Collective Tunnelling of Strongly Interacting Cold Atoms in a Double-Well Potential

It is known that under resonance conditions, a group of strongly interacting bosonic atoms, trapped in a double-well potential, mimics a single particle, performing Rabi oscillations between the wells. By implication, all atoms need to tunnel at roughly the same time, even though the Bose–Hubbard Hamiltonian accounts only for one-atom-at-a-time transfers. The mechanism of this collective behavior is analyzed, the Rabi frequencies in the process are evaluated, and the limitation of this simple picture is discussed. In particular, it is shown that the small rapid oscillations superimposed on the slow Rabi cycle result from splitting the transferred cluster at the sudden onset of tunnelling, and disappear if tunnelling is turned on gradually.     

冷轧带钢局部高点卷取过程起筋控制的建模与仿真

为了研究带钢局部高点卷取起筋的控制方法，利用三维弹塑性变形基本理论，并引入带钢塑性流动因子，建立了弹塑性卷取应力和起筋量模型.基于应力函数假设、S. Timoshenko最小功原理和伽辽金虚位移法建立了起筋带钢的应力场分布和可用于在线计算的起筋临界卷取张力设定模型.仿真结果表明：局部高点在径向累积叠加所引起的带钢张力不均匀分布和轴向压应力是导致带钢起筋的主要原因；起筋量随局部高点高度、卷径和卷取张力增加而增大，薄带钢比厚带钢起筋量增幅明显；临界卷取张力随卷径、带钢厚度和局部高点高度增大而减小.     

来自磁光阱中冷原子团的荧光干涉条纹及其应用

实验观察来自磁光阱中冷原子团的荧光经真空系统窗口的平板玻璃反射产生的干涉条纹，理论分析表明从从荧光干涉条纹的强度分布可获得关于俘获原子总数以及密度分布的信息。采用该方法实测了俘获原子总数，并模拟得到了不同密度分布时条纹的对比度变化。     

旋流式低温送风口的实验研究

对新研制的一种旋流式低温送风口进行了空气动力、速度场、温度场及噪声测试.测试结果表明该旋流式低温送风口诱导效果好、阻力小、能耗低、噪声低、送风均匀、不结露,完全能满足低温送风要求.     

Cold compaction of ceramic powder: Computational analysis of the effect of pressing method and die shape

This paper deals with a computational analysis of the influence of the pressing method and part geometry on the final density distribution in the cold compaction process of ceramic alumina powders. The analysis is based on the explicit finite-element model proposed and validated in a previous study. The mechanical behavior of the processing material is described using a multisurface elastoplastic model, the modified Drucker-Prager/Cap model Published in Prikladnaya Mekhanika, Vol. 43, No. 10, pp. 129–134, October 2007.     

冷热敷治疗踝关节损伤

本文通过冷热敷和功能锻炼治疗踝关节损伤的试验，表明冷热治疗踝关节韧带损伤时间短，疗效好，在运动实践中可提倡．     

微脉冲电子枪的初步实验研究

给出了微脉冲电子枪的模拟计算及其初步实验结果. 该电子枪采用铜铝镁合金作为冷阴极材料, 在以磁控管作为微波功率源的出束实验中得到了100mA/cm²的电流密度.实验结果与次级电子倍增解析计算和SEEG程序的模拟计算结果基本符合, 初步验证了微脉冲电子枪的基本原理, 为今后实验中得到更大的电流密度打下了基础.     

测量冷原子温度的理论与近似拟合公式的误差分析

对短程飞行时间法(tim e-of-flight,TOF)中推算冷原子温度的理论拟合公式与近似拟合公式进行了误差分析与比较。研究表明:对于使用短程飞行吸收光谱信号推测冷原子团温度,当探测光光斑半径与冷原子团高斯半径之比k小于0.2时,理论拟合公式和近似拟合公式能很好的相符,随着探测光光斑半径与冷原子团高斯半径比值的逐渐增大,用近似拟合公式所得TOF吸收信号与用理论拟合公式所得TOF吸收信号的误差也将逐渐增大,当比值为0.5时,用近似拟合公式所得TOF吸收信号的误差将增大到20%。     

Design and Cold Tests of Asymmetric Quasioptical Resonators

This paper presents the design and test of asymmetric quasioptical resonators for gyrotron applications, where most of the diffraction output coupling comes from the smaller of two mirrors. A computer code based on scalar diffraction theory is used to calculate the resonator losses and the electric field near the mirrors. Resonators with mirror separations approaching confocal have reduced side lobes in the diffraction patterns, which should allow for better power transmission and focusing. Cold tests have been performed at 94 and 141 GHz to measure the quality factor of the asymmetric resonators as a function of mirror separation and mirror misalignment. Typical resonator parameters include 65 cm mirror separation, 1-3% output coupling and 85% of the losses from the small mirror. A half-symmetric resonator with one flat and one curved mirror has also been investigated. The calculated values of Q are in reasonably good agreement with the cold test measurements.     

冷轧压下率分配对IF钢深冲性能的影响

冷轧压下率对IF钢的深冲性能有重要的影响。采用两次冷轧，在总压下率一定的情况下，两次冷轧压下率的分配是影响IF钢深冲性能的关键。通过冷轧实验，得出在总压下率一定时，两次冷轧比一次冷轧的塑性应变比r值要高；总压下率一定，一次冷轧压下率较小，两次冷轧压下率较大时，可使r值提高；同时，冷轧总压下率提高，也可使r值提高。