Effect of sodium doping on graded Cu(In1−xGax)Se2 thin films prepared by chemical spray pyrolysis

In the present work we have studied the effect of Na on the properties of graded Cu(In_1−xGa_x)Se₂ (CIGS) layer. Graded CIGS structures were prepared by chemical spray pyrolysis at a substrate temperature of 350 °C on soda lime glass. Sodium chloride is used as a dopant along with metal (Cu/In/Ga) chlorides and n, n-dimethyl selenourea precursors. The addition of Na exhibited better crystallinity with chalcopyrite phase and an improvement in preferential orientation along the (112) plane. Energy dispersive analysis of X-rays (line/point mapping) revealed a graded nature of the film and percentage incorporation of Na (0.86 at%). Raman studies showed that the film without sodium doping consists of mixed phase of chalcopyrite and CuAu ordering. Influence of sodium showed a remarkable decrease in electrical resistivity (0.49–0.087 Ω cm) as well as an increase in carrier concentration (3.0×10¹⁸–2.5×10¹⁹ cm⁻³) compared to the un-doped films. As carrier concentration increased after sodium doping, the band gap shifted from 1.32 eV to 1.20 eV. Activation energies for un-doped and Na doped films from modified Arrhenius plot were calculated to be 0.49 eV and 0.20 eV, respectively. Extremely short carrier lifetimes in the CIGS thin films were measured by a novel, non-destructive, noncontact method (transmission modulated photoconductive decay). Minority carrier lifetimes of graded CIGS layers without and with external Na doping are found to be 3.0 and 5.6 ns, respectively.     

Mg_(0.15)Zn_(0.85)O:Tb合金薄膜的阴极射线发光性质研究

采用溶胶凝胶方法成功地制备了掺杂稀土铽离子的 Zn O和 Mg0 .1 5Zn0 .85薄膜。通过对 X射线衍射结果的分析表明 ,稀土离子替代了 Zn2 +的格位 ,进入了半导体基质的晶格中。从阴极射线发光结果可以发现 ,在Mg0 .1 5Zn0 .85O基质中 ,可以观察到来源于稀土铽离子各能级的发射 ,而 Zn O:Tb的薄膜只能观察到较强的铽离子 5D4 — 7F5能级的跃迁。这可能是由于 Mg0 .1 5Zn0 .85O基质的能隙 (3 .65 e V)比 Zn O更宽 (3 .3 e V) ,其对铽离子的能量传递更有效的缘故。     

ZnO陶瓷材料的负阻特性

介绍了ＺｎＯ陶瓷的负阻特性，主要研究了ＭｎＯ２掺杂和Ｎｉ２Ｏ３掺杂对ＺｎＯ陶瓷负阻特性的影响。     

ZnO压敏陶瓷最佳掺杂含量的理论计算

从对电子薄膜材料研究中得到的最佳掺杂含量定量理论推广到ZnO陶瓷材料。该理论建立了电子薄膜材料的某一物理性能与晶体结构、制备方法和掺杂剂含量之间的联系，给出了一个能够拟合实验曲线的具有确定物理意义的抛物线方程。该方程的极值点确定了最佳掺杂含量与晶体结构和制备方法之间的定量关系，进而得到了一个掺杂最佳含量的表达式。系统地分析了ZnO压敏陶瓷的掺杂改性的实验结果，应用此表达式定量计算了ZnO压敏陶瓷的最佳掺杂含量，定量计算的结果与实验数据相符合。该理论也适用于其他薄膜材料最佳掺杂含量的理论计算。     

Wide-range regulation of polyaniline conduction by interphase doping of a polyaniline film

The not-sufficient-enough conductance of semioxidized protonated polyaniline (PANI) is usually attributed to the presence of ordered quasi-metallic domains surrounded by a poorly conducting amorphous phase. The paper presents experimental results testifying to the existence, in semioxidized PANI, of multilevel redox heterogeneity that crucially effects the conductance magnitude in view of specific topology at which higher-oxidized (conducting) domains are surrounded by less oxidized (poorly conducting) domains and because the PANI conduction is extremely sensitive to the oxidation degree. It is shown experimentally that the interphase doping with metals and degenerate semiconductors of a semioxidized salt of PANI and poly(2-acrylamide-2-methyl-1-propanesulfonic acid) (PAMPSA) with a 1: 2 ratio between PANI and PAMPSA raises the PANI-PAMPSA conductivity by 3–8 orders of magnitude due to the formation near the interface of thin layers whose conductance depends on the work function of the material in contact with PANI-PAMPSA and in extreme cases substantially exceeds the conductance of gold and copper at room temperature.     

