Fluid‐structure coupling of linear elastic model with compressible flow models

Cavitation erosion is caused in solids exposed to strong pressure waves developing in an adjacent fluid field. The knowledge of the transient distribution of stresses in the solid is important to understand the cause of damaging by comparisons with breaking points of the material. The modeling of this problem requires the coupling of the models for the fluid and the solid. For this purpose, we use a strategy based on the solution of coupled Riemann problems that has been originally developed for the coupling of 2 fluids. This concept is exemplified for the coupling of a linear elastic structure with an ideal gas. The coupling procedure relies on the solution of a nonlinear equation. Existence and uniqueness of the solution is proven. The coupling conditions are validated by means of quasi‐1D problems for which an explicit solution can be determined. For a more realistic scenario, a 2D application is considered where in a compressible single fluid, a hot gas bubble at low pressure collapses in a cold gas at high pressure near an adjacent structure.     

Metabolomics techniques applied in the investigation of phenolic acids from the agro-industrial by-product of Carapa guianensis Aubl

Processing of Carapa guianensis seeds to obtain oil on an industrial scale generates a significant amount of by-product, approximately 66% w/w, which is called cake and is a potential source of biomolecules, including simple phenolic structures. For this reason, studies were carried out on the chemical profiles of hydrolyzed extract from this agro-industrial by-product through High Performance Thin-Layer Chromatography (HPTLC) and Gas Chromatography coupled to Mass Spectrometry (GC–MS). These techniques were used to detect metabolic classes and/or groups, and to identify, for the first time, thirteen simple phenolic acids in this by-product. The sample antioxidant capacity was determined by methods of 2,2-diphenyl-1-picrylhydrazyl (DPPH)and 2,2′-azino-bis(3-ethylbenzothiazoline-6-sulfonic acid) diammonium salt (ABTS⁺) radicals direct sequestration. The hydrolyzed fraction showed a total of 63.47% in the relative abundance of the total of compounds, standing out: p-hydroxybenzoic acid (39.19%) and protocatechuic acid (3,4-dihydroxybenzoic acid) (5.62%), both from hydroxybenzoic acids and 3-(3,4-dihydroxyphenyl)lactic acid, (7.76%) hydroxycinnamic acids derivatives. In these results, the fraction rich in simple phenolic acids was obtained, attributing the prominent behavior of this matrix antioxidant activity, expressed by (IC₅₀: of 16.42 µg/mL and 6.52 µg/mL for DPPH and ABTS⁺ radicals, respectively). The research demonstrated an alternative to applicability that involves sustainability from agro-industrial. These techniques were used to detect metabolic classes and/or groups, and to identify, for the first time, thirteen simple phenolic acids in this by-product, generating a process capable of converting biomass into a bioproduct, consisting of bioactive compounds, in addition to adding value to the industrial chain.     

Recent trends in capillary and micro-chip electrophoretic instrumentation for field-analysis

Technical advances in the development of field-deployable capillary and microchip electrophoretic instruments and reports of their deployment between 2013 and 2017 were reviewed. Strategies and considerations in the design of the injection, separation and detection hardware, chemistry and associated infrastructure were discussed from an in-field perspective, with portability, robustness and automation/“ease of use” featuring as key requirements. Integration of functionality is important for adequate in-field performance. Progress was made towards the use of multiple channel devices for increased throughput and/or resolving power, mixing devices for on-line/in-line sample derivatization, battery operation and temperature control. The strengths and weaknesses of the various approaches described in the literature are discussed from the perspective of in-field operation. An overview of the applications of the field electrophoretic instruments is provided, including environmental science and planetary investigation.     

噪声测量作为筛选光电耦合器件的一种方法

本文针对目前用于光电耦合器件筛选方法的不足，提出了用测量耦合器件噪声功率谱的方法来筛选掉噪声值大的器件，给出一批光电耦合器件的测量统计结果及在不同工作点时的噪声功率谱，并给出相应的筛选标准，实验结果表明，这种方法是有效、可行的。     

Quantification of trace elements in human serum fractions by liquid chromatography and inductively coupled plasma mass spectrometry

On‐line coupling of LC and ICP‐MS has been used for fractionation and detection of species of Cu, Fe, I, Se and Zn in human serum. It has been shown that anion exchange chromatography provided better separation capability (both intra‐ and inter‐element) than size‐exclusion chromatography. The mobile phases for ion exchange chromatography consisted of Tris–HNO₃ buffer and ammonium salt (nitrate, acetate or formate). Formate was found to be the best mobile phase counter ion, enabling good chromatographic separation, and is acceptable for mass spectrometry too. The quantitative evaluation of element concentrations adhering to individual fractions was performed by the peak area normalization method. The repeatability of results ranged from 3 to 15% (depending on the element concentration level) and represented the main part of the result uncertainty. The accuracy of Cu and Zn fraction determinations was confirmed by comparison with the isotope dilution technique. Copyright © 2006 John Wiley & Sons, Ltd.     

