Unipolar conductivity of donor or acceptor solutions

Donor or acceptor compounds in apolar organic solvents become charged at a high-field strength electrode and are driven to a surrounding low-field strength electrode of opposite sign. At 10 kV per cm the solutions conduct 3–7 times better when the highly charged electrode is positive in donor solutions. The opposite situation occurs in acceptor solutions.     

基于80C196MC的单极性SPWM的实现

研究了利用80C196MC单片机的波形发生器和一定的外围电路产生单极性SPWM(正弦脉宽调制)信号的方法。利用IR2130驱动器作为栅极驱动器,驱动用IGBT(绝缘栅双极晶体管)组成的单相H桥。对比了单极性SPWM相对于双极性SPWM的优点,阐述了其实现的基本原理,给出了具体的主电路和控制电路及程序实现的流程,分析了IR2130应用中的具体问题,最后给出了一种简单的减小过零点失真的方法。     

A High Efficiency,High Throughput Unipolar Aerosol Charger for Nanoparticles

A novel aerosol charger has been developed, which has high efficiency and high throughput especially for nanometer particles in the size range of 3–50nm. Unipolar charging with high ion concentration and long charging time is used to obtain the high charging efficiency. High throughput is achieved by reducing particle loss within the charger. This is accomplished by directing ion flow and aerosol flow in the same direction and by the use of sheath air flow. The charger configuration is of a longitudinal design – the direction of aerosol stream and ion stream are flowing parallel along the longitudinal axis of the charger. The charger consists of four sections: the inlet zone, the ion production zone, the unipolar charging zone, and the exit zone. In the inlet and ion production zones, unipolar ions are generated using Po²¹⁰ radioactive sources with an electric field designed to separate the positive and negative ions, and to focus the selected unipolar ions into the core region of the charger. The ions with the selected polarity is then attracted to the charging zone by an uniform electric field created by a series of ring electrodes applied with a linear ramped voltage. Aerosol entering the charger is sheathed with clean gas flow in order to keep the aerosol in the core region. A novel exit design with a reversed electric field is incorporated in order to minimize the charged particles loss. The performance of the charger is first evaluated using computer simulation and then constructed for experimental validation. Experiment data have demonstrated that the charger achieves 90% and 95% charged-particles penetration efficiency and with 22% and 48% extrinsic charging efficiency at 3 and 5nm particle sizes, respectively. These performance data represent significant improvement, over a factor of 10, compared with the existing chargers.     

MOS 场引晶体管双极理论和实验

提出场引晶体管双极理论.替代已55年久,1952 Shockley发明单极理论.解释近来双栅纳米硅MOS晶体管实验特性--两条电子和两条空穴表面沟道,同时并存.理算晶体管输出特性和转移特性,包括实用硅基及栅氧化层厚度.理算比较最近报道实验,利用硅FinFET,含(金属/硅)和(p/n)结,源和漏接触.实验支持双极理论.建议采用单管,实现CMOS倒相电路和SRAM存储电路.     

Structural characteristics and residual stresses in oxide films produced on Ti by pulsed unipolar plasma electrolytic oxidation

Oxide films, 7–10 µm thick, were produced on commercially pure titanium by plasma electrolytic oxidation in a sodium orthophosphate electrolyte using a pulsed unipolar current with frequency (f) and duty cycle (δ) varying within f = 0.1–10 kHz and δ = 0.8–0.2, respectively. The coatings comprised a mixture of an amorphous phase with nanocrystalline anatase and rutile phases, where the relative rutile content range was 17–25 wt%. Incorporation of phosphorus from the electrolyte into the coating in the form of PO₂ ^–, PO₃ ^2– and PO₄ ^3–, as demonstrated by EDX and FT-IR analyses, contributed to the formation of the amorphous phase. Residual stresses associated with the crystalline coating phase constituents were evaluated using the X-ray diffraction sin² ψ method. It was found that, depending on the treatment parameters, internal direct and shear stresses in anatase ranged from–205 (±17) to–431 (±27) MPa and from–98 (±6) to–145 (±10) MPa, respectively, whereas the rutile structure is comparatively stress-free.     

基于TMS320F28335的单极性SPWM的实现

文中介绍了应用高性能数字信号处理器（DSP）TMS320F28335输出正弦波的原理和方法,其中详细介绍了借助28335内部的正弦脉宽调制（EPWM）模块输出单臂／双臂斩波、带／不带同臂互补的四种驱动信号的方法,最后搭建实验平台对理论分析和仿真结果进行验证,实验结果表明利用该控制器的逆变系统可以输出满足工程需要的50Hz正弦波。     

Dependence of the Intensity of the Spectral Lines and the Composition of the Sample and the Plasma Parameters of the Unipolar Arc

The investigation was made of the dependence of the intensity of Tl, Ga, Mo, Mg, Mn, Sn, Bi, Ni, Zn, Pt and Au spectral lines and the plasma parameters (temperature T, electron concentration n_e, degree of 6 ionnization α) from concentration of lithium additive.     

Out-of-Plane Resistance Switching of 2D Bi2O2Se at the Nanoscale

Two-dimensional (2D) bismuth oxyselenide (Bi₂O₂Se) with high electron mobility shows great potential for nanoelectronics. Although the in-plane properties of Bi₂O₂Se have been widely studied, its out-of-plane electrical transport behavior remains elusive, despite its importance in fabricating devices with new functionality and high integration density. Here, the out-of-plane electrical properties of 2D Bi₂O₂Se at nanoscale are revealed by conductive atomic force microscope. This work finds that hillocks with tunable heights and sizes are formed on Bi₂O₂Se after applying a vertical electric field. Intriguingly, such hillocks are conductive in the vertical direction, resulting in a previously unknown out-of-plane resistance switching in thick Bi₂O₂Se flakes while ohmic conductive characteristic in thin ones. Furthermore, the transformation is observed from bipolar to stable unipolar conduction in thick Bi₂O₂Se flake possessing such hillocks, suggesting its potential to function as a selector in vertical devices. This work reveals the unique out-of-plane transport behavior of 2D Bi₂O₂Se, providing the basis for fabricating vertical devices based on this emerging 2D material.     

A Hybrid Metaheuristic Based on Neurocomputing for Analysis of Unipolar Electrohydrodynamic Pump Flow

A unipolar electrohydrodynamic (UP-EHD) pump flow is studied with known electric potential at the emitter and zero electric potential at the collector. The model is designed for electric potential, charge density, and electric field. The dimensionless parameters, namely the electrical source number (Es), the electrical Reynolds number (ReE), and electrical slip number (Esl), are considered with wide ranges of variation to analyze the UP-EHD pump flow. To interpret the pump flow of the UP-EHD model, a hybrid metaheuristic solver is designed, consisting of the recently developed technique sine–cosine algorithm (SCA) and sequential quadratic programming (SQP) under the influence of an artificial neural network. The method is abbreviated as ANN-SCA-SQP. The superiority of the technique is shown by comparing the solution with reference solutions. For a large data set, the technique is executed for one hundred independent experiments. The performance is evaluated through performance operators and convergence plots.     

PWM功率放大器在直流伺服系统中的应用

介绍了PWM功率放大器的基本概念和分类,详细说明了H型双极可逆PWM系统的工作原理及其与单极、受限单极的区别。研制了基于智能功率模块PM75CES060的H型可逆PWM功率放大器,实验结果表明该系统具有高可靠性和较好的实用价值。