用横波推导简谐波的能量

本文提出用横波推导简谐波能量的方法，并就此进行了具体时推导。     

An unflexural refined model of deformation of multilayered plates on an undeformable foundation

The stress-strain state of multilayered plates on an undeformable foundation is investigated. The design diagram of a transversely loaded plate is formed by supplementing it with a symmetric one about the contact surface of the foundation. The double-thickness plate obtained becomes loaded bilaterally and symmetrically about its midsurface. In such a way, only unflexural deformations can be modeled, which reduces the number of unknowns and the general order of differentiation of the resolving system of equations. The refined continual model developed takes into account the deformations of transverse shear and transverse compression in high iterative approximations. The cases of a rigid contact between the foundation and the plate and frictionless slip of the plate over the foundation are considered. Calculations confirm the efficiency of such an approach, which allows one to obtain solutions qualitatively and quantitatively close to three-dimensional ones. __________ Translated from Mekhanika Kompozitnykh Materialov, Vol. 42, No. 5, pp. 643–654, September–October, 2006.     

二极管激光侧泵浦单横模100Hz电光调Q激光器

介绍了二极管激光侧泵浦单横模１００Ｈｚ电光调Ｑ激光器的实验结果。泵浦源为一个线阵准连续１００Ｗ二极管激光器，激光工作介质为ＮｄＹＡＧ薄梯形板条，板条与泵浦源间用柱透镜耦合，ＫＤ＊Ｐ电光晶体调Ｑ。在１００Ｈｚ重复频率下，获得单脉冲能量２．３７ｍＪ，脉宽小于７ｎｓ，光束质量因子Ｍ２＝１．１的１．０６μｍ激光，光－光效率为８．５％，斜效率为１８．７％。     

厄米-双曲余弦-高斯光束的瞄准稳定性

用失调叠加积分的方法 ,对厄米双曲余弦高斯光束的瞄准稳定性作了研究 ,得到了厄米双曲余弦高斯光束失调因子 ηm2 的精确解析公式和近似解析公式 ,并用数值计算了相对横向偏移和相对角向偏移对失调因子ηm2 的影响以及对精确解析公式和近似解析公式的适用范围作了分析和说明。     

Operational characteristics and power scaling of a transverse flow transversely excited CW CO<Subscript>2</Subscript> laser

Transverse flow transversely excited (TFTE) CO₂ lasers are easily scalable to multikilowatt level. The laser power can be scaled up by increasing the volumetric gas flow and discharge volume. It was observed in a TFTE CW CO₂ laser having single row of pins as an anode and tubular cathode that the laser power was not increasing when the discharge volume and the gas volumetric flow were increased by increasing the electrode separation keeping the gas flow velocity constant. The discharge voltage too remained almost constant with the change of electrode separation at the same gas flow velocity. This necessitated revision of the scaling laws for designing this type of high power CO₂ laser. Experimental results of laser performance for different electrode separations are discussed and the modifications in the scaling laws are presented.     

部分子相互作用与(S_(NN))~(1/2)=130GeV Au-Au碰撞中两粒子的横向动量关联(英文)

采用蒙特卡罗模型AMPT 究了(S_(NN))~(1/2)=130GeV Au Au碰撞中部分子相互作用对两粒子横向动量关联的影响,结果表明部分子相互作用对两粒子的横向动量关联有重要的贡献．还计算了AMPT模型中(S_(NN))~(1/2)=130GeV Au Au碰撞的两粒子横向动量关联与碰撞对心性的依赖关系并与来自STAR的实验数据进行了比较,发现AMPT的理论预言很好地符合实验数据．     

LD泵浦的Nd∶YAG腔内倍频激光器及其模式

用KTP晶体研制成LD泵浦的YAG腔内倍频激光器,得到0.532μm连续绿色线偏振激光输出,阈值泵浦功率为41mW,输出功率为1.4mW,斜效率为1.7％。研究了泵浦光对倍频激光横模的影响。     

Novel simulated moving-bed adsorber for the fractionation of gas mixtures

The separation of propylene-propane mixture is an energy intensive operation commercially practiced using cryogenic distillation. The separation by pressure swing adsorption has been studied as an alternative. A fixed-bed pressure swing adsorption yields the heavy component as a pure product. The product recovery and the productivity are not high. In a moving-bed process, because of the counter-current solid-gas contact, the separation achieved is similar to that of the fractionation by distillation. Although the moving-bed operation offers the upper limit for the performance of a cyclic adsorptive process, due to mechanical complexities in the handling of solids the 'simulated' moving-bed is preferred. By moving the inlet and outlet ports of streams located along the length of the bed, a moving-bed process can be realized in a fixed bed. We describe here a 'moving-port' system which permits injection or withdrawal of the fluid along the axial direction in a fixed bed. A fixed bed embedded with the moving-port systems emulates a simulated moving-bed adsorber. The proposed adsorber can fractionate a binary gas mixture into two product streams with high purities. It is similar to the Sorbex process of UOP but does not have the eluent as an additional separating agent. A parametric study indicates that high purity products and a higher productivity by an order of magnitude can be achieved with simulated moving-beds compared to the fixed beds.     

Effect of Enzyme Modification of Corn Grits on their Properties as an Adsorbent in a Skarstrom Pressure Swing Cycle Dryer

Corn grits have been tested as a desiccant in a pressure swing adsorption (PSA) system to produce dry air. Two sizes of unmodified corn grits were tested in the PSA system: 2.16 and 0.978 mm in diameter, which dried moist air to dew points of –42°C and –69°C, respectively. A modification technology has been developed for the corn grits that gives an increase in the operational adsorptive capacity in a pressure swing adsorption system, so that they remove as much moisture from air as molecular sieves at the same conditions. After modification, 2.16 mm corn grits dry moist air to a –56°C dew point and the 0.978 mm corn grits dry air to a –80°C dew point. The modification process creates surface modifications on the corn grits apparently making more adsorption sites easily available. The modification procedure increases the specific surface area of the grits and possibly decreases the crystallinity, which would make more hydroxyl groups available for adsorption of water. Possible applications of using corn grits in the pressure swing adsorption system include industrial gas dryers, sorptive cooling air conditioners, and recycling equipment for industrial solvents.     

Mathematical Modeling of Multicomponent Nonisothermal Adsorption in Sorbent Particles Under Pressure Swing Conditions

A detailed model for nonisothermal sorption of multicomponent mixtures in a single sorbent particle (monodisperse or bidisperse with negligible intracrystalline mass transport limitations) under pressure swing conditions is developed in this study. The dusty-gas model is used to describe the coupling of the molar fluxes, the temperature, the partial pressures and the partial pressure gradients of the components in the pore space of the particle. The variations of the temperature are described by an energy equation in which both convective and conductive modes of heat transport are accounted for. No limitations are imposed on the number of the components in the mixture and on the type of the adsorption isotherm. The model is applied in the investigation of the industrially important air-zeolite 5A system. Two cases with respect to the surrounding gas phase are examined: infinite environment, which is representative for single particle experiments, and finite environment, which is representative for the situation in packed bed adsorbers. It is found that in an infinite environment the external and internal temperature gradients are equally important while in a finite environment the external heat transport limitations are negligible. It is concluded that in modeling the nonisothermal operation of adsorption processes occurring in packed beds it is not necessary to allow for the temperature differences between the gas phase and the surface of the adsorbing particles. Furthermore, if the temperature gradients within the particles can be neglected, only a single temperature equation is needed to describe the energy transport in the bed.