. For second-order systems, a necessary and sufficient condition is established. Moreover, a parametrization of the CAES is also obtained. The motivation comes from stabilization of switched linear systems which consist of a family of LTI systems and a switching law specifying the switching between them, where if all the subsystems are stable and commuting each other, then the total system is stable under arbitrary switching.     

束晕-混沌的复杂性理论与控制方法及其应用前景

本文系统论述涉及强流加速器等强流离子束装置中产生的束晕-混沌的复杂性理论与控制方法及其应用前景。强流离子束在核材料生产与增殖、洁净核能、放射性废物嬗变、放射性药物生产、重离子聚变、高能物理、核科学与工程、国防与民用工业和医疗等许多方面都有极其重要的应用潜力和诱人的发展前景。尤其是，近年来强流加速器驱动的放射性洁净核能系统是国内外关注的热门课题，因为它比常规核电更安全、更干净、更便宜。但是，强流离子束形成的束晕-混沌的复杂性现象已引起了国内外广泛关注，需要加以抑制、控制和消除这类现象，解决这一难题已经成为强流离子束应用中的关键问题之一。目前不仅必须深入研究这类束晕-混沌的复杂特性及其产生的物理机制，而且需要研究如何实现对束晕-混沌的有效控制，并寻求和发展其新理论、新方法和新技术。这就向强流离子束物理和非线性-复杂性科学及其技术提出了一系列极富挑战性的新课题。本文结合国内外的研究概况，根据我们多年来的研究成果，特别是我们首创性地提出了一些束晕-混沌的有效控制方法，它们包括：非线性反馈控制法，小波反馈控制法，变结构控制法，延迟反馈控制法，参数自适应控制法等，进行重点的介绍。对上述课题当前的主要进展及相关问题进行系统的总结和比较全面综述的评论。最后，指出该领域今后的研究方向，以推动这个崭新领域的深入研究和应用发展。     

Variational Derivative for Buckling Loads of Beams and Frames

The finite-difference method is a numerical technique for obtaining approximate solutions to differential equations. The main objective of the present study is to give a new aspect to the finite-difference method by using a variational derivative. By applying this formulation, accurate values of the buckling loads of beams and frames with various end supports are obtained. The performance of this formulation is verified by comparison with numerical examples in the literature __________ Published in Prikladnaya Mekhanika, Vol. 41, No. 7, pp. 139–144, July 2005.     

Stability and Nonlinear Deformation of Cylindrical Grids

The general stability of single-layer cylindrical grids is studied in linear and nonlinear formulations. Dependence of the general buckling load on the geometry and stiffness parameters of a grid is established in an analytical form. Such grids are numerically analyzed for stability. It is established that the general buckling load is much less than the local buckling load. Typical general buckling modes are found. It is shown that such grids are weakly sensitive to imperfections     

几何相似体应力-应变分布相同时的载荷关系

为了保证几何相似模型与原件具有完全相同的应力-应变分布,必须对几何相似模型施加与实际构件成对应比例的各种载荷,因此需要寻求几何相似模型在应力-应变分布完全相同时各种外加载荷的比例关系。从相似理论入手,以2端固支的矩形梁下表面边线中点的应力解析表达式为基础进行推导,得出相应的理论载荷关系,并用算例在弹塑性状态下验证了所得关系的正确性。得到的结论是:对于2个几何相似构件,若几何相似系数为kl,则当外加集中载荷的载荷系数为kl、均布线载荷的载荷系数为kl、均布面载荷的载荷系数为1时,2构件的应力-应变分布完全相同。     

A parallel cell‐based DSMC method on unstructured adaptive meshes

A parallel DSMC method based on a cell‐based data structure is developed for the efficient simulation of rarefied gas flows on PC‐clusters. Parallel computation is made by decomposing the computational domain into several subdomains. Dynamic load balancing between processors is achieved based on the number of simulation particles and the number of cells allocated in each subdomain. Adjustment of cell size is also made through mesh adaptation for the improvement of solution accuracy and the efficient usage of meshes. Applications were made for a two‐dimensional supersonic leading‐edge flow, the axi‐symmetric Rothe's nozzle, and the open hollow cylinder flare flow for validation. It was found that the present method is an efficient tool for the simulation of rarefied gas flows on PC‐based parallel machines. Copyright © 2004 John Wiley & Sons, Ltd.     

耦合映像格子中时空混沌的状态反馈控制

利用状态反馈的方法，实现了耦合映像格子中时空混沌的稳定控制.反馈方式可以是没有延迟的，也可以是有延迟的；控制方式可以是连续的，也可以是脉冲的.数值模拟结果证明了状态反馈方法的有效性. 关键词： 耦合映像格子 时空混沌 状态反馈控制