Electrochemical Preparation of WO_3 Nanowire Arrays

1 Results Ordered WO3 nanowires arrays have been fabricated by electrochemical deposition with anodic aluminum oxide (AAO) templates and annealing the W nanowire arrays in air at 400 ℃. The morphology and the chemical composition of WO3 nanowires arrays were characterized by Scanning Electron Microscopy (SEM),Transmission Electron Microscopy (TEM), X-ray Photoelectron Spectroscopy (XPS), and X-ray diffraction (XRD). The results show that the diameters of the WO3 nanowires are about 90 nm, which is in go...     

纳米WO3的制备及其光解水析氧性能研究

用溶胶凝胶法,灼烧法合成了纳米级WO3,采用X-射线衍射、紫外可见漫反射光谱对WO3进行表征.在Fe3 为电子受体、溶液酸度pH为2.0情况下,研究了纳米级WO3在365nm紫外辐射下光解水析氧的光催化活性,并讨论了不同方法制备的催化剂活性差异的原因.结果表明,结晶程度越高、尺寸越小、比表面积越大的纳米级WO3具有更高的光分解水析氧活性,电子受体的浓度、溶液的酸度对析氧活性有明显的影响.     

The research on the high quality TiO2, MoO3-doped WO3 electrochromic film

The high quality TiO2, MoO3-doped WO3 electrochromic film was prepared by the sol–gel method for the first time. The sol, which has hydrogen peroxide (H2O2) and oxalic acid (H2C2O4), was very stable at room temperature and quite suitable for the deposition of films. The WO3 electrochromic film prepared from this doped sol had excellent performance, such as short response time, no cracks, good adhesion to the substrate, high coloring efficiency and longevity of service.     

对甲烷氧化偶联W－Mn／SiO＿2催化剂Na＿2WO＿4的流失及其影响的考察

用ＸＲＤ、ＦＴ－ＩＲ、ＥＳＲ、Ｈ２－ＴＰＲ和ＴＰＯ等方法，对Ｎａ２ＷＯ４－Ｍｎ２Ｏ３／ＳｉＯ２催化剂和其经水煮处理的一系列样品进行了表征．实验发现该催化剂中的结晶态Ｎａ２ＷＯ４易于流失，单层分布的Ｎａ２ＷＯ４在苛刻的处理条件下也有可能流失．依此，探讨了上述流失现象与Ｎａ２ＷＯ４－Ｍｎ２Ｏ３／ＳｉＯ２催化剂的催化活性及该催化剂在长时间反应中发生的ＳｉＯ２相变之间的关系，证明了结晶态Ｎａ２ＷＯ４的流失对该催化剂甲烷氧化偶联反应的催化活性只有轻微的影响，单层分布Ｎａ２ＷＯ４的流失可造成催化剂中Ｍｎ从Ｍｎ３＋转变为Ｍｎ２＋，并使催化剂的催化活性明显降低．但在水煮条件下，无论是结晶态的还是单层分布，Ｎａ２ＷＯ４的流失都没有对ＳｉＯ２的α－方石英结构产生影响     

