用于波分复用系统的多峰干涉滤光片

介绍了用于波分复用系统的多峰干涉滤光片的设计原理,提出了滤光片透射峰位置的确定方法,讨论了影响滤光片半宽度和截止度的因素,给出了滤光片的膜厚容差分析结果,表明透射率监控标准偏差在<0.5%范围内,可以得到波形良好的多峰滤光片,最后给出了实验结果.     

磁控溅射技术制备ZnO透光薄膜

采用RF磁控溅射方法,在玻璃衬底上制备了择优取向的ZnO薄膜;通过台阶仪、X射线衍射技术、原子力显微镜和分光光度计分别测量了不同溅射功率条件下淀积的ZnO薄膜厚度(淀积速率)、结晶质量、表面形貌与粗糙度、透光光谱,报道了该薄膜结晶质量、薄膜粗糙度与其在可见光区透光率的关系.     

高阻值Cd1-xZnxTe晶体的生长及其性能测试

通过适当的工艺措施，采用Bridgman法生长了直径为30mm的X射线及γ射线探测器级的Cd.9Zn0．1Te晶锭．测试结果表明：该晶锭结晶质量良好，位错密度低，成分均匀，杂质含量低，红外透过率和电阻率都十分接近本征Cd.9Zn0．1Te的值．并从晶体的生长特性、缺陷和杂质的角度，分析了生长高性能晶体的条件，研究了生长Cdl-xZnxTe晶体的x值与缺陷和杂质浓度之间的关系．     

多层介质光学膜系的误差分析——膜层厚度变化的灵敏度因子

文中推导了对于给定膜系的特定膜层的厚度变化的灵敏度因子计算公式，并给出了用计算机对不同膜系的计算实例。分析了厚度灵敏度因子对膜系透射光谱的灵敏谱段、灵敏膜层等特性的影响规律，并由此给出了确定膜层厚度允差的方法。     

Contour lines of the optical functions for solids

The well-known equations for the optical functions of reflectance, transmittance and phase changes on reflection and transmission for a solid material have been rearranged into the form of simple geometric figures in the u, v (n, k) plane. The curves for F_p show a singularity on the n-axis.     

微通道板BeO防离子反馈膜粒子阻透率的模拟研究

带有防离子反馈膜的微通道板是第三代微光像增强器件中的核心部件。文章阐述了防离子反馈膜的电子透过、离子阻止特性,利用Monte-Carlo模拟方法计算了氧化铍和三氧化二铝防离子反馈膜电子透过率和离子阻止率在不同条件下的变化曲线。模拟结果表明,氧化铍薄膜比三氧化二铝薄膜的电子透过特性好,而三氧化二铝薄膜比氧化铍薄膜的离子阻止本领好,证实了氧化铍作为防离子反馈膜的可行性。     

A 2.20 eV Bandgap Polymer Donor for Efficient Colorful Semitransparent Organic Solar Cells

Semitransparent organic solar cells (ST-OSCs) have attracted increasing attention due to their promising prospect in building-integrated photovoltaics. Generally, efficient ST-OSCs with good average visible transmittance (AVT) can be realized by developing active layer materials with light absorption far from the visible light range. Herein, the development of ultrawide bandgap polymer donors with near-ultraviolet absorption, paired with near-infrared acceptors, is proposed to achieve high-performance ST-OSCs. The key points for the design of ultrawide bandgap polymers include constructing donor–donor type conjugated skeleton, suppressing the quinoidal resonance effect, and minimizing the twist of conjugated skeleton via noncovalent conformational locks. As a proof of concept, a polymer named PBOF with an optical bandgap of 2.20 eV is synthesized, which exhibited largely reduced overlap with the human eye photopic response spectrum and afforded a power conversion efficiency (PCE) of 16.40% in opaque device. As a result, ST-OSCs with a PCE over 10% and an AVT over 30% are achieved without optical modulation. Moreover, colorful ST-OSCs with visual aesthetics can be achieved by tuning the donor/acceptor weight ratio in active layer benefiting from the ultrawide bandgap nature of PBOF. This study demonstrates the great potential of ultrawide bandgap polymers for efficient colorful ST-OSCs.     

