论住宅户型设计

为适应现代人居住观念的变化，结合设计工作的实践，分别就住宅户型设计中的户内空间序列以及起居室、卧室、厨房、卫生间的设计理念、设计原则和有关具体问题进行了探讨。     

多壁碳纳米管膜湿敏特性的研究

研究了多壁碳纳米管(MWNTs)薄膜的湿敏特性，实验所用的多壁碳纳米管是用热灯丝化学气相沉积法(CVD)合成的.分别对未修饰和修饰的多壁碳纳米管膜温度和湿度特性进行研究后发现，修饰的多壁碳纳米管对温度和湿度非常敏感，且对湿度的响应时间和恢复时间短，重复性好.而未修饰的多壁碳纳米管对温度和湿度不太敏感.对修饰多壁碳纳米管的湿敏特性进行了理论分析，给出了其理论表示式. 关键词： 多壁碳纳米管 化学修饰 湿敏特性 物理吸附     

绝缘表面和气体导电与湿度的关系

湿度对绝缘体表面电导和气体电导有一定的影响，但通常在湿度传感器的研究中忽略了气体电导的贡献。本文通过特殊设计装置来区分表面电导和气体电导，并分别从实验和理论上进行了定性的研究。     

关于喷水室中热湿交换效率的研究

本文探讨了喷水室中的热湿交换机理,导出了反映不同换热效率之间的关系式,从中可知,η_1,η_2和X值是相互有关联的。利用本文导出的公式,可将不同作者通过实验所整理成的某一热湿交换效率值,变挟成其它换热效半值,以供从事空调设计和运行的人员使用。     

Hygrometric Determination of Water Activities and Osmotic and Activity Coefficients of NH4Cl–LiCl–H2O at 25°C

The mixed aqueous electrolyte system of ammonium and lithium chlorides has been studied by the hygrometric method at 25°C. The relative humidities of this system are measured at total molalities from 0.3 to 6 mol-kg^{– 1} for different ionic-strength fractions y of NH₄Cl with y = 0.33, 0.50, and 0.67. The data obtained allow the deduction of new water activities and osmotic coefficients. The experimental results are compared with the predictions of the ECA (extended composed additivity) law proposed in our previous work. The Zdanovskii–Stokes–Robinson (ZSR), the Robinson–Stokes (RS), Reilly–Wood–Robinson (RWR), the Pitzer, and the Lietzke–Stoughton (LS II) models are also compared with our results. Predictions made using these models are, in general, consistent with our results. From these measurements, new Pitzer mixing ionic parameters are determined and used to predict the solute activity coefficients in the mixture for different ionic-strength fractions.     

贵州省粮食储藏地理区划初步研究

通过对贵州省气象特征的分析,尤其是对影响粮食安全储藏的主要环境因素温度和相对湿度的分析,得出贵州省粮食储藏可划分为四个地理区域。依据各区域的储藏气候条件和主要粮食的储藏特点,提出相应的储藏技术措施。     

In situ prepared polypyrrole for low humidity QCM sensor and related theoretical calculation

In situ preparation of polypyrrole (Ppy) by photo-polymerization coated on a quartz crystal microbalance (QCM) as a low humidity sensor was reported. Different concentrations of Ppy films say 0 wt.% (as blank), 0.1, 1, and 10 wt.% were investigated to measure humidity concentrations between 14.7 and 5412.5 ppm_v. The adsorption/desorption behavior was also examined at humidity concentration 510.2 ppm_v. The sensitivities of 0, 0.1 and 1 wt.% Ppy films at 51.5 ppm_v were 0.143, 0.219 and 0.427, respectively. For 1 wt.% Ppy, the highest sensitivity was obtained. The slope and correlation coefficients (R²) for 1 wt.% Ppy at the ranges of 14.7–898.6 ppm_v were 0.0646 and 0.9909, respectively. A series of molecular simulations have been carried out to calculate bond energy for the water molecule interaction with Ppy, which was found to be 3 kcal/mol indicating the existence of hydrogen bonding during the sorption process. Based on Langmuir isotherm adsorption assumption, for 0.1 and 1 wt.% Ppy films, the association constants were 2606.30 and 5792.98, respectively. This larger association constant for 1 wt.% Ppy film explains higher sensitivity.     