高选择性NH3敏元件

以化学沉淀法制备的ＷＯ３微粉作为气敏基体材料，以Ａｕ２Ｏ（或ＨＡｕＣｌ４）及ＮＨ４ＶＯ３为主要掺杂剂制成的气敏元件对ＮＨ３具有较高的灵敏度和优良的选择特性     

一步法制备含W介孔碳材料及其氧化脱硫性能研究

以钨酸钠为钨源,以乙二胺四乙酸二钠为碳源经过高温煅烧制备了含W的介孔碳材料,采用XRD、SEM、FT-IR、BET对含钨的介孔碳材料进行表征。结果表明,煅烧后介孔碳材料的表面形成了粒状含有结晶水的氧化钨(WO_3·H_2O)。相比于纯的介孔碳材料,含钨介孔碳材料的总比表面积减小。以含W介孔碳材料为催化剂,H_2O_2作为氧化剂,1-丁基-3-甲基咪唑氟硼酸盐([BMIM][BF_4])离子液体作为萃取剂,组成萃取-催化氧化脱硫体系(ECODS)并研究其对模拟油中二苯并噻吩脱除效果。考察了氧化钨负载量、反应温度、H_2O_2加入量、催化剂用量、离子液体用量以及不同类型硫化物对二苯并噻吩脱除的影响。在最佳反应条件下,催化剂对二苯并噻吩(DBT)、4,6-二甲基二苯并噻吩(4,6-DMDBT)、苯并噻吩(BT)、噻吩(TH)和真实汽油的脱除率分别达到98.6%、65.6%、61.2%、57.8%和64.3%。催化剂回收利用五次之后脱硫率略有降低,仍高达95.2%。     

水热法制备Li_(4-3x)Eu_x(WO_4)_2微晶及其发光性能

采用水热法制备了Li_(4-3x)Eu_x(WO_4)_2系列红色荧光粉.通过荧光分析(FL)、扫描电镜(SEM)和X射线衍射(XRD)对所得粉体的发光性能、颗粒大小及形貌和物相进行表征分析.XRD分析结果表明,制备的Li_(4-3x)Eu_x(WO_4)_2微晶均为白钨矿四方结构.SEM结果表明,Li_(4-3x)Eu_x(WO_4)_2颗粒度为2.0μm×0.2μm~12μm×1.0μm,且随x的增大而增大.荧光分析结果表明,该荧光粉可被近紫外光(395nm)有效激发,最大发射波长位于614nm,即为纯正的红光.随着x的增大,样品中Eu~(3+)的593nm和614nm两个特征发射峰的强度先增大后减小,当x=1.0时达到最大.     

Facile Preparation of WO3−x Dots with Remarkably Low Toxicity and Uncompromised Activity as Co-reactants for Clinical Diagnosis by Electrochemiluminescence

The exceptional nature of WO_3−x dots has inspired widespread interest, but it is still a significant challenge to synthesize high-quality WO_3−x dots without using unstable reactants, expensive equipment, and complex synthetic processes. Herein, the synthesis of ligand-free WO_3−x dots is reported that are highly dispersible and rich in oxygen vacancies by a simple but straightforward exfoliation of bulk WS₂ and a mild follow-up chemical conversion. Surprisingly, the WO_3−x dots emerged as co-reactants for the electrochemiluminescence (ECL) of Ru(bpy)₃²⁺ with a comparable ECL efficiency to the well-known Ru(bpy)₃²⁺/tripropylamine (TPrA) system. Moreover, compared to TPrA, whose toxicity remains a critical issue of concern, the WO_3−x dots were ca. 300-fold less toxic. The potency of WO_3−x dots was further explored in the detection of circulating tumor cells (CTCs) with the most competitive limit of detection so far.     

铝掺杂及钨酸锂表面包覆双效提升富锂锰基正极材料的循环稳定性

采用溶胶-凝胶法合成Al掺杂富锂锰基Li_1.2Mn_0.54-xAl_xNi_0.13Co_0.13O₂（x=0、0.03）锂离子电池正极材料,之后采用一步液相法制备Li₂WO₄包覆层,系统地研究了Al掺杂和Li₂WO₄包覆双效改性对富锂锰基正极材料电化学性能的影响.结果表明,Al掺杂后明显提升富锂锰基正极材料的循环稳定性,包覆层Li₂WO₄明显改善其倍率性能和放电平台电压衰减问题.Li₂WO₄包覆量为5% Li_1.2Mn_0.51Al_0.03Ni_0.13Co_0.13O₂正极材料在2.0~4.8 V充放电电压区间及1000 mA·g^-1电流密度下比容量仍高达110 mAh·g^-1左右,同时在100 mA·g^-1的电流密度下循环300次容量保持率为78%,而且循环过程中放电平台电压衰减也明显减缓.该工作为解决锂离子电池富锂锰基正极材料循环稳定性和平台电压衰减提供了新的思路.