Resistivity－temperature characteristics of sol gel YBa2Cu3Oy samples synthesized in flowing oxygen atmosphere

The relationship of resistivity versus synthesizing temperature of sol gel YBa_2Cu_3O_y samples was studied when prepared under flowing oxygen conditions. A set of high-temperature ρ－T curves was obtained for the whole process. After the sample finished the test measuring, its resistivity was ρ_{300}=9.83×10^{-3 }Ω·cm at room temperature. The ρ－T curve also showed that the orthorhombic－tetragonal phase transformation of sol-gel YBa_2Cu_3O_y sample occurred at 581℃ for the sample in the rising temperature process, but at 613℃ in the cooling process, lower than that of the samples made by using the conventional powder metallurgy methods.     

Epoxy based coatings on glass: strengthening mechanisms

Glass may be strengthened by epoxy coatings although the strengthening mechanisms remain unclear. Possible strengthening mechanisms are reviewed and are used to analyse strength data for both a solvent based and a water based coating system. The coatings either fill (solvent based coatings), or partially fill (water based coatings) surface cracks and it is shown that closure stresses arising from the thermal expansion mismatch of the coating within these cracks can account for the observed degrees of strengthening. It is also demonstrated that other suggested mechanisms such as flaw healing cannot fully account for the observed degree of strengthening.     

Size exclusion chromatographic determination of hydroxypropyl methyl cellulose and polyethylene glycol 400 in an ophthalmic solution

Summary Hydroxypropyl methyl cellulose (HPMC) and polyethylene glycol 400 (PEG 400) content in HypoTears™ Daily Dose ophthalmic solution are determined simultaneously by size exclusion chromatography. The retention times of HPMC and PEG 400 are 10.6 and 15.4 minutes, respectively. The method requires minimal sample pretreatment and is accurate and reproducible. The peak area response from a refractive index detector versus HPMC and PEG 400 concentration is linear over the range of 50–150 % of their label claims of 2.5 mg/mL and 10 mg/mL, respectively. The mean absolute recoveries of HPMC and PEG 400 at their label claim using the described method are 98.9±1.3 % and 100.4±1.2 % (mean±SD, n=12), respectively.     

荫罩黑化及DX气与煤气成分的探讨

本文介绍了彩色显像管荫罩黑化反应的机理,详细说明了DX气制气流程,以及DX气的成分对黑化膜品质的影响。计算分析了成分不同的煤气在制成DX气时的成分变化。同时还分析了黑化工艺和黑化设备对煤气成分波动的适应性,及在生产实践中改变DX气制气时的煤气空气对黑化膜质量的影响。     

Effect of local alloy disorder on the emission kinetics of deep donors (DX centers) in AlxGa1-xAs

In this paper we summarize our recent studies of the effects of local alloy disorder on the properties ofDX levels. A single emission rate is observed in GaAs where all Si-donors have identical local environments. In contrast, three discrete emission rates are observed in dilute AlGaAs alloys, suggesting that the group IV donor moves towards the interstitial site, thereby “selecting” three of the twelve surrounding group III atoms. We present evidence for an ordering of theDX levels consistent with Morgan’s model of a deepening potential well for theDX level as Al atoms are subsequently substituted for Ga atoms near the relaxed donor. These conclusions are consistent with earlier calculations of Chadi and Chang.     

分组交换网上的增值业务

本文介绍了公用和专用分组交换数据网的现状后，说明了开展标准的增值业务系统的重要性。论述了典型的增值业务系统－电子邮件和传真存储转发系统。     

Influence of relaxation effects on probabilities of the 2s2p35S2－2s22p2 3P1，2 intercombination transitions in NII

Transition probabilities of the 2s2p^3 {}^5S_2－2s^22p^2 {}^3P_{1,2} intercombination transitions in NII have been calculated by using a large-scale multiconfiguration Dirac－Fock method. In the calculation the most important effects of relativity, correlation, and relaxation are considered. From the calculated transition probabilities, the lifetime of the 2s2p^3 {}^5S_2 metastable state is derived. The result is in excellent agreement with the latest experimental result. In the meantime the influence of anomalously strong relaxation effects on probabilities of the 2s2p^3 {}^5S_2－2s^22p^2 {}^3P_{1,2} lines in NII have been found.     

Ohmic contact and transport properties of II–VI Green/Blue laser diodes

The employment of the Zn(Se,Te) pseudo-graded contacting scheme to p-type ZnSe-based alloys contributes directly to the recent demonstration of room temperature continuous-wave operation of II– VI green-blue laser diodes. Contact ohmicity is maintained down to cryogenic temperatures which enabled the investigation of electrical transport properties associated with the p-type nitrogen-doped ZnSe, Zn(S,Se), and (Zn,Mg)(S,Se). The observation of both persistent photoconductivity and a metastable population of holes which are in thermodynamic equilibrium with hydrogenic acceptors having reduced activation energy suggests the presence of a DX-like behavior for holes in p-type (Zn,Mg)(S,Se).     

Synthesis and characterization of segmented liquid crystal poly(azoxy polyester-co-polyoxypropylene)

In this study a series of a segmented copolyester, poly(4,4′-dioxy-2,2′-dimethyl-azoxybenzene dodecanedioyl) (PMABD)-co-polyoxypropylene 400 (POP), was prepared. The chain length of PMABD studied (n) was varied from 7.8-18.2, and that of POP was unchanged. The intrinsic viscosity of the segmented copolyesters was 1.04-1.30, and the number average molecular weight obtained was 2.53 × 10⁴?3.49 × 10⁴ g/mol. The mesophase texture and thermal properties of the segmented copolyesters were measured as functions of n. It was found that the insert of flexible POP between those liquid crystalline domains of PMABD did affect thermotropic properties of PMABD. As the n value was 9.0 and 7.8 (or 7.4 and 8.6% by weight POP) the texture appeared as cholesteric-like oily streaks. The effect could not be attained by simply copolymerizing a mesogenic moiety with a pair of spacers of different lengths. The fluidity and domain structure of the flexible dodecanedioyl-POP-dodcanedioyl segments are taken into account for the obtained results. © 1995 John Wiley & Sons, Inc.     

Volume and heat capacity of model non-aqueous self-assembly systems

Blends of immiscible polymers are often stabilized by block copolymers which can form non-aqueous micelles and microemulsions in the liquid polymers. The phase diagrans, apparent volumes and apparent heat capacities of model non-aqueous binary and ternary systems were studied in order to investigate the conditions under which such self-assembly systems could form. 1,2-Hexanediol, which can cosolubilize hexane and ethyleneglycol, forms inverse micelles in hexane and weak microaggregates in ethyleneglycol. Genapol X-060, a commercial alcoholic surfactant containing on the average an aliphatic chain of 13 carbons and 6 oxyethylenes (C₁₃E₆), forms microaggregates in poly(ethyleneglycol) 400. These self-assembly systems are strengthen in the presence of a third component which has an affinity for the inner phase.Presented at the Symposium, 76^th CSC Congress, Sherbrooke, Quebec, May 30–June 3, 1993, honoring Professor Donald Patterson on the occasion of his 65^th birthday.