The microstructure and optical transmittance thermal analysis of sodium borosilicate bio-glasses

The conditions to fabricate the bulk porous specimens have been studied on account of sodium borosilicate (NBS) glasses. Glass composition, heat treatment at phase separation and TiO₂ addition have been considered in this study. Original glass samples of composition in mol%: sample A: 9.19 Na₂O - 23.58 B₂O₃ - 67.23 SiO₂, sample B: 9.29 Na₂O - 3.17 TiO₂ - 23.82 B₂O₃ - 63.72 SiO₂ were prepared by melting reagent grade chemicals (Na₂CO₃, HBO₃, SiO₂ and AgNO₃) in platinum crucibles at 1480°C for 1 h in air. The melts were poured onto stainless steel plates and were annealed at 500°C for 0.5 h after cooling. Thus, obtained samples were phase separated at 700°C for 2, 15, 25 and 50 h to study their microstructure by scanning electron microscope (SEM). Besides the direct study of the microstructure by SEM, information on glass structural changes of samples are provided by measuring in situ changes by the optical transmittance thermal analysis. The isothermal measurements were carried out at 700, 720 and 740°C. The temperature of phase separation, the leaching and nucleator addition (TiO₂), significantly influence the microstructure of the resulting leached product. TiO₂ additive seems to suppress crystallization of cristobalite: especially at the extended above heat treatment phase separation runs. The phase-separated domains of glasses containing above 80 moles of SiO₂ are so small that it is very hard to observe them by SEM. The glass composition in our case was selected in a way to have relatively large phase separated areas easily observed by SEM at magnification 20 000·. The influence of TiO₂ is not too pronounced. It seems to suppress the cristobalite crystallization, especially of longer heating runs. The image analysis of leached glasses shows the prevailing content of the skeletal phase in a comparison to pores. The TiO₂ content diminishes the content of the skeletal phase. This revised version was published online in July 2006 with corrections to the Cover Date.     

Optochemical Sensor for Ammonia Based on a Lipophilized pH Indicator in a Hydrophobic Matrix

Abstract

An optical sensor for the determination of ammonia in water based on ion pairing has been investigated. A pH-sensitive dye is immobilized as an ion pair in a silicone matrix. The colour of the dye changes from yellow to blue depending on the concentration of ammonia in the sample solution. This change is reversible. The concentration of ammonia can be determined by measuring the transmittance at a given wavelength.

All measurements were performed with a dual-beam optical meter. The measurement range was from 5.9 × 10^?7 to 1 × 10^?3 M (0.01 to 17 mg/l) in 0.1 M phosphate buffer of pH 8. The detection limit was 10 μg/l. The response times at a flow rate of 2.5 ml/min were 4 min for t₉₀ and 10 min for t₁₀₀ at a change from 41.9 to 82.5 μM ammonia and 12 min for t₉₀ and 48 min for t₁₀₀ at a change from 160 to 0 μM ammonia. The operational lifetime of the ammonia sensor was limited to a period of a few days only. A continuous decrease in baseline signal and relative signal change was observed over the whole measurement. The storage stability was more than 10 months (dry). With respect to possible application of the ammonia sensor to environmental analysis, the influence of pH, typical interferences, such as amines and various detergents on the sensor response was investigated. No interference due to pH was observed in the range from pH 5 to pH 9. With methyl- and ethylamine the response was not completely reversible. The sensor was affected by cationic detergents, but not by anionic or neutral detergents.     

Side-lobeless far-field spectrum of a short pulse from a circular aperture with Gaussian form of transmittance

The spectrum change of a Gaussian pulse in the far field is studied with the Fresnel diffraction integral when it is incident on an aperture with Gaussian form transmittance. It is found that the side-lobes of the diffracted spectral intensity, which exist in a normal circular aperture with unit transmittance, can be eliminated completely under such a condition. Also, the red shift and blue shift of the spectral intensity maximum of the incident pulse are presented.