Full counting statistics of transport electrons through a two-level quantum dot with spin–orbit coupling

We study the full counting statistics of transport electrons through a semiconductor two-level quantum dot with Rashba spin–orbit (SO) coupling, which acts as a nonabelian gauge field and thus induces the electron transition between two levels along with the spin flip. By means of the quantum master equation approach, shot noise and skewness are obtained at finite temperature with two-body Coulomb interaction. We particularly demonstrate the crucial effect of SO coupling on the super-Poissonian fluctuation of transport electrons, in terms of which the SO coupling can be probed by the zero-frequency cumulants. While the charge currents are not sensitive to the SO coupling.     

Effect of heat treatment on microstructures and properties of a novel Al-Zn-Mg-Cu alloy for oil drilling

In view of the special requirements for strength, heat resistance and corrosion resistance of Al-Zn-Mg-Cu alloy for oil drilling, the Al-6.2 Zn-2.5 Mg-1.6 Cu alloy was prepared by increasing Cu content on basis of Russian Series 1953 alloy. The effect of heat treatment on the microstructures and properties of the alloy was characterized by optical microscope(OM), scanning electron microscope(SEM) and transmission electron microscope(TEM), and investigated by tensile test at room temperature, thermal exposure test and corrosion test. The results show that the strength after T6 aging treatment exhibit a decrease trend as an increase of the solution temperature from465 °C to 480 °C. After the solution treated by the rate of 470 °C/1 h, second phases dissolve into the matrix very well and the strength property reaches optimum. The alloy has better comprehensive properties treated by a solution treatment of 470 °C/1 h and then followed by an aging treatment of 120 °C/24 h + 170 °C/1 h + 120 °C/24 h. Under the aging state, the precipitated phases inside the grains are suitable in size, while on the grain boundary distribute discontinuously and the precipitate-free zone is obvious. Besides, the alloy still maintain high tensile properties. The yield strength, tensile strength and elongation are 650 MPa, 686 MPa,12.0%, respectively. The yield strength retention after heat exposure is 92%. The alloy has good corrosion resistance and the exfoliation corrosion degree. The average corrosion rate in the H_2S and CO_2 environment is 0.0024 mm/a, which is far less than the required 0.12 mm/a. It is insensitive to H_2S and CO_2 environments.     

Formation of low-temperature deformation-induced segregations of nickel in Fe–Ni-based austenitic alloys

ABSTRACT

The authors present the results of an investigation in Fe–Ni-Cr austenitic alloys of the low-temperature deformation-induced segregations of nickel that form in the micro regions being (i) located close to grain- and subgrain boundaries and (ii) characteristic of the concentration and magnetic inhomogeneities indicated by the appearance of a dark diffraction contrast at the electron diffraction patterns taken from these regions typical (at the same time) of an enhanced value of Curie temperature. The observed effects were connected with the micro distortions caused by the local change of lattice parameter because of an increase in nickel concentration, as well as in the result of a magnetostriction dilatation. Using methods of the X-ray energy dispersive spectroscopy (XEDS) and atomic-probe body-section radiography (tomography – APT) has made it possible to determine the borders of those regions of austenite that were characteristic of an enhanced concentration of nickel in the fields of the localisation of a deformation-induced segregation of nickel in the vicinity of grain (subgrain) boundaries of austenitic alloys of the types Fe–13Cr–30Ni and Fe–37Ni–3Ti.     

Studies on metabolites and metabolic pathways of bulleyaconitine A in rat liver microsomes using LC‐MSn combined with specific inhibitors

Bulleyaconitine A (BLA) from Aconitum bulleyanum plants is usually used as anti‐inflammatory drug in some Asian countries. It has a variety of bioactivities, and at the same time some toxicities. Since the bioactivities and toxicities of BLA are closely related to its metabolism, the metabolites and the metabolic pathways of BLA in rat liver microsomes were investigated by HPLC–MSⁿ. In this research, the 12 metabolites of BLA were identified according to the results of HPLC‐MSⁿ data and the relevant literature. The results showed that there are multiple metabolites of BLA in rat liver microsomes, including demethylation, deacetylation, dehydrogenation deacetylation and hydroxylation. The major metabolic pathways of BLA in rat liver microsomes were clarified by HPLC‐MS combined with specific inhibitors of CYP450 isoforms. As a result, CYP3A and 2C were found to be the principal CYP isoforms contributing to the metabolism of BLA. Moreover, CYP2D6 and 2E1 are also more important CYP isoforms for the metabolism of BLA. While CYP1A2 only affected the formation rate of M11, its effect on the metabolism of BLA is very small. Copyright © 2014 John Wiley & Sons, Ltd.     

