陈化温度和Fe/Zr配比对SO42-/Fe2O3-ZrO2固体超强酸结构与性能的影响

用低温陈化法制备了SO42 -/Fe2 O3 ZrO2 (简称SFZ)固体超强酸催化剂 ,用红外光谱 (IR)和X光衍射(XRD)对其结构进行了表征 ,并考察了它对合成癸二酸二正丁酯的催化性能 .IR谱显示 ,低温陈化的SFZ样品在10 70cm-1处吸收峰远强于常温陈化样品 .XRD分析则显示 ,在焙烧温度为 6 5 0℃、Fe/Zr为 2∶1时 ,低温陈化的样品出现了亚稳态的ZrO2 四方晶相 .该样品在催化酯化反应中使产率达 90 %以上 ,高于常温陈化样品的 30 % .研究结果表明 :在其他条件不变时 ,低温陈化所出现的亚稳态的ZrO2 四方晶相是表面酸性和催化活性增加的微观原因     

Age-dependent variations of cell response to oxidative stress: proteomic approach to protein expression and phosphorylation

We investigated the protein profiles of variously aged rat astrocytes in response to oxidative stress. After H2O2-exposure of cells at 100 microM for 30 min, the relative intensity of ten protein spots changed on two-dimensional (2-D) gels compared with control gels after silver staining. Matrix-assisted laser desorption/ionization-time of flight-mass spectrometry (MALDI-TOF-MS) analysis after in-gel digestion revealed that six of these spots corresponded to three kinds of proteins, each of which was composed of a protein and its modified form with a different isoelectric point (pI). These three proteins were identified as peroxiredoxins (PRDXs) II and III, and calpactin I light chain (p11). H2O2-exposure increased the intensity of the spot with lower pI and simultaneously decreased that of the spot with higher pI for both PRDXs II and III. In addition, the expression of annexin VII, S-adenosyl-L-homocysteine hydrolase, elongation factor II fragment (EF-II), and adenosine deaminase was increased by H2O2-exposure in astrocytes from variously aged rats. Using the Pro-Q Diamond staining, heat shock protein 60 kDa (Hsp 60) and alpha-tubulin were observed to be phosphorylated upon H2O2-exposure. While phosphorylation of alpha-tubulin was correlated positively with age, the changes in abundance of ten protein spots as described above were independent of age. These results suggest that aging does not suppress the responses aimed at limiting injury and promoting repair brought about by severe oxidative stress, and might affect cell dynamics including the formation of microtubules.     

Characterization of thermo-oxidative stability of polymer optical fibers using chemiluminescence technique

The thermo-oxidative stability of commercially available polymer optical fibers (POFs) and their components (cores and claddings) was investigated. All the bare POFs (core and cladding only) studied here were based on poly(methyl methacrylate) (PMMA) core. The fibers were exposed to 100 °C/low humidity for about 4200 h. Chemiluminescence (CL) technique was applied to investigate the thermo-oxidative stability and for measuring the transmission loss during exposure a prototype device called multiplexer was used. POFs exhibited variation in thermo-oxidative stability although they possessed identical core material PMMA. This was due to difference in the chemical compositions of claddings. Claddings were more susceptible to the thermo-oxidative degradation compared to cores. The thermo-oxidative degradation of both the cladding and the core was found in POFs as a result of climatic exposure. POFs showed an early drop-off followed by a slow decline of transmission. The early drop-off of transmission was attributed to physical changes like thermal expansion and the slow decline of transmission to chemical changes like oxidative degradation of POFs. A good linear relationship between optical transmission stability and thermo-oxidative stability of POFs was established from these studies.     

Use of D–T-produced fast neutrons for in vivo body composition analysis: a reference method for nutritional assessment in the elderly

Body composition has become the main outcome of many nutritional intervention studies including osteoporosis, malnutrition, obesity, AIDS, and aging. Traditional indirect body composition methods developed with healthy young adults do not apply to the elderly or diseased. Fast neutron activation (for N and P) and neutron inelastic scattering (for C and O) are used to assess in vivo elements characteristic of specific body compartments. Non-bone phosphorus for muscle is measured by the ³¹P(n,)²⁸Al reaction, and nitrogen for protein via the ¹⁴N(n,2n)¹³N fast neutron reaction. Inelastic neutron scattering is used to measure total body carbon and oxygen. Body fat is derived from carbon after correcting for contributions from protein, bone, and glycogen. Carbon-to-oxygen ratio (C/O) is used to measure the distribution of fat and lean tissue in the body and to monitor small changes of lean mass. A sealed, D–T neutron generator is used for the production of fast neutrons. Carbon and oxygen mass and their ratio are measured in vivo at a radiation exposure of less than 0.06 mSv. Gamma-ray spectra are collected using large BGO detectors and analyzed for the 4.43 MeV state of carbon and 6.13 MeV state of oxygen, simultaneously with the irradiation. P and N analysis by delayed fast neutron activation is performed by transferring the patient to a shielded room equipped with an array of NaI(Tl) detectors. A combination of measurements makes possible the assessment of the quality of fat-free mass. The neutron generator system is used to evaluate the efficacy of new treatments, to study mechanisms of lean tissue depletion with aging, and to investigate methods for preserving function and quality of life in the elderly. It is also used as a reference method for the validation of portable instruments of nutritional assessment.     

