All-printed and highly stable organic resistive switching device based on graphene quantum dots and polyvinylpyrrolidone composite

We propose all printed and highly stable organic resistive switching device (ORSD) based on graphene quantum dots (G-QDs) and polyvinylpyrrolidone (PVP) composite for non-volatile memory applications. It is fabricated by sandwiching G-QDs/PVP composite between top and bottom silver (Ag) electrodes on a flexible substrate polyethylene terephthalate (PET) at ambient conditions through a cost effective and eco-friendly electro-hydrodynamic (EHD) technique. Thickness of the active layer is measured around 97 nm. The proposed ORSD is fabricated in a 3 × 3 crossbar array. It operates switching between high resistance state (HRS) and low resistance state (LRS) with OFF/ON ratio ∼14 for more than 500 endurance cycles, and retention time for more than 30 days. The switching voltage for set/reset of the devices is ±1.8 V and the bendability down to 8 mm diameter for 1000 cycles are tested. The elemental composition and surface morphology are characterized by XPS, FE-SEM, and microscope.     

Strain induced strengthening of soft thermoplastic polyurethanes under cyclic deformation

We investigate the cyclic mechanical behavior in uniaxial tension of three different commercial thermoplastic polyurethane elastomers (TPU) often considered as a sustainable replacement for common filled elastomers. All TPU have similar hard segment contents and linear moduli but sensibly different large strain properties as shown by X-ray analysis. Despite these differences, we found a stiffening effect after conditioning in step cyclic loading which greatly differs from the common softening (also referred as Mullins effect) observed in chemically crosslinked filled rubbers. We propose that this self-reinforcement is related to the fragmentation of hard domains, naturally present in TPU, in smaller but more numerous sub-units that may act as new physical crosslinking points. The proposed stiffening mechanism is not dissimilar to the strain-induced crystallization observed in stretched natural rubber, but it presents a persistent nature. In particular, it may cause a local reinforcement where an inhomogeneous strain field is present, as is the case of a crack propagating in cyclic fatigue, providing a potential explanation for the well-known toughness and wear resistance of TPU.     

Supramolecular Assembly of Aminoethylene‐Lipopeptide PMO Conjugates into RNA Splice‐Switching Nanomicelles

Phosphorodiamidate morpholino oligomers (PMOs) are oligonucleotide analogs that can be used for therapeutic modulation of pre‐mRNA splicing. Similar to other classes of nucleic acid‐based therapeutics, PMOs require delivery systems for efficient transport to the intracellular target sites. Here, artificial peptides based on the oligo(ethylenamino) acid succinyl‐tetraethylenpentamine (Stp), hydrophobic modifications, and an azide group are presented, which are used for strain‐promoted azide‐alkyne cycloaddition conjugation with splice‐switching PMOs. By systematically varying the lead structure and formulation, it is determined that the type of contained fatty acid and supramolecular assembly have a critical impact on the delivery efficacy. A compound containing linolenic acid with three cis double bonds exhibits the highest splice‐switching activity and significantly increases functional protein expression in pLuc/705 reporter cells in vitro and after local administration in vivo. Structural and mechanistic studies reveal that the lipopeptide PMO conjugates form nanoparticles, which accelerate cellular uptake and that the content of unsaturated fatty acids enhances endosomal escape. In an in vitro Duchenne muscular dystrophy exon skipping model using H2K‐mdx52 dystrophic skeletal myotubes, the highly potent PMO conjugates mediate significant splice‐switching at very low nanomolar concentrations. The presented aminoethylene‐lipopeptides are thus a promising platform for the generation of PMO‐therapeutics with a favorable activity/toxicity profile.     

Theory of chemical bonds in metalloenzymes XXII: a concerted bond-switching mechanism for the oxygen–oxygen bond formation coupled with one electron transfer for water oxidation in the oxygen-evolving complex of photosystem II

