煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

大气状态下AFM阳极氧化加工Si的研究

Si纳米氧化线是构筑基于Si的纳米器件的基础。通过AFM针尖诱导阳极氧化加工的n型Si(100)的实验得到凸出的n型Si(100)氧化物高度和偏置电压成线性关系,与针尖扫描速度成负对数关系,并在前人的基础上深化了AFM针尖诱导氧化加工的机理和理论模型,得到了合适的加工条件为偏压8 V和扫描速度1μm/s。     

Germanium growth on Br-terminated Si(1 0 0)

The consequences of Ge deposition on Br-terminated Si(1 0 0) were studied with scanning tunneling microscopy at ambient temperature after annealing at 650 K. One monolayer of Br was sufficient to prevent the formation of Ge huts beyond the critical thickness of 3 ML. This is possible because Br acts as a surfactant whose presence lowered the diffusivity of Ge adatoms. Hindered mobility was manifest at low coverage through the formation of short Ge chains. Further deposition resulted in the extension and connection of the Ge chains and gave rise to the buildup of incomplete layers. The deposition of 7 ML of Ge resulted in a rough surface characterized by irregularly shaped clusters. A short 800 K anneal desorbed the Br and allowed Ge atoms to reorganize into the more energetically favorable “hut” structures produced by conventional Ge overlayer growth on Si(1 0 0).     

Electrical and growth characteristics of Au/Al0.15Ga0.85N:Si structures with various Si incorporations

We have investigated the growth characteristics of n-Al_0.15Ga_0.85N:Si/GaN and the electronic properties of Au/n-Al_0.15Ga_0.85N:Si diode structures grown by metal-organic chemical vapor deposition (MOCVD) with various Si incorporations. The Al_0.15Ga_0.85N:Si layers were grown on undoped GaN/sapphire (0001) epitaxial layers in a horizontal MOCVD reactor at the reduced pressure of 300 torr. The mirrorlike surface, free of defects, such as cracks or hillocks, can be seen in the undoped Al_0.15Ga_0.85N epilayer, which was grown without any intentional flow of SiH₄. However, many cracks are observed in the n-Al_0.15Ga_0.85N:Si, which was grown with Si incorporation above 1.0 nmol/min. While Au/n-Al_0.15Ga_0.85N:Si diodes having low incorporation of Si showed retively good rectifying behavior, the samples having high Si incorporation exhibited leaky current-voltage (I-V) behavior. Particularly, the Au/n-Al_0.15Ga_0.85N:Si structure grown with Si incorporation above 1.0 nmol/min cannot be used for electrical rectification. Both added tunneling components and thermionic emission influence the current transport at the Au/n-Al_0.15Ga_0.85N:Si barrier when Si incorporation becomes higher.     

Si基膜片型气敏传感器微结构单元的热学性能

微结构气敏传感器由于其微型化、低功耗、易阵列化和易批量生产等优点而受到国内外研究者的广泛关注。利用微机电系统（MEMS）加工技术，制备Si基膜片型微结构单元，并分析其热学性能。这种单元工作区温度为-300℃时，加热功率约75mW；并且膜片工作区的热质量很小，温度可以于毫秒量级的时间内，在室温和450℃之间调制。利用这种微结构单元，可以在温度调制方式下，研究气敏薄膜的电学特性和敏感机理。     

Monte Carlo study of interfacial silicon suboxide layers and oxidation kinetics

A simple simulation scheme that simultaneously describes the growth kinetics of SiO₂ films at the nanometer scale and the SiO_x/Si interface dynamics (its extent, and spatial/temporal evolution) is presented. The simulation successfully applies to experimental data in the region above and below 10 nm, reproduces the Deal and Grove linear-parabolic law and the oxide growth rate enhancement in the very thin film regime (the so-called anomalous region). According to the simulation, the oxidation is governed mainly by two processes: (a) the formation of a transition suboxide layer and (b) its subsequent drift towards the silicon bulk. We found that it is the superposition of these two processes that produces the crossover from the anomalous oxidation region behavior to the linear-parabolic law.     

The glow curve structure for the LiF:Mg,Cu,Na,Si TL detector with dopants concentrations and sintering temperatures

The glow curve structures for LiF:Mg,Cu,Na,Si TL detectors with various dopant concentrations and sintering temperatures were investigated for the improvement of the glow curve structure and sensitivity of the TL detector. The dopant concentrations were varied over the following ranges: Mg (0–0.25 mol%), Cu (0–0.07 mol%), Na and Si (0–1.5 mol%). With increasing Cu concentration, the intensity of the main peak was intensified and reached a maximum at a concentration of 0.05 mol%. The high-temperature peak was reduced. The dependency of the main peak intensity on the Mg concentration exhibits a sharp maximum at 0.2 mol%. The intensity of the high-temperature peak tends to rise slightly with increasing Mg concentration. It was found that the optimum concentrations of the dopants in the LiF:Mg,Cu,Na,Si TL material are Mg: 0.2 mol%, Cu: 0.05 mol%, Na and Si: 0.9 mol%. The dependency of the main peak intensity on sintering temperature exhibits a very sharp maximum at 830°C. The high-temperature peak was rapidly reduced after 825°C.     

步进扫描时间分辨光谱及其在太阳电池光电导上的应用

建立傅里叶变换步进扫描时间分辨光电导光谱，并研究太阳电池中与转换效率密切相关的少数载流子寿命.实验选取三种典型的硅太阳电池(单晶硅样品1、多晶硅样品2和多晶硅样品3 )，发现其瞬态光电导的上升和衰退曲线可以分别用两个简单的指数函数描述.由于有复合中心的参与，复合过程中少数载流子的寿命比产生过程中的寿命短.为验证实验结果的可靠性，采用了提取样品少数载流子的体寿命和计算其有效扩散长度两种方法.通过与太阳电池暗伏安特性和负载特性研究相结合，进一步分析和讨论了少数载流子寿命与短路电流、开路电压和转换效率的关系.同时探讨了步进扫描时间分辨光谱实验的其他用途. 关键词： 步进扫描 时间分辨 硅太阳电池 瞬态光电导     

硅光电二极管激光损伤阈值随激光脉宽的变化

 对飞秒激光辐照下硅光电二极管损伤阈值进行了实验测量，对从1s到60fs不同脉宽激光辐照下硅光电二极管损伤阈值进行了讨论。实验数据表明，在1s到10ns脉宽范围内损伤所需能量密度近似而非严格地与脉宽的平方根成正比。信号分析表明硅光电二极管的损伤主要由热效应造成，而60fs激光辐照下的损伤阈值为0.1J/cm2，明显偏离普通温度分布预言的趋势。