A Complexing Agent to Enable a Wide-Temperature Range Bromine-Based Flow Battery for Stationary Energy Storage

Bromine-based flow batteries (Br-FBs) are considered one of the most promising energy storage systems due to their features of high energy density and low cost. However, they generally suffer from uncontrolled diffusion of corrosive bromine particularly at high temperatures. That is because the interaction between polybromide anions and the commonly used complexing agent (N–methyl–N–ethyl–pyrrolidinium bromide [MEP]) decreases with increasing temperatures, which causes serious self-discharge and capacity fade. Herein, a novel bromine complexing agent, 1–ethyl–2–methyl–pyridinium bromide (BCA), is introduced in Br-FBs to solve the above problems. It is proven that BCA can combine with polybromide anions very well even at a high temperature of 60 °C. Moreover, the BCA contributes to decreasing the electrochemical polarization of Br⁻/Br₂ couple, which in turn improves their power density. As a result, a zinc–bromine flow battery with BCA as the complexing agent can achieve a high energy efficiency of 84% at 40 mA cm⁻², even at high temperature of 60 °C and it can stably run for more than 400 cycles without obvious performance decay. This paper provides an effective complexing agent to enable a wide temperature range Br-FB.     

大口径宽视场双波段扫描红外相机光学设计

通过分析计算,设计了一种大口径宽视场折射式红外相机光学系统。该系统设计用于超长线阵扫描红外相机的地面演示成像,它能同时对短波2μm—3μm、中波3μm—4.5μm双波段成像,且同时具有24°的大视场和150mm的宽口径,成像质量接近衍射极限。该系统在航天遥感领域应用广泛。     

Wide‐angle X‐ray diffraction and differential scanning calorimetry study of the crystallization of poly(ethylene naphthalate), poly(butylene naphthalate), and their copolymers

The crystallization behavior of a series of poly(ethylene‐co‐butylene naphthalate) (PEBN) random copolymers was studied. Wide‐angle X‐ray diffraction (WAXD) patterns showed that the crystallization of these copolymers could occur over the entire range of compositions. This resulted in the formation of poly(ethylene naphthalate) or poly(butylene naphthalate) crystals, depending on the composition of the copolymers. Sharp diffraction peaks were observed, except for 50/50 PEBN. Eutectic behavior was also observed. This showed isodimorphic cocrystallization of the PEBN copolymers. The variation of the enthalpy of fusion of the copolymers with the composition was estimated. The isothermal and nonisothermal crystallization kinetics were studied. The crystallization rates were found to decrease as the comonomer unit content increased. The tensile properties were also measured and were found to decrease as the butylene naphthalate content of the copolymers increased. For initially amorphous specimens, orientation was proved by WAXD patterns after drawing, but no crystalline reflections were observed. However, the fast crystallization of drawn specimens occurred when they were heated above the glass‐transition temperature. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 843–860, 2004     

微波宽频带功率负载的研究

介绍了５００Ｗ宽频带功率负载的设计及实验结果，并将研究成果扩展到１０～１０００Ｗ范围。负载主要技术指标：输入阻抗５０Ω，频带宽度０～１０００ＭＨｚ，电压驻波比≤１．１．表面最高温升△ｔ≤１００℃。     

高阻带抑制有源声表面波滤波组件

介绍有源声表面波滤波组件的设计思路。报道最新研制的高性能滤波组件，其中心频率４０ＭＨｚ，３ｄＢ相对带宽０．８％，阻带抑制优于１００ｄＢ，矩形系数（Δｆ１００ｄＢ／Δｆ３ｄＢ）小于３，输入输出端口电压驻波比接近１。组件体积８５ｍｍ×３５ｍｍ×２４ｍｍ，重量小于１１５ｇ     

CCD摄像机大视场光学镜头的设计

为提高CCD摄像机的成像质量，同时使镜头结构紧凑、小型化，在大视场光学镜头的设计中，引入标准二次曲面和偶次非球面。根据初级像差理论，分析了非球面的位置、初始结构参数的求解规律。通过理论计算和ZEMAX光学设计软件的优化，给出工作波长为0.4～0.7μm、全视场角为80°，相对孔径为1∶1.5的镜头设计实例。该镜头由7块镜片组成，包括一个标准二次曲面和两个8次方非球面；在40lp/mm空间频率处的MTF值超过0.85，全视场畸变小于3％，像质优良     

一种应用于HDMI接收端的宽频带锁相环设计

基于110 nm CMOS工艺设计了一种应用于HDMI接收端电路的宽频带低抖动锁相环。采用一种改进型双环结构电荷泵,在25～250 MHz的宽输入频率范围内实现了快速锁定。通过高相噪性能的伪差分环形振荡器产生了调谐范围为125 MHz～1.25 GHz的时钟信号。仿真实验结果表明,该锁相环的锁定时间小于1.2μs,在振荡器工作频率为0.8 GHz时,其相位噪声为-100.0 dBc/Hz@1 MHz,输出时钟峰峰值抖动为4.49 ps。     

一种变压器巴伦馈电的超短波紧耦合阵列天线

紧耦合阵列天线(Tightly Coupled Array, TCA)具有超宽带、低剖面、宽角扫描等特点,近年来受到国内外学者的广泛关注。然而,在甚高频(VHF)、特高频(UHF)频段TCA 由于馈电网络设计困难等原因现有的研究报道很少。为了填补这一空白,本文设计并测试了一款变压器巴伦馈电的TCA,利用变压器巴伦解决了单元平衡馈电困难问题,同时采用短路枝节抑制E面共模谐振,采用频率选择表面(FSS)匹配层改善宽角扫描阻抗匹配。实测结果表明,该天线在110~520 MHz 频带内、±40°扫描角范围内电压驻波比<2.5,和仿真结果吻合。     

Minimizing Energy Barrier in Intermediate Connection Layer for Monolithic Tandem WPeLEDs with Wide Color Gamut

Perovskite light-emitting diodes (PeLEDs) show promising prospects in the wide color gamut display owing to their ultra-narrow full width at half maximum (FWHM). However, up to now, all perovskite white LEDs integrated by standard red, green, and blue perovskite emitters, namely, monolithic white PeLEDs (WPeLEDs), have been rarely reported, owing to facing some issues, e.g., solvent incompatibility in solution technique, ion exchange, and energy transfer between different emission centers. Herein, centered on these issues, an optimal intermediate connection layer (ICL) of Po-T2T/LiF/Ag/HAT-CN/MoO₃ is adopted to successfully develop monolithic tandem multicolor PeLEDs and WPeLEDs for the first time. The multicolor PeLEDs can achieve the best external quantum efficiency of 1.8% and the highest luminance of 4844 cd m⁻². Besides, the red/green/blue (R/G/B) monolithic tandem WPeLED shows a standard white International Commission on Illumination coordinate of (0.33, 0.33) and achieves an extremely wide color gamut reaching  National Television Standards Committee of 130%. This study is the first to realize the standard R/G/B co-electroluminescence in a monolithic perovskite device and offers a feasible strategy for developing wide-color gamut perovskite displays.     

Untersuchungen an Hydriden im Bereich der Phase Ti2CO1—x Fe x (x=0–0,5)

The hydrogen absorption of the phase Ti₆₄Co_32–x Fe _x (x=0...16) and its influence on the magnetic properties have been investigated. Measurements of the vapour-pressure, wide-line NMR and magnetic susceptibility have been performed. Substitution of Co by Fe does not change the amount of absorbed hydrogen. However the reaction rate of hydriding process, the activation energy of diffusion and the magnetic quantities change upon this substitution.