Hygrometric Determination of Water Activities, Osmotic and Activity Coefficients, and Excess Gibbs Energy of the System MgSO4–K2SO4–H2O

Ternary aqueous solutions of MgSO₄ and K₂SO₄ have been studied by the hygrometric method at 25°C. The relative humidity of this system is measured at total molalities from 0.35 mol-kg^–1 to about saturation for three ionic-strength fractions (y = 0.25, 0.50, and 0.80 of MgSO₄. The data allow calculation of water activities and osmotic coefficients. From these measurements, the Pitzer ionic mixing parameters are determined and used to predict the solute activity coefficients in the mixture. The results are used to calculate the excess Gibbs energy at total molalities for ionic-strength fraction y.     

Boiling Temperature and Reversed Deliquescence Relative Humidity Measurements for Mineral Assemblages in the NaCl + NaNO3 + KNO3 + Ca(NO3)2 + H2O System

Boiling temperature measurements have been made at ambient pressure for saturated ternary solutions of NaCl + KNO₃ + H₂O, NaNO₃ + KNO₃ + H₂O, and NaCl + Ca(NO₃)₂ + H₂O over the full composition range, along with those of the single salt systems. Boiling temperatures were also measured for the four component NaCl + NaNO₃ + KNO₃ + H₂O and five component NaCl + NaNO₃ + KNO₃ + Ca(NO₃)₂ + H₂O mixtures, where the solute mole fraction of Ca(NO₃)₂, x{Ca(NO₃)₂}, was varied between 0 and 0.25. The maximum boiling temperature found for the NaCl + KNO₃ + H₂O system is ≈134.9 ^∘C; for the NaNO₃ + KNO₃ + H₂O system is ≈165.1 ^∘C at x(NaNO₃) ≈ 0.46 and x(KNO₃) ≈ 0.54; and for the NaCl + Ca(NO₃)₂ + H₂O system is 164.7 ± 0.6 ^∘C at x{NaCl} ≈ 0.25 and x{Ca(NO₃)₂} ≈ 0.75. The NaCl + NaNO₃ + KNO₃ + Ca(NO₃)₂ + H₂O system forms molten salts below their maximum boiling temperatures and the temperatures corresponding to the cessation of boiling (dry-out temperatures) of these liquid mixtures were determined. These dry-out temperatures range from ≈300 ^∘C when x{Ca(NO₃)₂} = 0 to ≥ 400 ^∘C when x{Ca(NO₃)₂} = 0.20 and 0.25. Mutual deliquescence/efflorescence relative humidity (MDRH/MERH) measurements were also made for the NaNO₃ + KNO₃ and NaCl + NaNO₃ + KNO₃ salt mixture from 120 to 180 ^∘C at ambient pressure. The NaNO₃ + KNO₃ salt mixture has a MDRH of 26.4% at 120 ^∘C and 20.0% at 150 ^∘C. This salt mixture also absorbs water at 180 ^∘C, which is higher than expected from the boiling temperature experiments. The NaCl + NaNO₃ + KNO₃ salt mixture was found to have a MDRH of 25.9% at 120 ^∘C and 10.5% at 180 ^∘C. The investigated mixture compositions correspond to some of the major mineral assemblages that are predicted to control brine composition due to the deliquescence of salts formed in dust deposited on waste canisters in the proposed nuclear repository at Yucca Mountain, Nevada.     

Sol-Gel Synthesis of Humidity-Sensitive P2O5-SiO2 Amorphous Films

The sol-gel synthesis of silicophosphate gels using phosphoryl chloride and tetraethoxysilane as molecular precursors is reported and discussed. Gel-derived glasses and films having the molar compositions 10P₂O₅ · 90SiO₂ and 30P₂O₅ · 70SiO₂ have been obtained. The structure of the dried gels as well as the structural modifications that occurs during the transformations in gel-derived glasses are analyzed by Fourier transform infrared spectroscopy (FTIR). It has been found that the evidence of the P—O—Si linkages begins to appear only on the FTIR spectra of the bulk gels heat treated up to 400°C while they are well resolved on the FTIR spectra of the bulk gel samples heated up to 1000°C indicating that at this temperature the transformation in the corresponding gel-derived glasses occurs. The humidity sensitive properties of the gel-films have been evaluated by electrochemical impedance spectroscopy (EIS). The phosphorous content as well as the temperature of the heat treatments strongly affect the sensitivity to RH of the gel-derived films.