一种北斗联合低轨星座的导航增强方法研究

单纯依靠北斗导航系统提供定位导航授时服务,存在卫星信号落地功率低、易受遮蔽和阻断的不足。针对此问题,研究了一种北斗联合低轨星座实现导航增强的系统架构;提出了一种新的适应严重遮蔽或干扰条件下,基于到达时间(TOA)和到达频率(FOA)联合观测的定位解算算法;对高中低轨混合星座条件下的覆盖特性和精度衰减因子进行了仿真分析。分析结果表明,用户可见星数平均增加了64.2%,位置精度衰减因子(PDOP)平均改善了28.7%。研究结果可为下一代北斗的论证设计与研制建设提供参考借鉴。     

Compiler compatible 5.66 Mb/mm2 8T 1R1W register file in 14 nm FinFET technology

1-read/1-write (1R1W) register file (RF) is a popular memory configuration in modern feature rich SoCs requiring significant amount of embedded memory. A memory compiler is constructed using the 8T RF bitcell spanning a range of instances from 32 b to 72 Kb. An 8T low-leakage bitcell of 0.106 μm² is used in a 14 nm FinFET technology with a 70 nm contacted gate pitch for high-density (HD) two-port (TP) RF memory compiler which achieves 5.66 Mb/mm² array density for a 72 Kb array which is the highest reported density in 14 nm FinFET technology. The density improvement is achieved by using techniques such as leaf-cell optimization (eliminating transistors), better architectural planning, top level connectivity through leaf-cell abutment and minimizing the number of unique leaf-cells. These techniques are fully compatible with memory compiler usage over the required span. Leakage power is minimized by using power-switches without degrading the density mentioned above. Self-induced supply voltage collapse technique is applied for write and a four stack static keeper is used for read Vmin improvement. Fabricated test chips using 14 nm process have demonstrated 2.33 GHz performance at 1.1 V/25 °C operation. Overall V_min of 550 mV is achieved with this design at 25 °C. The inbuilt power-switch improves leakage power by 12x in simulation. Approximately 8% die area of a leading 14 nm SoC in commercialization is occupied by these compiled RF instances.     

嵌人式与独立存储器设计上的差异分析和研究

进入21世纪,随着集成电路的发展,SoC(System on Chip)片上系统应运而生。而作为SoC重要组成部分的嵌入式存储器,在SoC中所占的比重正逐步增加,并起着越来越重要的作用,那么嵌入式存储器与独立的存储器芯片在设计上存在着哪些差异?对此本文将以NOR型闪存为例在制造工艺的选取、衍生产品的设计、功耗与噪声、后端功能仿真、测试与修复等方面进行分析和研究。     

服务质量测量技术及其应用

文章在概述服务质量测量技术的基础上，介绍了服务质量测量技术的服务质量性能评估、网络推测、网络定位等应用，并给出了服务质量测量的一般数学模型。     

计费帐务系统发展趋势分析

计费帐务系统作为业务运营支撑系统的重要组成部分。其发展方向日益受到运营商的关注。通过对计量帐务系统的研究，首先介绍了传统计费模式的现状以及存在的问题，然后结合各大公司产品对计责帐务系统的关键技术进行了分析，最后提出未来计费帐务系统的特征及对其发展趋势的展望。     

构建媒体网络信息安全体系

通过对广州市电视台综合信息平台网络系统的应用现状及安全风险进行分析,提出基于网络层、系统层、用户层和安全策略管理全方位的网络信息安全体系.     

提高托盘利用效率的重要手段——电子信息化管理

托盘能否有效运用对物流的畅通与否关系重大,这已经引起了国内外专家和学者们的重视,并就此制定了托盘电子信息化管理系统,旨在更合理地使用托盘,推进托盘一体化和共用系统的建立。而RFID技术在托盘的电子信息化管理的应用更将大大提高物流的效率与准确性,托盘电子信息化管理将成为今后托盘管理的趋势。     

Quality of Service in VoIP Communication

The focus of this paper lies in the practical aspects of voice over IP communication. VoIP configurations in the H.323 standard will be presented briefly. Following that, the fundamental protocol procedure of H.323 communication will be briefly explained. A further part of the paper will address the subject QoS (quality of service), and present the common measurement methods used in QoS. Results gained from experiments conducted in a VoIP environment will then follow. The investigations concentrate primarily on the load behavior of voice packets in relation to important parameters of this service. The results obtained are presented and evaluated in diagrams. The paper concludes with a summary.     

实时硬件系统中控制方法的研究

由于实时硬件系统的规模和复杂度不断增大，系统结构的模块化设计已成为硬件系统开发的发展趋势。研究了硬件系统中模块控制的方法和特点。结合MPEG2电视编码器中各功能模块的特点，提出了适合该硬件系统的模块控制方案，说明了控制模块的硬件设计思想和软件实现。实践证明，该方案满足系统实时性和可靠性的设计要求。     

从微电子到"活动的硅"--系统集成的未来潜力

本文主要介绍微电子发展趋势、微电子与微机械结合、系统集成的未来潜力。