时效工艺对Cu-Ag-Zr合金电磨损性能的影响

对Cu-0．1Ag-0．18Zr合金时效后的电导率、显微硬度以及电滑动磨损性能进行了研究。结果表明：该合金940℃固溶1h后，在560℃时效可获得较高的电导率，在480℃时效可获得较高的显微硬度。时效前冷变形能大大加快第二相的析出过程，使合金综合性能显著提高。该合金经940℃固溶再经60％变形后，在480℃时效1h，其电导率和显微硬度分别可达85．6％IACS和HV131．2，而固溶后直接时效为81．3％IACS和HV116．1。在载流条件下，合金的磨损量随加载电流的增加而增大；磨损机制是以电蚀为主的电蚀、犁削和磨粒磨损。     

山东省人口老龄化问题及对策分析

依据先期预测结果和世界权威部门提供的有关数据，从人口老龄化程度、速度、总量等3个方面指标及其与经济发展的变动关系角度分析了山东省目前和未来可能出现的人口老龄化问题，认为强化社会养老职能是应对未来老龄化问题的必然选择，并就完善社会养老体系提出了几点对策建议．     

Mechanical recyclability of technical biopolymers: Potential and limits

The mechanical recyclability of the technical biopolymers polytrimethylene terephthalate (PTT), cellulose acetate butyrate (CAB), polybutylene succinate (PBS) and polyhydroxy alkanoate blend (PHBV/PBAT) was evaluated by assessing the effect of repeated polymer processing (extrusion without further compounding with virgin material or additives) on the material structure and mechanical properties. Reprocessing-induced hydrolytic degradation was found to be the prevalent aging mechanism of the investigated biopolymer grades. However, susceptibility to hydrolysis, and thus maintenance of the performance characteristics, differed strongly between the biopolymer types. To that effect, PTT and CAB especially exhibit a high potential for mechanical recycling. By taking advantage of appropriate additivation, the mechanical recyclability of PBS and PHBV/PBAT is also assumed to be high.     

弹道明胶老化初级阶段的模型

用流变震荡模式研究了10 wt%浓度的弹道明胶在冷却和等温下的老化行为.对明胶从sol-gel点冷却到某个目标温度的过程,通过不同冷却速率的实验,建了一个弹性模量与温度的线性关系.不同温度下明胶的等温老化实验表明,弹性模量-时间曲线具有相似的形状.依据Normand提出的二级反应动力学模型,引入一个表征明胶老化行为的速率常数,构建了一个预测弹道明胶在老化初级阶段的弹性模量演化的模型.该模型中模量-温度关系在初始和无穷大时是直线,其他模量-温度线是近似直线,并交于sol-gel点.老化速率常数和过冷度之间符合Flory-Weaver方程.对弹性模量和老化时间进行归一化处理,可将不同温度下的老化曲线叠加成一条主曲线.     

Sulfur-Containing Vinyl Monomers. XV. Kinetic Study of Radical Polymerization of Vinyl Mercaptobenzothiazole and Its Copolymerization

A kinetic study of radical polymerization of vinyl mercaptobenzothiazole (VMBT) with α,α′-azobisisobutyonitrile (AIBN) at 60°C was carried out. The rate of polymerization (R_p) was found to be expressed by the rate equation: R_p = k[AIBN]^0.5 [VMBT]^1.0, indicating that the polymerization of this monomer proceeds via an ordinary radical mechanism. The apparent activation energy for overall polymerization was calculated to be 20.9 kcal/mole. Moreover, this monomer was copolymerized with methyl methacrylate, acrylonitrile, vinyl acetate, phenyl vinyl sulfide, maleic anhydride, and fumaronitrile at 60°C. From the results obtained, the copolymerization parameters were determined and discussed.     

Effect of Aging on the Synthesis of Kaolin-Based Zeolite Y from Ahoko Nigeria Using a Novel Metakaolinization Technique

Zeolite Y was systematically synthesized from Ahoko Nigerian kaolin in a conventional hydrothermal system using novel metakaolinization technique. The effect of aging on the formation of zeolite phase was investigated during the course of the synthesis. A rapidly processed metakaolin at a temperature of 600°C and exposure time of 50 minutes, which is capable of reducing the energy and cost of producing it was used to study the synthesis of zeolite Y. It was found that aging conditions play a prominent role in the preparation of zeolite Y from Ahoko metakaolin. Aging played a significant role by increasing the crystallinity of the final product even though zeolite Y was obtain without aging. The outcome of zeolite Y synthesized from Ahoko kaolin in 9 hours at 100°C was different from most reports on the synthesis of zeolite Y from kaolin where longing time (72 hours) of crystallization are reported.