基于关键路径延时检测的自适应电压缩减技术

为了减小传统的最差情况设计方法引入的电压裕量,提出了一种变化可知的自适应电压缩减(AVS)技术,通过调整电源电压来降低电路功耗.自适应电压缩减技术基于检测关键路径的延时变化,基于此设计了一款预错误原位延时检测电路,可以检测关键路径延时并输出预错误信号,进而控制单元可根据反馈回的预错误信号的个数调整系统电压.本芯片采用SMIC180 nm工艺设计验证,仿真分析表明,采用自适应电压缩减技术后,4个目标验证电路分别节省功耗12.4％,11.3％,10.4％和11.6％.     

基于串联两阶段网络DEA模型的供应链规模收益分析

数据包络分析(DEA)是评价供应链系统(Supply chain system)间相对有效性的一种重要的工具,但是传统的DEA不考虑供应链的内部结构,对系统效率评价偏高;而本文所研究两阶段串联供应链系统,考虑把部分中间产品作为最终产品输出,增加额外中间投入的情形.基于所提出的供应链系统结构,本文建立相应的串联结构下的网络DEA模型,并针对所建立模型进行相关理论的研究,给出了串联结构下的生产可能集和规模收益情况判定方法.最后,进行数值实验,以验证我们提出的结论.     

Voltage reference architectures for low-supply-voltage low-power applications

This paper presents a voltage reference generator architecture and two different realizations of it that have been fabricated within a standard 0.18 μm CMOS technology. The architecture takes the advantage of utilizing a sampled-data amplifier (SDA) to optimize the power consumption. The circuits achieve output voltages on the order of 190 mV with temperature coefficients of 43 ppm/°C and 52.5 ppm/°C over the temperature range of 0 to 120°C without any trimming with a 0.8 V single supply. The power consumptions of the circuits are less then 500 nW while occupying an area of 0.2 mm² and 0.08 mm², respectively.     

多带OFDM-UWB系统峰均功率比降低方法研究

针对多带OFDM—UWB信号存在高峰均功率比的问题，提出了利用扩展与交织降低系统信号峰均功率比的方法。该方法通过对传输数据进行正交扩展与交织，使得进入多载波调制的数据趋于高斯分布，减小了传输数据自相关函数的旁瓣峰值，降低了OFDM-UWB信号的峰均功率比。由于采用正交矩阵进行扩展，扩展前后的数据传输速率保持不变。仿真结果表明，扩展与交织可以有效地降低信号峰均功率比2-5dB左右。同时该方法还具有抗窄带干扰的鲁棒性。     

掺镱双包层高功率光纤激光器输出特性研究

对线形腔掺镱双包层高功率光纤激光器的输出特性进行了研究 ,通过求解速率方程 ,得到了激光器泵浦阈值功率、输出光功率和斜率效率的表达式。分析了光纤长度、腔镜反射率和泵浦波长等因素对激光器阈值功率、输出光功率和斜率效率的影响 ,为高功率光纤激光器的优化设计提供了理论依据     

Handover and Uplink Power Control Performance in the 3.84 Mcps TDD mode of UTRA Network

In this article we consider the performance of the 3.84 Mcpstime-division duplex (TDD) mode of UTRA (Universal TerrestrialRadio Access) network. We emphasize two of the radio resourcemanagement algorithms, handover and uplink power control, whoserole in the overall system performance is studied extensively.First, a handover algorithm used in WCDMA (Wideband Code DivisionMultiple Access) standard is considered in a TDD-mode operation.This gives rise to a careful setting of different handoverparameters, and the evaluation of the effects to the systemperformance. Secondly, the specified uplink power controlalgorithm is considered. Since it is based on several user-mademeasurements which may involve both random and systematic errors acareful study about the suitability of the power control scheme iscarried out.     

移动通信系统中功率控制研究

在阐述功率控制在移动通信系统中的发展过程的基础上，着重研究了WCDMA系统的功率控制，最后对功率控制未来的研究方向做了简要的分析。     

Range Assignment for Biconnectivity and k-Edge Connectivity in Wireless Ad Hoc Networks

Depending on whether bidirectional links or unidirectional links are used for communications, the network topology under a given range assignment is either an undirected graph referred to as the bidirectional topology, or a directed graph referred to as the unidirectional topology. The Min-Power Bidirectional (resp., Unidirectional) k-Node Connectivity problem seeks a range assignment of minimum total power subject to the constraint that the produced bidirectional (resp. unidirectional) topology is k-vertex connected. Similarly, the Min-Power Bidirectional (resp., Unidirectional) k-Edge Connectivity problem seeks a range assignment of minimum total power subject to the constraint the produced bidirectional (resp., unidirectional) topology is k-edge connected. The Min-Power Bidirectional Biconnectivity problem and the Min-Power Bidirectional Edge-Biconnectivity problem have been studied by Lloyd et al. [23]. They show that range assignment based the approximation algorithm of Khuller and Raghavachari [18], which we refer to as Algorithm KR, has an approximation ratio of at most 2(2 – 2/n)(2 + 1/n) for Min-Power Bidirectional Biconnectivity, and range assignment based on the approximation algorithm of Khuller and Vishkin [19], which we refer to as Algorithm KV, has an approximation ratio of at most 8(1 – 1/n) for Min-Power Bidirectional Edge-Biconnectivity. In this paper, we first establish the NP-hardness of Min-Power Bidirectional (Edge-) Biconnectivity. Then we show that Algorithm KR has an approximation ratio of at most 4 for both Min-Power Bidirectional Biconnectivity and Min-Power Unidirectional Biconnectivity, and Algorithm KV has an approximation ratio of at most 2k for both Min-Power Bidirectional k-Edge Connectivity and Min-Power Unidirectional k-Edge Connectivity. We also propose a new simple constant-approximation algorithm for both Min-Power Bidirectional Biconnectivity and Min-Power Unidirectional Biconnectivity. This new algorithm applies only to Euclidean instances, but is best suited for distributed implementation. A preliminary version of this work appeared in the proceedings of the 2nd International Conference on AD-HOC Network and Wireless (Adhoc-Now 2003). Research performed in part while visiting the Max-Plank-Institut fur Informatik. Gruia Calinescu is an Assistant Professor of Computer Science at the Illinois Institute of Technology since 2000. He held postdoc or visiting researcher positions at DIMACS, University of Waterloo, and Max-Plank Institut fur Informatik. Gruia has a Diploma from University of Bucharest and a Ph.D. from Georgia Insitute of Technology. His research interests are in the area of algorithms. Peng-Jun Wan has joined the Computer Science Department at Illinois Institute of Technology in 1997 and has been an Associate Professor since 2004. He received his Ph.D. in Computer Science from University of Minnesota in 1997, M.S. in Operations Research and Control Theory from Chinese Academy of Science in 1993, and B.S. in Applied Mathematics from Tsinghua University in 1990. His research interests include optical networks and wireless networks.     

动力环境集中监控系统可靠性的提高

为实现电源设备乃至通信机房的少人或无人值守和集中维护,必须建立一套完善的电信局动力环境集中监控系统。文中结合番禺区电信局的实际,讨论了提高系统运行可靠性的几点措施,包括硬件方面与软件方面的手段,关键在于加强系统的运行管理。     

动力环境网络监控精细管理

叙述动力环境运行质量分析管理，包括故障管理，性能管理和专题分析管理，以动力环境网络监控细致八微、言之有据的月度分析管理实例展现了其精细管理的效果。