二氧化锡溅射工艺研究

SnO2 是最早使用也是目前使用最广泛的一种气敏材料 ,使用该材料设计制作的气敏传感器具有许多优点。在简要介绍溅射镀膜的成膜过程和特点的基础上 ,着重介绍了SnO2 膜的制备流程 ,分析了功率和温度变化对成膜质量的影响     

Characterization of ZnO:AI films deposited by r.f.magnetron-sputtering at low temperature

Transparent conducting ZnO:AI thin films with good adhesion and Iow resistivity have been prepared on organic substrates and Coming 7059 glass substrates by r.f. magnetron-sputtering technique at Iow substrate temperature (25-210℃). Structural and photoelectric properties of the deposited films are investigated. The deposited films are polycrystalline with hexagonal structure and a preferred orientation with the c-axis perpendicular to the substrate. Only the (002) peak is observed.High quality films with resistivity as Iow as 1.0 x 10- 3Ω@ cm and 8.4 x 10- 4Ω@ cm, the average transmittance over 74% and 85% in the wavelength range of the visible spectrum have been obtained on different substrates.     

Growth studies of m-GaN layers on LiAlO2 by MOCVD

This paper reports that the m-plane GaN layer is grown on （200）-plane LiAlO2 substrate by metal-organic chemical wpour deposition （MOCVD） method. Tetragonal-shaped crystallites appear at the smooth surface. Raman measurement illuminates the compressive stress in the layer which is released with increasing the layer＇s thickness. The high transmittance （80%）, sharp band edge and excitonic absorption peak show that the GaN layer has good optical quality. The donor acceptor pair emission peak located at -3.41 eV with full-width at half maximum of 120 meV and no yellow peaks in the photoluminescence spectra partially show that no Li incorporated into GaN layer from the LiAlO2 substrate.     

蓝宝石R面上ZnO薄膜的NH3掺杂研究

以NH₃为掺杂源,利用金属有机化学气相沉积(MOCVD)系统在蓝宝石R面上生长出掺氮ZnO薄膜。通过XRD,SEM测量优化了其生长参数,在610℃和在80sccm的NH₃流量下生长出了〈1120〉单一取向的ZnO薄膜。经Hall电阻率测量,得知该薄膜呈现弱p型或高电阻率,并对其光电子能谱进行了研究。     

Investigation of thin-film electroluminescent structures on rough subsrates

Results of experimental investigations of the volt-brightness characteristics, frequency dependences of brightness, and the directional radiation pattern of electroluminescent MSDM, MSCM, and MSDCM emitters, where M stands for the first transparent and second nontransparent electrodes, S is a semiconductor, D is a thin-film dielectric, and C is a silicone-based composite liquid dielectric with a powdered segnetoelectric filler, developed on conventional “smooth” and rough glass substrates are presented. It is shown that electroluminescent structures on rough surfaces have a brightness approximately two times higher than that of similar structures developed on a “smooth” substrate. Ul’yanovsk State University, 42, L. Tolstoi St., Ul’yanovsk, 432700, Russia. Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 4, pp. 507–512, July–August, 1997.     

彩色PDP用玻璃基板

本文讨论了彩色ＰＤＰ现用钠钙玻璃的热稳定性，指出由于这种玻璃在热处理过程中易变形和收缩，因而不适合作大面积彩色ＰＤＰ基板材料，介绍了彩色ＰＤＰ基板玻璃的制造方法和特点。最后介绍了日本旭硝子公司和美国康宁公司各自为彩色ＰＤＰ新开发的玻璃基板材料ＰＤ２００和ＣＳ２５。     

Si衬底上ZnSe外延膜的低压MOCVD生长

以硒化氢（H2Se）和二甲基锌为源材料，生长温度是300℃时，用低压金属有机化学气相沉积（LP－MOCVD）系统在Si(111)衬底上外延生长了ZnSe薄膜。通过X射线衍射（XRD）、扫描电子显微镜的能量色散（EDS）以及光致发光（PL）实验验证ZnSe外延膜的质量，在X射线衍射谱中只有一个强的ZnSe(111)面衍射峰，这说明外延膜是（111）取向的单晶薄膜，在能量色散谱中除了Si,Zn和Se原子外，没有观测到其他原子，说明ZnSe外延膜中杂质含量较少。ZnSe外延膜中Zn/Se原子比接近1，有较好的化学配比。在ZnSe外延膜的77K光致发光谱中没有观测到与深中心发射相关的发光峰，表明ZnSe外延膜的晶格缺陷密度较小。77K时的近带边发射峰447nm在室温时移至465nm附近。     

4英寸热氧化硅衬底上磁性隧道结的微制备

就如何在4英寸热氧化硅衬底上沉积高质量的磁性隧道结纳米多层薄膜材料和如何利用光刻方法微加工制备均匀性较好的磁性隧道结方面做了初步研究，并对磁性隧 道结的磁电性质及其工作特性进行了初步测量和讨论.利用现有的光刻设备和工艺条 件在4英寸热氧化硅衬底上直接制备出的磁性隧道结，其结电阻与面积的积 矢的绝对误差在10% 以内，隧穿磁电阻的绝对误差在7% 以内，样品的磁性隧道结性质具有较好的均匀性和一致性，可以满足研制磁随机存储器存储单元演示器件的基本要求. 关键词： 磁性隧道结 隧穿磁电阻 磁随机存储器 4英寸热氧化硅衬底     

可与氟树脂基板相匹敌的热可塑性树脂基板材料

概述了可以与氟树脂基板相匹敌的低介质特性的热可塑性树脂基板材料的开发和应用。     

流延法制作AlN陶瓷基片工艺

研究出一种用流延法制作ＡＩＮ陶瓷基片的工艺。制备出性能优良的ＡＩＮ基片。经１６５０℃，保温２ｈ无压烧结制得的基片，其热导率达１３０Ｗ／（ｍ·Ｋ）、密度为３．３４ｇ／ｃｍ￣３，表面光滑平整，瓷体结构均匀，性能达到用干压法制备的同类基片的性能。