IPTV系统中媒体数据接收控制的一种实现

IPTV已经成为未来电视及VOD技术发展的方向，系统介绍IPTV系统中数据流接收的一种实现过程，重点是RTP与一个类RTSP协议的配合，实现数据流的接收与控制。     

快速热处理对PECVD氮化硅薄膜性能的影响

利用PECVD在硅片上沉积了氮化硅(SiNx)薄膜,将沉积膜后的样品放在N2气氛中进行快速热处理(RTP),研究了不同快速热处理对PECVD氮化硅薄膜件能的影响.采用原子力显微镜(AFM)检测薄膜的表面形貌,利用椭圆偏振仪测量样品膜厚和折射率,利用准稳态光电导衰减法(QSSPCD)测鼋样品的少子寿命.实验结果表明随着RTP温度的升高,薄膜厚度迅速减小,折射率迅速增大;低于500℃热处理时,少子寿命基本不变;高于500℃热处理时,随着温度的升高,少子寿命急剧下降.氮化硅薄膜经热处理后反射率基本不变.     

The effect of copper content on the reactivity of Cu/Co6Al2 solids in the catalytic steam reforming of methane reaction

The steam reforming of methane over Cu/Co₆Al₂ mixed oxides with different copper contents was studied. The Co₆Al₂ support was prepared via the hydrotalcite route. It was thermally stabilized at 500 °C, impregnated with 5 wt.%, 15 wt.% or 25 wt.% copper using copper (II) nitrate Cu(NO₃)₂·3H₂O precursor and then calcined again at 500 °C under an air flow. The impregnation of copper enhanced significantly the reactivity of the solids in the considered reaction. The 5Cu/Co₆Al₂ solid was the most reactive one, with a methane conversion of 96% at 650 °C. The selectivities of H₂ and CO₂ were also better for the catalyst containing 5 wt.% copper compared to higher copper loadings. The decrease in the catalytic reactivity with increasing the copper content was attributed to the formation of agglomerated and less reactive CuO species, which were detected by XRD and TPR analyses.     

Time‐resolved investigation of Cu(In,Ga)Se2 growth and Ga gradient formation during fast selenisation of metallic precursors

Ga segregation at the backside of Cu(In,Ga)Se₂ solar cell absorbers is a commonly observed phenomenon for a large variety of sequential fabrication processes. Here, we investigate the correlation between Se incorporation, phase formation and Ga segregation during fast selenisation of Cu–In–Ga precursor films in elemental selenium vapour. Se incorporation and phase formation are analysed by real‐time synchrotron‐based X‐ray diffraction and fluorescence analysis. Correlations between phase formation and depth distributions are gained by interrupting the process at several points and by subsequent ex situ cross‐sectional electron microscopy and Raman spectroscopy. The presented results reveal that the main share of Se incorporation takes place within a few seconds during formation of In–Se at the top part of the film, accompanied by outdiffusion of In out of a ternary Cu–In–Ga phase. Surprisingly, CuInSe₂ starts to form at the surface on top of the In–Se layer, leading to an intermediate double graded Cu depth distribution. The remaining Ga‐rich metal phase at the back is finally selenised by indiffusion of Se. On the basis of a proposed growth model, we discuss possible strategies and limitations for the avoidance of Ga segregation during fast selenisation of metallic precursors. Solar cells made from samples selenised with a total annealing time of 6.5 min reached conversion efficiencies of up to 14.2 % (total area, without anti‐reflective coating). The evolution of the Cu(In,Ga)Se₂ diffraction signals reveals that the minimum process time for high‐quality Cu(In,Ga)Se₂ absorbers is limited by cation ordering rather than Se incorporation. Copyright © 2014 John Wiley & Sons, Ltd.     

基于Windows Mobile 5.0的SIP软电话的设计与实现

为实现在Windows Mobile 5.0上利用Internet技术实现语音通话,本文以SIP为基础采用visual studio2005编译器完成了基于Windows Mobile 5.0的SIP软电话功能.文章中介绍了SIP软电话以及Windows Mobile 5.0开发的基本方法,提出了一种基于Windows Mobile 5.0的SIP软电话的具体实现方案,包括开发环境搭建、软电话结构、软电话信令、语音采集、编解码等.     

亚微米自对准硅化物工艺开发

文章对亚微米自对准硅化物制造设备及工艺进行了详细的描述。文中以实际生产为目标, 以实验数据为依据,对影响自对准硅化物薄膜特性的各项工艺参数进行调试和论证,找出合适的RTP1 温度,并开发出适合自对准硅化物薄膜的工艺标准。     

MPTS转多路SPTS的IP输出实现

介绍了一种接收解码器,它是一种广泛应用于三网融合的信源接收设备,它可以将接收到的MPTS多节目传输流转换为多个SPTS单节目传输流,并且通过TS OVER IP的形式将各个节目分别输出到不同的IP主机或端口.详细介绍了整个系统各个模块的功能和实现过程.     

Ni(Pt)Si硅化物温度稳定性的研究

对比研究了夹层结构N i/P t/N i分别与掺杂p型多晶硅和n型单晶硅进行快速热退火形成的硅化物薄膜的电学特性。实验结果表明,在600~800°C范围内,掺P t的N iS i薄膜电阻率低且均匀,比具有低电阻率的镍硅化物的温度范围扩大了100~150°C。依据吉布斯自由能理论,对在N i(P t)S i薄膜中掺有2%和4%的P t样品进行了分析。结果表明,掺少量的P t可以推迟N iS i向N iS i2的转化温度,提高了镍硅化物的热稳定性。最后,制作了I-V特性良好的N i(P t)S i/S i肖特基势垒二极管,更进一步证明了掺少量的P t改善了N iS i肖特基二极管的稳定性。     

基于SIP的Internet电话

文章先给出了基于ＳＩＰ（会话初始化协议）的Ｉｎｔｅｒｎｅｔ电话的协议结构,随后对其中传输数据的ＲＴＰ（实时传输协议）和ＲＴＣＰ（实时传输控制协议）进行了介绍和分析,并对会话初始化协议的组成实体、命名、寻址、操作进行了详细的论述。     

Verification of radiotherapy doses by EPR dosimetry in patients' teeth

The aim of this work was to verify applicability of electron paramagnetic resonance (EPR) ex vivo dosimetry in teeth enamel for determination of doses absorbed by patients during radiotherapy with radiation fields covering head regions and to examine with what accuracy the doses predicted by radiotherapy treatment plan (RTP) can be confirmed by doses measured ex post by the EPR method. The doses were determined in 22 enamel samples obtained from 11 patients who, after their radiotherapy treatment underwent extraction of teeth due to medical reasons. The delivered doses were determined by measuring EPR signals in enamel samples from the extracted teeth; magnitude of these signals is proportional to concentration of stable free radicals induced by radiation in the hydroxyapatite content of enamel. The measured doses were compared with doses planned in the teeth locations by RTP systems. The relation between the measured (D_m) and the planned (D_p) doses can be described as a linear function: D_m = s·D_p + b, with the slope s = 0.93 ± 0.03 and the intercept b = 0.67 ± 1.26. The deviations between the measured and calculated doses were in the (−12.6%, +1.9%) range with the average deviation of – 4.6%. It is concluded, than more accurate measurements, achievable when using a higher calibration dose than in the present study, are necessary to confirm or to deny the observed bias between the measured and planned doses.