新一代IP QoS的实现

文章介绍了新一代IP骨干网上的IP QoS实现技术，论述了集成业务(IntServ)与差分业务(DiffServ)解决方案的特点，详细介绍了相关的队列管理与排队机制。并结合多协议标签交换（MPLS)技术的最新发展，阐述了综合多协议标签交换流量工程与DiffServ技术体系端到端IP QoS的实现。     

Handover and Uplink Power Control Performance in the 3.84 Mcps TDD mode of UTRA Network

In this article we consider the performance of the 3.84 Mcpstime-division duplex (TDD) mode of UTRA (Universal TerrestrialRadio Access) network. We emphasize two of the radio resourcemanagement algorithms, handover and uplink power control, whoserole in the overall system performance is studied extensively.First, a handover algorithm used in WCDMA (Wideband Code DivisionMultiple Access) standard is considered in a TDD-mode operation.This gives rise to a careful setting of different handoverparameters, and the evaluation of the effects to the systemperformance. Secondly, the specified uplink power controlalgorithm is considered. Since it is based on several user-mademeasurements which may involve both random and systematic errors acareful study about the suitability of the power control scheme iscarried out.     

色散补偿及EDFA增益均衡的一体化

提出一种新的色散补偿及EDFA增益均衡的一体化方法。在10Gb／s的光通信系统和600km G652光纤中首次实现了基于16个碉啾光纤布拉格光栅(FBG)的色散补偿及掺饵光纤放大器(EDFA)的增益均衡。16个FBG的波长间隔为1．6nm，波长覆盖C波段1529～1556nm约27nm的范围。经600km G652光纤传输后，10Gb／s的NRZ码传输功率代价小于2dB。     

Analysis of Distributed DDQ for QoS Router

In a packet switching network, congestion is unavoidable and affects the quality of real‐time traffic with such problems as delay and packet loss. Packet fair queuing (PFQ) algorithms are well‐known solutions for quality‐of‐service (QoS) guarantee by packet scheduling. Our approach is different from previous algorithms in that it uses hardware time achieved by sampling a counter triggered by a periodic clock signal. This clock signal can be provided to all the modules of a routing system to get synchronization. In this architecture, a variant of the PFQ algorithm, called digitized delay queuing (DDQ), can be distributed on many line interface modules. We derive the delay bounds in a single processor system and in a distributed architecture. The definition of traffic contribution improves the simplicity of the mathematical models. The effect of different time between modules in a distributed architecture is the key idea for understanding the delay behavior of a routing system. The number of bins required for the DDQ algorithm is also derived to make the system configuration clear. The analytical models developed in this paper form the basis of improvement and application to a combined input and output queuing (CIOQ) router architecture for a higher speed QoS network.     

基于多相滤波器的信道化接收机及其应用研究

本文主要研究了应用多相滤波技术的信道化接收机建模问题。在给定信道频谱划分方案下,推导了基于多相 滤波器的信道化接收机数学模型。并由此模型设计了一个四信道模拟系统。最后用仿真实验结果验证了模型的正确性。     

测向定位技术准确度及误差校正

测向定位技术是无线电管理的一个重要课题。测向定位过程中的误差的种类和产生的原因很多。选择适当的方法对误差进行校正，可以有效的减小测向误差带来的损失，提高无线电管理的效率。     

采用RF2607的WLAN自动增益控制设计

介绍了宽动态变化范围的新型可变增益放大器RF2607的特性、功能,给出了利用RF2607设计无线局域网(WLAN)通信中自动增益控制部分的实用电路.     

无线电车载监测站的信号采集与通讯系统

本系统采用LabVIEW对无线电监测信号进行采集和处理．并开发用户界面。在Delphi平台上运用远程访问服务实现了无线电车载监测站与中心固定站的通讯。LabVIEW主程序对通讯子程序进行调用。     

WPAN/WLAN应用环境下基于PER的链路自适应算法

本文重点研究基于包错误率测量的链路自适应算法，分析了包错误率与信道参数的关系，提出了一种有别于固定门限值方案的优化门限值方案。仿真结果表明，优化门限值方案的网络吞吐量要大于固定门限值方案和基于信干比估计的链路自适应算法，最大增幅可达12Mbit/s。在系统引入重传机制后，网络吞吐量将有所损失，但最大不超过1Mbit/s，相比较服务质量的提高是值得的。需指出的是，虽然分析和仿真均以HIPERLAN／2为例，但不失一般性，它们同样适合于WPAN/WLAN等类似系统。     

双级染料激光放大器泵浦能量分配的数值研究

用染料激光放大器的横向稳态泵浦理论，对不同的入射光能量选择不同的增益计算方法，研究了双级染料放大器的泵浦能量分配比例、泵浦光总能量和信号光能量大小对激光增益的影响。计算结果表明，对于其他参数确定的放大系统，存在着最佳的泵浦能量分配比例，可获得最大增益输出。通过自编程序的计算，可方便地找出特定系统泵浦能量分配比例的最佳值。