声诱饵仿真试验系统

文章介绍了声诱饵仿真试验系统中的有关问题，包括：系统的组成、工作原理、对接装置结构等。建立了对接装置声耦合状态下的数学模型，对近场声压分布进行了仿真计算，得出了匹配材料厚度、发射和接收换能器的选取原则。     

Si_（1－x）Ge_x／Si定向耦合器的研制

在运用ＳｉＧｅ脊形波导单模条件和有效折射率法分析ＳｉＧｅ／Ｓｉ定向耦合器结构参数的基础上，采用分子束外延和各向异性腐蚀技术制备出Ｓｉ１－ｘＧｅｘ／Ｓｉ（ｘ＝０．０５）单模定向耦合器．在波长为１．３μｍ时，平均串音小于－１８．１ｄＢ，输出功率耦合效率达到９８．１％     

An ASE Reduction Filter Using Cascaded Optical Fiber Grating Couplers in EDFA Repeater

A new configuration for an ASE reduction filter in EDFA repeaters for WDM optical transmission systems using optical fiber grating couplers (FGCs) was proposed and first demonstrated. The filtering characteristics of the proposed filter for amplified single wavelength signal and 2-channel WDM signals using EDFA were identified. It was found that the filter was effective to improve SNR in optical domain by reducing ASE noise. The required FGC characteristics for the filter were theoretically predicted under the condition that the total filter loss did not exceed 3 dB. More than 70% of drop efficiency was required in each FGC for the application of the proposed filter to an 8-channel WDM system using EDFA repeaters.     

正方分布的4×4单模光纤熔锥耦合器耦合特性分析

本文以线性耦合波方程为基础,采用散射矩阵的方法讨论了具有正方分布的4×4单模光纤熔锥形耦合器的耦合特性,并与实验作了比较,得到了比较一致的结果。     

差分无源器件的设计

在现代无线通信系统中,差分电路相比单端电路而言具有更强的抗干扰能力,因此受到了国内外学者的广泛关注。文章介绍了混合模散射参数、差分器件设计中常用的微带线和缝隙线及两种传输线之间的相互转化,并介绍了基于微带线和缝隙线转换结构的两种全差分带通滤波器。两种滤波器分别实现了多频段和宽带的差模传输特性以及宽带的共模抑制特性。文章还给出了差分耦合器、差分功分器和差分天线等差分器件的设计。仿真与实测结果吻合较好,验证了设计方法的正确性。     

Mode selective directional couplers for overmoded waveguide systems

Two types of directional couplers for transverse electric (TE) modes are described: short and multihole couplers, respectively. They selectively pick one mode out of a mode mixture in an overmoded circular waveguide system. Unwanted modes are either statistically kept at low level or are suppressed by destructive interference in the coupling waveguide. Mode selectivity and directivity in multihole couplers oscillate up and down with an increasing number of holes, finally reaching a minimum of approximately 20 dB, unless there are competing modes with rational fractions of the beat wavelength. A multihole coupler for the TE₀₂ mode (28 GHz, 63.4 mm waveguide diameter, 41 holes) and a length of 1.6 m shows a calculated directivity of 68 dB and suppresses the unwanted modes TE₀₁ with 34 dB (24 dB), TE₂₂ with 37 dB (45 dB), and further modes TE_m (<5, m<6) with 17 dB to 34 dB in forward direction (figures in parentheses are for unwanted modes propagating in backward direction).A short directional coupler for the TE₀₁ mode (28 GHz, 63.4 mm waveguide diameter) with 16 holes and a length of 230 mm shows a directivity of 55 to 100 dB between 27.9 and 28.1 GHz, suppressing the TE₀₂ mode with 35 to 80 dB, the TE₀₃ mode with 30 to 65 dB, and the TE₂₂ mode with 30 to 70 dB.     

一种改进的2×2 SOI Mach-Zehnder热光开关

本文设计并制作了基于强限制多模干涉耦合器的2×2 SOI马赫-曾德热光开关.这种光开关采用了深刻蚀结构的多模干涉耦合器和输入/输出波导,较大地提高了干涉耦合器的性能并减少了连接耦合损耗.同时,在调制臂区域采用浅刻蚀结构,保持其单模调制状态.深刻蚀多模干涉耦合器具有优越的特性,在实验中测得不均衡度只有0.03 dB,插入损耗－0.6 dB.基于这种耦合器的新型热光开关,其插入损耗为－6.8 dB,其中包括光纤-波导耦合损耗－4.3 dB,开关时间为6.8 μs.     

基于正交定向耦合器组合的微波功率测量方法

定向耦合器广泛应用于微波系统的功率测量.但定向耦合器的方向隔离度有限,两个方向的耦合输出信号存在一定程度地串扰,影响功率测量的准确性.为了解决这一问题,本文提出一种正交耦合测量方法.该方法采用一对相位差为90°的定向耦合器同时测量功率,通过对测量结果的计算处理,可消除方向串扰的影响.推导了正反向传输功率与正交耦合器组合功率测量值的关系,分析了正交偏差所产生的误差.为了确定耦合器的正交状态,提出了一种准确测量两个定向耦合器之间相位差的方法.实测表明正交耦合方法可有效提高功率和驻波比测量的准确性.     

光纤双折射和耦合器偏振性对环形腔的影响

本文应用琼 斯矩阵分析了光纤的线性双折射和耦合器的偏振性对光纤环形腔特性的影响,光纤的线性双白射和耦合器的偏振性使普通单模光纤环形腔带阻输出特性中的谐振峰分裂为两组,相应的谐振频率发生偏移,偏移量正比于双折射的大小和耦合器的偏振参数。两组谐振峰的相对幅度取决于输入偏振态。调整输入偏振态为Ｘ、Ｙ两线偏振态之一时,就仅出现一组谐振峰。环形腔的精细度与光纤的线性双折射无关,但爱耦合器偏振性的影响。     

高功率微波选模定向耦合器的设计制作

本文根据弱耦合函数理论，设计制作了圆波导ＴＭ０ｎ到３ｃｍ波段矩形波导ＴＥ１０模的选模定向耦合器用于高功率微波的测量系统，理论设计与实际测量结果与理论吻合较好 。