激光快速成型TC4合金显微组织及力学性能

采用金相显微镜、扫描电镜、电子拉伸机等，研究了激光快速成型TC4合金沉积态在平行沉积方向和垂直沉积方向的组织和力学性能.结果表明:激光快速成型TC4合金沉积态宏观组织沿沉积方向生长的粗大β柱状晶呈明暗相间的条带状结构，具备典型的魏氏组织特征;垂直沉积方向的强度比平行沉积方向的强度高，但塑性低;合金断口为韧窝状断口，垂直沉积方向的断口韧窝尺寸比平行沉积方向的小.     

Development and validation of a reversed‐phase HPLC method for CYP1A2 phenotyping by use of a caffeine metabolite ratio in saliva

CYP1A2 is important for metabolizing various clinically used drugs. Phenotyping of CYP1A2 may prove helpful for drug individualization therapy. Several HPLC methods have been developed for quantification of caffeine metabolites in plasma and urine. Aim of the present study was to develop a valid and simple HPLC method for evaluating CYP1A2 activity during exposure in xenobiotics by the use of human saliva. Caffeine and paraxanthine were isolated from saliva by liquid‐liquid extraction (chlorophorm/isopropanol 85/15v/v). Extracts were analyzed by reversed‐phase HPLC on a C₁₈ column with mobile phase 0.1% acetic acid/methanol/acetonitrile (80/20/2 v/v) and detected at 273nm. Caffeine and paraxanthine elution times were <13min with no interferences from impurities or caffeine metabolites. Detector response was linear (0.10–8.00µg/ml, R²>0.99), recovery was >93% and bias <4.47%. Intra‐ and inter‐day precision was <5.14% (n=6). The limit of quantitation was 0.10µg/ml and the limit of detection was 0.018±0.002µg/mL for paraxanthine and 0.032±0.002µg/ml for caffeine. Paraxanthine/caffeine ratio of 34 healthy volunteers was significantly higher in smokers (p<0.001). Saliva paraxanthine/caffeine ratios and urine metabolite ratios were highly correlated (r=0.85, p<0.001). The method can be used for the monitoring of CYP1A2 activity in clinical practice and in studies relevant to exposure to environmental and pharmacological xenobiotics. Copyright © 2015 John Wiley & Sons, Ltd.     

出口商品结构优化的多元统计分析法及应用

探讨了出口商品结构优化的多元统计分析法及应用,并通过示例说明了该方法在出口商品结构优化中的应用。     

铅锡合金沉积物的显微组织

将离子浓度比为5∶5的铅锡电沉积分形生长沉积物制备成金相样品，用金相显微镜观察了它们的显微组织。结果表明，在此情况下，铅锡电沉积生成物由两相组成，即铅锡共晶相和铅基固溶相，两相呈交替层状分布。     

Reducing systems of linear differential equations to a passive form

In this paper, an application of the Riquer-Thomas-Janet theory is described for the problem of transforming a system of partial differential equations into a passive form, i.e., to a special form which contains explicitly both the equations of the initial system and all their nontrivial differential consequences. This special representation of a system markedly facilitates the subsequent integration of the corresponding differential equations. In this paper, the modern approach to the indicated problem is presented. This is the approach adopted in the Knuth-Bendix procedure [13] for critical-pair/completion and then Buchberger's algorithm for completion of polynomial ideal bases [13] (or, alternatively, for the construction of Groebner bases for ideals in a differential operator ring [14]). The algorithm of reduction to the passive form for linear system of partial differential equations and its implementation in the algorithmic language REFAL, as well as the capabilities of the corresponding program, are outlined. Examples illustrating the power and efficiency of the system are presented.     

Dielectric and optical properties of polymer-liquid crystal composite

Dielectric properties of polymer-liquid crystal mixture, having constituent polymer, poly-butyl methacrylate (PBMA) and liquid crystal, cholesteryl nonanoate, are reported as a function of frequency and temperature. The measurement has been done in a temperature range of 300-375 K and frequency range of 100 Hz-10 MHz. The dielectric permittivity and dielectric loss shows significant changes with the addition of polymer molecules in liquid crystal. The significant feature of composite formation is that the pure liquid crystal and polymer do not show dielectric relaxation in the frequency range covered, while the composite shows relaxation peak at a particular frequency. The optical transmittance of pure liquid crystal and composite has also been measured and compared.