Analytical procedures for quantification of peptides in pharmaceutical research by liquid chromatography–mass spectrometry

Peptide quantification by liquid chromatography–mass spectrometry (LC–MS) combines the high resolving power of reversed-phase (RP) chromatography with the excellent selectivity and sensitivity of mass spectrometric detection. On the basis of comprehensive practical experience in the analysis of small molecules, pharmaceutical research is developing technologies for analysis of a growing number of peptidic drug candidates. This article is a detailed review of procedures based on LC–MS techniques for quantitative determination of peptides. With the focus on pharmaceutical applications several technologies for sample preparation, various aspects of peptide chromatography, important characteristics of ESI–MS, selectivity of MS-detection modes, the large variability of internal standards, and modern instrumentation are discussed. The demand for reliable, robust, sensitive, and accurate methods is discussed using numerous examples from the literature, complemented by experiments and results from our laboratory.     

壳聚糖-盐酸溶液中温度敏感的相分离行为

研究了壳聚糖 盐酸溶液温度敏感的相分离行为.通过对壳聚糖-盐酸溶液浊度变化的考察以确定相分离温度.测定不同盐酸浓度、壳聚糖浓度以及不同脱乙酰度的条件下的相分离温度，并用DLVO理论(Deijaguin-Landau and Verwey-Overbeck Theory)进行了解释. FTIR、X-ray以及SEM分别描绘了壳聚糖经相分离过程后官能团、结晶状态、颗粒形态的特点.     

丙烯腈水相沉淀聚合研究进展

结合近几年的研究成果,笔者对丙烯腈水相沉淀聚合机理、聚合动力学、动力学数学模型诸方面问题进行了系统的综述,反映了该领域的研究概况和最新研究成果.     

Physical properties and electrochemical performance of LiMn2O4 cathode materials prepared by a precipitation method

LiMn₂O₄ powder for lithium-ion batteries was prepared by a precipitation method, and the effects of calcination temperature on the physical properties and electrochemical performance of the samples were investigated by various methods. The results of X-ray diffraction (XRD) showed that the lattice parameter (a) and the unit cell volume (v) decrease with the increasing calcination temperature, and the LiMn₂O₄ sample calcined at 750°C has smaller particle size and higher crystallinity than other samples. The results of the electrochemical experiments showed that the sample calcined at 750°C has larger peak currents, higher initial capacity, and better cycling capability, because of its lower charge-transfer resistance and larger diffusion coefficient of Li⁺ ions than those of other samples.     

Evaluation of new selective molecularly imprinted polymers prepared by precipitation polymerisation for the extraction of phenylurea herbicides

Three different molecularly imprinted polymers (MIPs) have been prepared by precipitation polymerisation using linuron (LIN) or isoproturon (IPN) (phenylurea herbicides) as templates and methacrylic acid (MAA) or trifluormethacrylic acid (TFMAA) as functional monomers. The ability of the different polymers to selectively rebind not only the template but also other phenylurea herbicides has been evaluated. In parallel, the influence of the different templates and functional monomers used during polymers synthesis on the performance of the obtained MIPs was also studied through different rebinding experiments. The experimental binding isotherms were fitted to the Langmuir-Freundlich isotherm allowing to describe the kind of binding sites present in the imprinted polymers under study. It was concluded that TFMAA-based polymer using IPN as template presents the best properties to be used as a selective sorbent for the extraction of phenylurea herbicides.     

