Logarithmic Regge pole

This work presents the subtraction procedure and the Regge cut in the logarithmic Regge pole approach. The subtraction mechanism leads to the same asymptotic behavior as previously obtained in the non-subtraction case. The Regge cut, in contrast, introduces a clear role to the non-leading contributions for the asymptotic behavior of the total cross-section. From these results, some simple parameterization is introduced to fit the experimental data for the proton-proton and antiproton-proton total cross-section above some minimum value up to the cosmic-ray. The fit parameters obtained are used to present predictions for the \begin{document}$ \rho(s)$\end{document} -parameter as well as to the elastic slope \begin{document}$ B(s)$\end{document} at high energies.     

A Symbolic Pole/Zero Extraction Methodology Based on Analysis of Circuit Time-Constants

This paper introduces a methodology for symbolic pole/zero extraction based on the formulation of the time-constant matrix of the circuits. This methodology incorporates approximation techniques specifically devoted to achieve an optimum trade-off between accuracy and complexity of the symbolic root expressions. The capability to efficiently handle even large circuits will be demonstrated through several practical circuits.     

薄膜磁头磁轭制备工艺研究

本文重点讨论了用不同的工艺方法来制备薄膜磁头中的关键元件-磁轭。采用多次光刻的方法克服湿法工艺中磁性膜NiFe层的侧向钻蚀问题，从而实现对磁轭几何尺寸的精确控制，并对几种工艺方法的优缺点作了比较详细的分析。     

电流模式n阶传输函数的OA-OTA实现

提出了一种新的实现任意 n阶电流模式传输函数的网络结构。该电路仅含运算放大器 (OA)和运算跨导放大器 (OTA)有源器件 ,因而适于全集成。适当设置 OTA的跨导值能实现任意高阶传输函数 ,且传输函数的系数可独立调整。文中推导了滤波器的设计公式 ,并给出了截止频率为 1 0 0 k Hz的三阶巴特沃斯低通滤波器实例 ,PSPICE仿真结果表明所提电路及设计公式是正确的     

The asymptotic behavior of queueing systems: Large deviations theory and dominant pole approximation

This paper presents the exact asymptotics of the steady state behavior of a broad class of single-node queueing systems. First we show that the asymptotic probability functions derived using large deviations theory are consistent (in a certain sense) with the result using dominant pole approximations. Then we present an exact asymptotic formula for the cumulative probability function of the queue occupancy and relate it to the cell loss ratio, an important performance measure for service systems such as ATM networks. The analysis relies on a new generalization of the Taylor coefficients of a complex function which we call characteristic coefficients. Finally we apply our framework to obtain new results for the M/D/1 system and for a more intricate multiclass M/D/n system.     

FRS-XRSA表征双轴取向聚对苯二甲酸乙二酯薄膜的取向分布

Ｘ－射线散射理论分析（ＦＲＳ－ＸＲＳＡ）是作者为了研究和表征取向高聚物结晶度与晶粒取向分布（ＯＤＣ）的一种新方案．在表征ＯＤＣ方面应用分峰法（ＣＰＲ）消除了传统极图法（ＰＦＭ）中高重叠峰相互干扰的困难，克服了取向分布函数分析（ＯＤＦＡ）中出现虚织构的困难，并且经一次系统的ＦＲＳ－ＸＲＳ测定，可以得到几乎所有主要（ｈｋｌ）晶面法向的ＯＤＣ．作者应用ＦＲＳ－ＸＲＳＡ对二类双轴取向ＰＥＴ磁带薄膜进行了ＯＤＣ的研究。基于结晶几何学原理（ＣＧＰ），建立了三斜晶系晶粒坐标系与试样坐标系的关系，并用于推演未测定方位角（αｉ，βｉ）（ｈｋｌ）的晶面散射以及未测（ｈ′ｋ′ｌ′）晶面的ＯＤＣ．作者关系建立了双轴取向函数〈ｃｏｓ２φｈｋｌ，ｉ〉，ｉ＝Ｎ、Ｍ、Ｔ的计算公式．按照ＦＲＳ－ＸＲＳＡ获得了反映取向分布的１０个晶面的双轴极图、三个主晶面（１００）、（０１０）、（１０５）的总极图，以及反映平均取向的各种取向函数，如〈ｃｏｓ２φｈｋｌ，ｉ〉、ｆｃｈｋｌ，ｉ等，结果十分令人满意．     

Crystalline orientation of the InN films prepared by atmospheric pressure halide chemical vapor deposition

The structural analysis of the hexagonal InN film prepared on a Si(100) substrate by the AP-HCVD technique using InCl₃ and NH₃ as starting materials were carried out by the X-ray pole figure analysis. The deposited films consist of the hexagonal InN pillar crystals. It was found that the pillar crystals, which have random rotation around the 100 axis, were grown at an angle of 70–90° to the substrate.     

X波段同轴腔多注速调管的研究

开展了具有同轴谐振腔互作用电路和双模工作杆控电子枪的X波段同轴腔双模多注速调管的研究工作.结合数值计算和冷测实验,对工作于TM₃₁₀高次模的同轴谐振腔模式分布和特性参数进行研究,获得了可满足多注速调管要求的谐振腔特性阻抗和良好的模式稳定性.采用具有双控制极的新型杆控多注电子枪及电子光学系统,可使多注速调管具有双模的新工作特性,通过数值模拟获得了优化的几何参数和具有良好层流性和波动性的空心多电子注.对采用6个电子注和5个谐振腔的X波段多注速调管进行了注波互作用大信号计算,结果表明当电子注电压为21.5kV,脉冲电流为14.4A时,可在30MHz频带范围内获得的100kW左右的脉冲输出功率,互作用效率大于30%,增益大于36dB.     

前缀码与极大前缀码的一种新刻画

在语言图Γ(X*)概念的基础上,用新引入的语言竹竿l(X*)和语言竹竿集L(X*)的概念形象地刻画了前缀码与极大前缀码:A是前缀码l(X*)∈L(X*),S_l_((X*))∩A或为单点集或为Φ;A是极大前缀码l(X*)∈L(X*),i)S_(l(X*))∩A或为单点集或为Φ.ii)S_(l(X*))∩A=Φ■u∈S_(l(X*)),■a∈A,ω∈X~+使a=uw.     

基于极点优化配置的发动机空燃比控制器设计

针对燃油发动机的燃油油膜动力学子系统,以发动机的空燃比精确控制为最终目标,采用基于状态空间模型的极点配置方法设计控制器.为确定适当的目标极点,提出根据主导极点概念,利用坐标轮换法搜索最优参数,从而确定目标极点的方法.最后通过仿真实验,验证所提出方法有较好的空燃比控制效果,为空燃比精确控制提供了一种新的思路.