医药洁净室的计算流体动力学模拟及实测对比

采用计算流体动力学(CFD)模拟,研究3个医药洁净室的气流流型及颗粒物浓度.采用标准k-ε双方程模型,通过模拟颗粒物在洁净室的分布,分析合理的污染物散发位置及散发比例.对比参考发尘量下的结果与实测数据的差异,根据实测数据确定污染散发量,通过试验不同的单位容积发尘量,计算对应的洁净度,得到与实测数据吻合最好的单位容积发尘量.在单位容积发尘量为1 000pc·(m3·min)-1计算条件下,各房间的模拟结果与实测数据数值比较吻合,且经CFD预测的3个房间的洁净度变化趋势与实测一致.     

高静态动作压力下粉尘爆炸泄放标准的可靠性

粉尘爆炸泄放设计标准的可靠性对能否实现爆炸防护尤为关键.以中径70μm石松子粉尘为介质,采用20 L球形粉尘爆炸装置进行了4种泄放口径、静态动作压力在0.12~0.6 MPa的爆炸泄放实验,对比了实验值与NFPA 68和EN 14491计算值.结果表明,NFPA 68在预测高静态动作压力下的泄放面积时,随着泄放口径的增大,预测结果由保守变为危险,但预测结果精度较好且数值稳定;EN 14491在预测高静态动作压力下的泄放面积时非常保守,预测精度较差,数据不可靠.依据两种标准推荐的经验函数关系,分析了NFPA 68和EN 14491在预测高静态动作压力时产生这种差异的原因.     

尘埃粒子的时空结构及其性质

讨论了尘埃粒子解的时空结构及其性质，导出了尘埃粒子的内空间的离散结构.证明了尘埃粒子内部的物质球是一个无坐标的平直球，因而具有最小的体积和整体的关联性.导出了在尘埃粒子的内外时空中的径向测地线并说明其连续性.阐述了由这个解所揭示的物质、引力与时空之间的内在联系. 关键词： 尘埃粒子 离散时空 测地线     

Letter: Causality Violating Geodesics in Bonnor's Rotating Dust Metric

We exhibit timelike geodesic paths for a metric, introduced by Bonnor [11] and considered also by Steadman [13], and show that coordinate time runs backward along a portion of these geodesics.     

收尘极板上沉降粉尘粘结性能研究

振打清灰效果不好，严重影响电除尘器的除尘效率和使用范围，而影响振打清灰效果的最主要因素是沉降粉体的粘结力。通过建立数学模型从微观的角度推导出粉尘之间各种粘结力的理论计算公式。分析了比电阻、外加电场和粉尘含水率等因素对粉尘粘结力的影响。在实验中，模拟电除尘器中的静电场，测出在不同外加电场下粉尘粘结力的大小，定量的反应了外加电场对粉尘粘结性能的影响。     

炼钢厂引风机叶轮粘灰控制

对目前广泛采用的炼钢厂一次烟气引风机叶轮冲水清灰效果不佳的原因进行了分析，提出采用压缩气体清灰的思路，并计算了供气压力。现场实际运行效果表明，风机运行周期超过1个月。     

Spectroscopic investigation of the Dergaon meteorite with reference to 10 μm and 20 μm bands

Analysis of a part of the meteorite which fell at Dergaon (India) on March 2, 16.40 local time (2001) is presented with the help of FTIR, absorption and atomic spectra. The FTIR spectrum exhibits prominent absorption bands in the region 800–1100 cm⁻¹, originating from the valence vibration of SiO⁴, a basic component of the silicate lattice.     

基于模糊数学的塑烧板除尘计算机控制系统

介绍了塑烧板除尘器的系统总体结构和工作原理,阐述了模糊控制模型的建立。     

Local and non-local sources of airborne particulate pollution at Beijing--The ratio of Mg/Al as an element tracer for estimating the contributions of mineral aerosols from outside Beijing

A new element tracer technique has firstly been established to estimate the contributions of mineral aerosols from both inside and outside Beijing. The ratio of Mg/Al in aerosol is a feasible element tracer to distinguish between the sources of inside and outside Beijing. Mineral aerosol, inorganic pollution aerosol mainly as sulfate and nitrate, and organic aerosol are the major components of airborne particulates in Beijing, of which mineral aerosol accounted for 32%―67% of total suspended particles (TSP), 10%―70% of fine particles (PM2.5), and as high as 74% and 90% of TSP and PM2.5, respectively, in dust storm. The sources from outside Beijing contributed 62% (38%―86%) of the total mineral aerosols in TSP, 69% (52%―90%) in PM10, and 76% (59%―93%) in PM2.5 in spring, and 69% (52%―83%), 79% (52%―93%), and 45% (7%―79%) in TSP, PM10, and PM2.5, respectively, in winter, while only ～20% in summer and autumn. The sources from outside Beijing contributed as high as 97% during dust storm and were the dominant source of airborne particulates in Beijing. The contributions from outside Beijing in spring and winter are higher than those in summer, indicating clearly that it was related to the various meteorological factors.     

层流中粉尘的火焰传播速度

建立了筛落式粉尘火焰试验装置和火焰信的号光电测量系统。提出确定火焰前沿位置的“最大斜率切线法”和判定火焰传播稳定性的“相对入射能量法”。测定了硅钙粉和煤粉的火焰传播速度和火焰厚度。结果表明数据合理,测量装置和方法可用于速度范围很宽的粉尘火焰传播研究,用修正的田中达夫模型计算的硅钙粉层流火焰传播速度与实验值接近。