Material transport between the atmosphere and sediment of the Lake Balaton

A monitoring system was developed to gain information on the present level of pollutants in the Lake Balaton, Hungary. Determination of 13 polycyclic aromatic hydrocarbons (PAHs) and inorganic pollutants (mostly toxic metals) in aerosol, precipitation and sediment samples was carried out. The aim of collecting aerosol and precipitate samples in the same site at the same period was to determine the distribution of elements in two depositions. For the fractionation by particle size, aerosols were sampled by a cascade impactor. A simple three-stage sequential leaching procedure was applied to establish the distribution of metals among environmentally mobile, bound to carbonates and oxides, and environmentally immobile, (bound to silicates) fractions in aerosols. Sediment samples were collected from 17 different sites inside of the lake and 10 sites at harbors at 30–70 cm in depth. Core samples were cut to 10-cm pieces, dried at room temperature, and finally passed through a 63-μm sieve. Total concentrations of elements were determined by atomic absorption spectrometry (AAS) after an acidic digestion. The concentrations of PAHs were determined by HPLC method with fluorescence detection.In aerosol samples collected from September 6, 2002 to January 26, 2003, concentration of Cd was <0.1 μg/m³, and the majority of Cd has been found in the mobile fraction. Cadmium was associated to particles between 0.25 and 2 μm indicating the anthropogenic origin. Similar distribution of Pb was obtained in all seasons, and the highest concentration of Pb was found as 8.6 ng/m³ in particle size of 0.7 and 1.4 μm. Results of total concentration of elements of bottom sediments of the Lake Balaton and harbors were compared to Interim Sediment Quality Guideline (ISQG) values and the Probable Effect Level (PEL) values. Data showed that the average concentrations of elements were usually less than those of ISQGs and other background data for soils and geochemical values. The sediment is not polluted and its disposal is feasible. There is no direct correlation between the concentration of elements deposited onto the surface of the lake from dry and wet deposition and the upper part of the sediment. So, from the budget of the deposition, the concentration of elements in the upper layer of the sediment cannot be predicted.Seasonal changes of the concentration of PAHs in aerosol was observed, samples collected at winter contained the highest values. In December–January 2002/2003, the wet deposition was found as 64 μg/m² period. Among the individual compounds, the wet deposition rate of phenantrane, fluoranthene and pyrene was dominant, while for dry deposition, these compounds were fluoranthene and pyrene. The concentrations of ∑PAHs found for all sites and depth of sediment samples ranged from 11 to 1734 μg/kg dry weight with an average of 132 μg/kg. These values represent a quite low pollution level compared to other sediment with anthropogenic influence. Based on the results, it can be definitely confirmed that the chemical quality of the water and sediment of the Lake Balaton is satisfactory.     

原子吸收光谱法间接测定叶酸的含量

在pH5．0的NaOAc-HOAc缓冲溶液中，过量的硝酸银完全沉淀叶酸，用原子吸收光谱法测定剩余的硝酸银，间接计算出叶酸的含量。方法简单快速，回收率在98％～104％之间，相对标准偏差为2．4％。     

计算机图解法确定掩蔽剂存在下微溶物沉淀的pH值

采用计算机图解法，以副反应系数为主变数，应用Excel电子表格和Origin作图程序进行计算、作图，可以极为简便地确定在掩蔽剂存在下，微溶物开始沉淀时和完全沉淀时的pH值，图形直观明了，具有确定的物理意义。     

A novel and simple pathway to synthesis of porous polyurea absorbent and its tests on dye adsorption and desorption

A novel one-step protocol for the preparation of porous polyurea material (PPU) through precipitation polymerization of toluene diisocynate (TDI) is presented. The process is based on step polymerization of one singlemonomer, TDI, with water in water-acetonemixed solvent. PPU is obtained without need for any porogen or additives, and no any chemical modification on the outcome polymer is necessary. The morphology, pore size and size distribution of PPU are characterized by scanning electron microscope and BET nitrogen adsorption. Taking acid fuchsine (AF) and Congo Red as dye examples in wastewaters, their adsorption on, desorption from PPU and the reusability of PPU were tested. Experimental conditions for AF adsorption were optimized with regard to pH, adsorption time, AF concentration and amount of PPU. Results demonstrate that the as-prepared PPU is of high performance in dyes adsorption and recycled use. This work presents therefore a novel and attractive candidate for removal of anionic dyes from wastewaters.     

Study on the Agglomeration Kinetics of Uranium Peroxide

Considering the previous study dealing with thermodynamic and kinetic phenomena (nucleation and crystal growth) during the uranium peroxide precipitation, this work focuses on the agglomeration mechanism. It provides the results obtained from the experiments carried out in a MSMPR reactor operating at steady state. The influence of the operating parameters on the uranium peroxide agglomerates was studied in order to identify the agglomeration kernel. The method is based on the resolution of the population balance equation using the method of moments and the experimental particle size distributions. The results lead to a size-independent kernel directly proportional to the crystal growth rate. Under the stirring conditions studied, the agglomeration appears to be significantly reduced by mixing which results in a kernel inversely proportional to the average shear rate. The agglomeration kinetic law obtained in this study will be used for the process modelling in a further study.