Study of the pulsed laser vapor doping of Si(1 0 0) with KrF excimer laser and BCl3 gas

The properties of pulsed laser vapor doping on p-Si(1 0 0) with a KrF (248 nm) excimer pulsed laser (248 nm) and BCl₃ gas are reported in this paper. The doped samples are characterized by the resistance measured using a four-probe method, since the sheet resistance changes with the carrier concentration of the sample. The doping effects with the variation of laser energy density, pulse number, and the pressure of BCl₃ were investigated in terms of the sheet resistance. In this way, the optimized parameters were obtained and used for the positive heavy doping on p-Si(1 0 0) and p-Si(1 1 1). Then, using a square mesh under the above conditions, an image doping was completed. Finally, the metal–semiconductor Ohmic contacts were realized by plating Ag and Cu films on the doped surface.     

Excitons in coupled quantum dots

Properties of excitons in vertically coupled GaAs/AlGaAs quantum dots were investigated using the variational method within the envelope function and effective mass approximations. It was found that when the thickness of the spacer layer becomes less than about one exciton Bohr radius, both the exciton binding energy and the fundamental optical transition energy are reduced compared to those in isolated quantum dots. This is a result of increased space extension of exciton due to the penetration of carrier wave functions into the spacer layer and corresponding reduction in confinement energy which dominates over the Coulomb interaction between the electron and the hole.     

C++QED: an object-oriented framework for wave-function simulations of cavity QED systems

We present a framework for efficiently performing Monte Carlo wave-function simulations in cavity QED with moving particles. It relies heavily on the object-oriented programming paradigm as realised in C++, and is extensible and applicable for simulating open interacting qua ntum dynamics in general. The user is provided with a number of “elements”, e.g. pumped moving particles, pumped lossy cavity modes, and various interactions to compose complex interacting systems, which contain several particles moving in electromagnetic fields of various configurations, and perform wave-function simulations on such systems. A number of tools are provided to facilitate the implementation of new elements.     

有机薄膜器件负电阻特性的影响因素

研究了影响有机染料掺杂聚合物薄膜器件负电阻特性的因素，为探索有机负电阻的机理提供实验依据。实验中制备了多种有机染料掺杂聚合物薄膜器件，研究了有机小分子染料、聚合物基体、薄膜组成及厚度、ITO和聚苯胺阳极等对有机染料掺杂聚合物薄膜器件负电阻特性的影响。在室温、大气环境下，所制备的多种有机染料掺杂聚合物器件在所加电压为3～4V时，观察到明显的负电阻特性，电流峰谷比最大约为8。负电阻现象及峰谷比的大小受膜厚和器件的结构、制备工艺等影响。提出用负电阻和二极管并联组成的等效电路模型解释影响负电阻特性的因素，认为负电阻特性与载流子的不平衡注入有关。在此基础上设计、合成了主链含唔二唑电子传输基团的可溶性聚对苯撑乙烯衍生物，该聚合物兼具空穴和电子传输功能，在空气中具有较稳定的N型负电阻特性。进一步控制相关材料和工艺条件，有可能得到易于控制的负阻效应，开发出新型的有机负电阻器件。     

纳米4-H碳化硅薄膜的掺杂现象

对纳米晶SiC薄膜进行了P和B的掺杂,B掺杂效率比P高,其暗电导预前因子与激活能遵守Meyer-Neldel规则,并有反转Meyer-Neldel规则出现.掺杂效率比非晶态碳化硅薄膜高是纳米碳化硅薄膜的特点之一.非晶态中的隧穿和边界透射对输运有一定贡献.