ABSTRACT

QM(UB3LYP)/MM(AMBER) calculations were performed for the locations of the transition structure (TS) of the oxygen–oxygen (O–O) bond formation in the S₄ state of the oxygen-evolving complex (OEC) of photosystem II (PSII). The natural orbital (NO) analysis of the broken-symmetry (BS) solutions was also performed to elucidate the nature of the chemical bonds at TS on the basis of several chemical indices defined by the occupation numbers of NO. The computational results revealed a concerted bond switching (CBS) mechanism for the oxygen–oxygen bond formation coupled with the one-electron transfer (OET) for water oxidation in OEC of PSII. The orbital interaction between the σ-HOMO of the Mn(IV)₄–O₍₅₎ bond and the π*-LUMO of the Mn(V)₁=O₍₆₎ bond plays an important role for the concerted O–O bond formation for water oxidation in the CaMn₄O₆ cluster of OEC of PSII. One electron transfer (OET) from the π-HOMO of the Mn(V)₁=O₍₆₎ bond to the σ*-LUMO of the Mn(IV)₄–O₍₅₎ bond occurs for the formation of electron transfer diradical, where the generated anion radical [Mn(IV)₄–O₍₅₎]^-? part is relaxed to the ?Mn(III)₄?…?O₍₅₎^- structure and the cation radical [O₍₆₎=Mn(V)₁]⁺ ? part is relaxed to the ⁺O₍₆₎–Mn(IV)₁? structure because of the charge-spin separation for the electron-and hole-doped Mn–oxo bonds. Therefore, the local spins are responsible for the one-electron reductions of Mn(IV)₄->Mn(III)₄ and Mn(V)₁->Mn(IV)₁. On the other hand, the O₍₅₎^- and O₍₆₎⁺ sites generated undergo the O–O bond formation in the CaMn₄O₆ cluster. The Ca(II) ion in the cubane- skeleton of the CaMn₄O₆ cluster assists the above orbital interactions by the lowering of the orbital energy levels of π*-LUMO of Mn(V)₁=O₍₆₎ and σ*-LUMO of Mn(IV)₄–O₍₅₎, indicating an important role of its Lewis acidity. Present CBS mechanism for the O–O bond formation coupled with one electron reductions of the high-valent Mn ions is different from the conventional radical coupling (RC) and acid-base (AB) mechanisms for water oxidation in artificial and native photosynthesis systems. The proton-coupled electron transfer (PC-OET) mechanism for the O–O bond formation is also touched in relation to the CBS-OET mechanism.     

计量用脉冲Nd：YAG倍频激光器及其电源

介绍了脉冲Nd:YAG倍频激光器双波长（1064／532nm）3种输出的激光光路。1064nm输出的动静比可达0.40；KTP晶体外腔倍频效率可达0.50。介绍了稳定可靠的调Q电路、逻辑控制电路和开关电源的主电路及其参数计算。     

开关电源的平均电流自动均流技术

针对多个开关电源并联时易出现负载电流在各模块间分配不均的现象,介绍了常用的负载电流自动均流法——平均电流自动均流法及其工作特性。并针对其存在母线电压降低的缺陷,提出了一种改进的平均电流自动均流方法,经试验证明均流精度比较高。     

On Burst Length Distribution and Preemption Probabilities in OBS Networks with Burst Segmentation

Recently, preemption techniques have attracted considerable attention as a means to provide differentiated quality of service in optical burst switching (OBS) networks. This paper is focused on the analysis of preemption probabilities for bursts within the same priority class. As proposed by Vokkarane and Jue ((2003)* IEEE J Select Areas Commun 21(7): 1198–1209) an incoming burst will preempt the burst in service, within the same priority class, if the residual length of the burst in service is smaller than the incoming burst length. For a general case with wavelength conversion, the preemption probability of contending bursts with a generic service distribution, not necessarily exponential, is analyzed. First, we show that the size distribution for the preempting bursts is shifted to larger values, in comparison to the original burst size distribution. Second, we obtain an upper and lower bound for the preemption probability. Finally, the asymptotic behavior of the OBS switch is analyzed showing that preemption will always occur for a very large number of wavelengths.     

宽带综合IP网的MPLS技术及其应用

多协议标记交换（MPLS）技术是综合利用网络第二层交换技术的有效性和第三层IP路由的灵活性等优点而产生的多层交换技术。通过在传统的IP包里加入标记，使路由转发依赖于标记，大大地提高IP包的转发速度，同时可使传统IP网络具有服务质量（QoS）能力。现主要分析MPLS体系结构，指出MPLS的一些应用。     

小波变换在光谱特征提取方面的应用

人们在处理高光谱图像时一般要对一些典型地物进行光谱分析、特征波段的提取,以便提取出最大量的有效信息,剔除无用或冗余的信息,然后再进行分类识别.采用小波变换的分析方法,选用合适的小波进行分解,根据分解后的高频分量中包含的重要信息,利用局部相邻的正负极值点找出对应于原始光谱曲线上每个吸收带的左右边界;利用局部过零点,即可比较精确的提取出各个吸收带的中心波长.该方法比传统的光谱特征提取方法更简洁、有效,实验证明为一种比较理想的光谱特征提取方法.     

移动通信系统"单通"故障浅析

重点分析了移动通信系统中,无线及交换系统内语音单通故障的成因；并以朗讯 CDMA 交换系统为例,提出语音系统优化建议；最后结合运维工作,阐述单通故障的处理流程与几种有效处理思路及工具。