Mode beating in spot-size converter lasers

An anomalous modulation in the wavelength spectrum has been observed in lasers with spot-size converters. This intensity modulation is shown to be caused by beating between the fundamental lasing mode and radiation modes in the taper. This results in a periodic modulation in the net gain spectrum, which causes wavelength jumps between adjacent net gain maxima, and a drive current dependent spectral width that is expected to affect system performance. The amplitude of this spectral modulation is reduced significantly by either using an angled rear-facet which reflects the beating radiation modes away from the laser axis, or by using a nonlinear, adiabatic taper.     

Solid phase extraction for analysis of biogenic carbonates by electrothermal vaporization inductively coupled plasma mass spectrometry (ETV-ICP-MS): an investigation of rare earth element signatures in otolith microchemistry

Uptake of trace elements into fish otoliths is governed by several factors such as life histories and environment in addition to stock and species differences. In an attempt to elucidate the elemental signatures of rare earth elements (REEs) in otoliths, a solid phase extraction (SPE) protocol was used in combination with electrothermal vaporization (ETV) as a sample introduction procedure for the determinations by inductively coupled plasma quadrupole mass spectrometry (ICP-MS). Effects of various parameters, such as carrier gas flow rate, atomization temperature and chemical modification, were examined for optimization of the conditions by ETV-ICP-MS. Atomization was achieved at 2800 °C. Lower temperatures (i.e. 2600 °C) resulted in severe memory problems due to incomplete atomization. Palladium was used as a chemical modifier. It was found that an increase in Pd concentration up to 0.5 μg in the injection volume (70 μl) led up to four-fold enhancement in the integrated signals. This phenomenon is attributed to the carrier effect of Pd rather than the stabilization since no significant losses were observed for high temperature drying around 700 °C even in the absence of Pd. Preconcentration was performed on-line at pH 5 by using a mini-column of Toyopearl AF-Chelate 650M chelating resin, which also eliminated the calcium matrix of otolith solutions. After preconcentration of 6.4 ml of solution, the concentrate was collected in 0.65 ml of 0.5% (v/v) HNO₃ in autosampler cups, and then analyzed by ETV-ICP-MS. The method was validated with the analysis of a fish otolith certified reference material (CRM) of emperor snapper, and then applied to samples. Results obtained from otoliths of fish captured in the same habitat indicated that otolith rare earth element concentrations are more dependent on environmental conditions of the habitat than on species differences.     

Three methods for analyzing forced vibration of a fluid-filled cylindrical shell

The forced vibration of an infinite elastic circular cylindrical shell filled with fluid is studied. Three methods are employed to analyze the forced vibration problem of this shell-fluid coupled system, that is, wave propagation approach (wave mode superposition), theorem of residues and a numerical integral method. In order to explain these methods more explicitly, before being used to investigate the vibration of an infinite fluid-filled elastic circular cylindrical shell, all these three methods are employed firstly to analyze the forced vibration problem of an infinite beam and an infinite elastic circular cylindrical shell in vacuo. Advantage and disadvantage of these three methods are discussed and their interesting relationship is revealed. That is, to any circumferential wavenumber and frequency of the external force, there is an unchangeable relationship between the general coordinates of various waves in the wave propagation approach and the residuals in the theorem of residues.     

一个耦合系统自由边界问题的整体古典解

§ 1　ＩｎｔｒｏｄｕｃｔｉｏｎＩｎｔｈｉｓｐａｐｅｒｗｅｄｉｓｃｕｓｓｔｈｅｇｌｏｂａｌｃｌａｓｓｉｃａｌｓｏｌｕｔｉｏｎｏｆａｍｕｌｔｉｄｉｍｅｎｓｉｏｎａｌｑｕａｓｉｓｔａｔｉｏｎａｒｙｐｒｏｂｌｅｍ .Ｔｈｅｐｒｏｂｌｅｍｃｏｍｅｓｆｒｏｍｔｈｅｄｉｓｃｕｓｓｉｏｎｏｆａｇｒｏｗｔｈｍｏｄｅｌｏｆｓｅｌｆｍａｉｎｔａｉｎｉｎｇｐｒｏｔｏｃｅｌｌ(ｓｅｅ [1— 3])ｉｎｍｕｌｔｉｄｉｍｅｎｓｉｏｎａｌｃａｓｅ .Ｔｈｅｐｒｏｔｏｃｅｌｌｃａｎｂｅｖｉｓｕａｌｉｚｅｄａｓｈａｖｉｎｇａｐｏｒｏｕｓｓｔ…