Microstructure,mechanical properties and wear resistance of an Al–Mg–Si alloy produced by equal channel angular pressing

Microstructure, mechanical properties and wear resistance in an ultrafine-grained Al–Mg–Si alloy fabricated utilizing a combination of equal channel angular pressing (ECAP) and dynamic aging were investigated in this paper. The results indicated that the grain size of the ECAP alloy was significantly refined, i.e., to ~239 nm after three ECAP passes. Meanwhile, the yield and tensile strength of the ECAPed material reached 340 MPa and 445 MPa, respectively, while maintaining a significant uniform elongation of 14%. Wear resistance results demonstrated that the wear rate, wear depth and width of the ECAPed material decreased in comparison with the solution-treated (SST) and peak-aged (T6) conditions under a load range of 5–25 N. The adhesive wear that occurs in the undeformed specimens at 10 N does not appear in the ECAPed specimen at the same load, indicating that the ECAPed specimen delay the appearance of more serious wear mechanisms under certain loads. The cooperative interaction of high density nano-scale β" precipitates and dislocations resulted in a combination of super-high strength and good work hardening ability which suppressed the extension of cracks between the friction layer and the plastic deformation zone. As a consequence, the combination of ECAP and dynamic aging brings a significant improvement for antifriction performance of the 6061 aluminum alloy.     

煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

循环作用对马蹄寺石窟群岩体性能的影响

马蹄寺石窟群地处河西走廊中部,气候条件十分恶劣。由于常年受到温度、湿度、酸碱盐等作用的影响,石窟岩体性能出现了不同程度的劣化现象。通过开展室内模拟试验,研究以上多种恶劣环境的循环作用对于岩体抗压强度、波速、质量的影响规律,同时使用X射线衍射仪(X-ray diffraction,XRD)、X射线荧光光谱(X-ray fluorescence,XRF)和扫描电子显微镜(scanning electron microscope,SEM)对循环作用过程中样品的矿物组分、元素含量和微观形貌进行分析研究。研究结果表明,循环作用使样品中的长石类矿物和方解石含量降低,黏土类矿物含量增加,胶结程度下降,孔隙逐渐发展成为横向微裂隙,导致样品的性能出现不同程度的劣化现象。循环作用对岩体性能的影响程度从大到小依次为冻融循环、耐盐循环、耐碱循环、耐酸循环和温湿循环。     

Microstructural stability and age-hardening behavior of Re-added dual two-phase Ni3Al and Ni3V intermetallic alloys

The effect of Re addition on the microstructure and hardening behaviour of the dual two-phase Ni₃Al (L1₂) and Ni₃V (D0₂₂) intermetallic alloy was investigated by scanning electron microscopy, transmission electron microscopy and Vickers hardness test. The two-phase eutectoid microstructure accompanying the Re-rich precipitates were observed in the channel region of the alloys in which Re substituted for Ni but not in those in which Re substituted for Al and V. The concomitant addition of Nb (or Ta) with Re more stabilized the two-phase eutectoid microstructure and consequently more induced the fine precipitates in the channel region. The annealing at temperatures below the eutectoid temperature was necessary to induce the fine precipitates in the channel region and thereby result in the precipitation hardening. The fine precipitation in the channel region and related hardening was attributed to the alloying feature so that Re is soluble in the A1 (fcc) phase at high temperatures and becomes less soluble in the two intermetallic phases decomposed from the A1 phase at low temperatures.     

铝互连线的电迁移问题及超深亚微米技术下的挑战

铝互连线的电迁移问题历来是微电子产业的研究热点，其面临的电迁移可靠性挑战也是芯片制造业最持久和最重要的挑战之一.从20世纪90年代开始，超深亚微米(特征尺寸≤0.18 μm)铝互连技术面临了更加复杂的电迁移可靠性问题.从电迁移理论出发，分析概括了铝互连电迁移问题的研究方法，总结了上世纪至今关于铝互连电迁移问题的主要经验；最后结合已知的结论和目前芯片制造业现状，分析了当前超深亚微米铝互连线电迁移可靠性挑战的原因和表现形式，提出了解决这些问题的总方向. 关键词： 电迁移 铝互连 微结构     

FTIR光谱遥测红外药剂的燃烧温度

本文利用遥感FTIR光谱，对红外药剂的燃烧特性进行了研究。在分辨率为4cm^-1时，收集4700－740cm^-1波段的光谱。从HF等燃烧产物发射的分子振转基带精细结构的谱线强度分布，可以对燃烧温度进行遥感测定，并给出了燃烧温度随时间的变化关系，实验结果表明燃烧表面附近温度梯度很大，存在着急剧的变化温度场，同时也说明，在不干扰火焰温度场的情况下，利用遥感FTIR光谱对剧烈的、非稳态快速燃烧的火焰温度进行连续实时的遥感测量，是一种快速、准确、灵敏度高的测温方法，显示了它在燃烧温度测量、产物浓度测试以及燃烧机理研究等方面的应用前景。     

从 ${\cal B}^0$ 到 $E(p,q)$ 和 $E_0(p,q)$ 空间的复合算子

设 $\varphi$ 是单位园盘 $D$ 到自身的解析映射, $X$ 是 $D$ 上解析函数的 Banach 空间, 对 $f\in X$, 定义复合算子$C_\varphi $ : $C_\varphi (f)=f\circ \varphi$. 我们利用从 ${\cal B}^0$到 $E(p,q)$ 和 $E_0(p,q)$ 空间的复合算子研究了空间 $E(p,q)$ 和 $E_0(p,q)$, 给出了一个新的特征.     

铝合金加工用刀具的使用研究（三）

当前我国各机械加工生产厂家引进国外进口设备及生产线较多，实现引进设备及生产线上刀具的国产化以降低生产成本，成为当前国内整个机械加工领域亟待解决的问题。     

Cn中不同域的复合算子

令Ω1与Ω2与C^n中的两个有界齐性域，假设φ：1Ω→Ω2是一个全纯映射。在本中，我们研究相应的复合算子Cφ：β（Ω2）→β（Ω1）的有界性和紧性，特别地，我们讨论取B^n和U^n的情形。     

Theory of interfacial phase transitions in surfactant systems

The spin-1 Ising model, which is equivalent to the three-component lattice gas model, is used to study wetting transitions in three-component surfactant systems consisting of an oil, water, and a nonionic surfactant. Phase equilibria, interfacial profiles, and interfacial tensions for three-phase equilibrium are determined in mean field approximation, for a wide range of temperature and interaction parameters. Surfactant interaction parameters are found to strongly influence interfacial tensions, reducing them in some cases to ultralow values. Interfacial tensions are used to determine whether the middle phase, rich in surfactant, wets or does not wet the interface between the oil-rich and water-rich phases. By varying temperature and interaction parameters, a wetting transition is located and found to be of the first order. Comparison is made with recent experimental results on wetting transitions in ternary surfactant systems.This paper is dedicated to J. K. Percus in honor of his 65th birthday.