Improved error performance for generalised spatial modulation with enhanced spectral efficiency

The existing analytical average bit error rate (ABER) expression of conventional generalised spatial modulation (CGSM) does not agree well with the Monte Carlo simulation results in the low signal‐to‐noise ratio (SNR) region. Hence, the first contribution of this paper is to derive a new and easy way to evaluate analytical ABER expression that improves the validation of the simulation results at low SNRs. Secondly, a novel system termed CGSM with enhanced spectral efficiency (CGSM‐ESE) is presented. This system is realised by applying a rotation angle to one of the two active transmit antennas. As a result, the overall spectral efficiency is increased by 1 bit/s/Hz when compared with the equivalent CGSM system. In order to validate the simulation results of CGSM‐ESE, the third contribution is to derive an analytical ABER expression. Finally, to improve the ABER performance of CGSM‐ESE, three link adaptation algorithms are developed. By assuming full knowledge of the channel at the receiver, the proposed algorithms select a subset of channel gain vector (CGV) pairs based on the Euclidean distance between all CGV pairs, CGV splitting, CGV amplitudes, or a combination of these.     

Investigation of mononuclear,dinuclear, and trinuclear transition metal (II) complexes derived from an asymmetric Salamo‐based ligand possessing three different coordination modes

A new asymmetric Salamo‐based ligand H₂L was synthesized using 3‐tert‐butyl‐salicylaldehyde and 6‐methoxy‐2‐[O‐(1‐ethyloxyamide)]‐oxime‐1‐phenol. By adjusting the ratio of the ligand H₂L and Cu (II), Co (II), and Ni (II) ions, mononuclear, dinuclear, and trinuclear transition metal (II) complexes, [Cu(L)], [{Co(L)}₂], and [{Ni(L)(CH₃COO)(CH₃CH₂OH)}₂Ni] with the ligand H₂L possessing completely different coordination modes were obtained, respectively. The optical spectra of ligand H₂L and its Cu (II), Co (II) and Ni (II) complexes were investigated. The Cu (II) complex is a mononuclear structure, and the Cu (II) atom is tetracoordinated to form a planar quadrilateral structure. The Co (II) complex is dinuclear, and the two Co (II) atoms are pentacoordinated and have coordination geometries of distorted triangular bipyramid. The Ni (II) complex is a trinuclear structure, and the terminal and central Ni (II) atoms are all hexacoordinated, forming distorted octahedral geometries. Furthermore, optical properties including UV–Vis, IR, and fluorescence of the Cu (II), Co (II), and Ni (II) complexes were investigated. Finally, the antibacterial activities of the Cu (II), Co (II), and Ni (II) complexes were explored. According to the experimental results, the inhibitory effect was found to be enhanced with increasing concentrations of the Cu (II), Co (II), and Ni (II) complexes.     

Crosslinking network of bio‐based bis‐functional epoxides derived from trans‐limonene oxide

The thiol‐ene reaction between trans‐limonene oxide (trans‐LO) and ethane‐1,2‐dithiol in the presence of triethylborane affords a bio‐based bis‐functional epoxide (bis‐trans‐LO). The crosslinking reaction of bis‐trans‐LO with branched polyethyleneimine (BPEI; M_n = 600; BPEI₆₀₀) at a feed ratio of bis‐trans‐LO/BPEI₆₀₀ = 57/43 (wt/wt) yields the corresponding network polymer with T_d10 (10% thermal decomposition temperature) of 304.7 °C in 98% yield. In contrast, negligible amounts of network polymer are obtained by the reaction of bis‐LO (bis‐functional epoxide derived from cis and trans‐LO) and BPEI₆₀₀ regardless of the feed ratio. The mechanical strengths as measured by direct tensile tests of the network polymers derived from bis‐trans‐LO and BPEI_600,1800 (M_n = 600 and 1800) were approximately 16 and 11 times higher than that of bis‐LO and BPEI₁₈₀₀, respectively. The tensile shear strengths of the metal‐to‐metal adhesive bonds induced by bis‐trans‐LO and BPEI_600,1800 were 9.5 and 14.1 MPa, respectively. DMA revealed that the storage modulus of the network polymer derived from bis‐trans‐LO and BPEI₁₈₀₀ in the rubber region was higher than that of the material prepared from bis‐LO and BPEI₁₈₀₀, indicating higher crosslink density of the bis‐trans‐LO/BPEI₁₈₀₀ system. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2019 , 57, 2466–2473     

Effective Location Based Services with Dynamic Data Management in Mobile Environments

With the proliferation of mobile computing technologies, location based services have been identified as one of the most promising target application. We classify mobile information service domains based on feature characteristics of the information sources and different patterns of mobile information access. By carefully examining the service requirements, we identify the dynamic data management problem that must be addressed for effective location based services in mobile environments. We then devise a general architecture and cost model for servicing both location independent and location dependent data. Based on the architecture and cost model, we propose a set of dynamic data management strategies that employs judicious caching, proactive server pushing and neighborhood replication to reduce service cost and improve response time under changing user mobility and access patterns. Detail behavior analysis helps us in precisely capturing when and how to apply these strategies. Simulation results suggest that different strategies are effective for different types of data in response to different patterns of movement and information access. Shiow-yang Wu is an associate professor of the Department of Computer Science and Information Engineering at National Dong Hwa University, Hualien, Taiwan, R.O.C. He received the BS and MS degrees in computer engineering from National Chiao Tung University, Hsinchu, Taiwan, ROC, and the PhD degree in computer science from the University of Texas at Austin in 1984, 1986, and 1995, respectively. His research interests include data/knowledge bases, mobile computing, distributed processing, intelligence information systems, and electronic commerce. Kun-Ta Wu was born in Taipei, Taiwan, R.O.C., in 1976. He received the B.S. degree in computer science from Soochow University, Taipei, Taiwan, R.O.C., in 1999 and the M.S. degree in computer science and information engineering from National Dong Hwa University, Hualien, Taiwan, R.O.C., in 2001. Currently, he is an Assistant Researcher in the Domestic Division at Science and Technology Information Center, National Science Council, R.O.C., as a member of Information Gathering and Analysis Group of National Information and Communication Security Taskforce. His research interests include mobile computing, wireless network and information security.     

积层板的制造方法

概述了积层板的开发背景、制造工艺和最近的开发动向。     

一种智能型的PCB产业需求预测方法

目前需求预测在整个印制电路板产业的生产活动控制中正扮演着越来越重要的角色。分析了影响印制电路板需求的因素和现有的预测方法,提出了一种适用于PCB产业需求预测的有效方法——遗传/BP—神经网络。实验表明该方法能够进一步改善印制电路板预测的准确度和减少生产成本的消耗。     

车载电子设备机柜布线工艺设计

对电子机柜传统的走线方式进行了分析、解剖，提出了新的走线方案模式，从工艺角度对机柜走线结构进行了改进设计，使之更适合于车载机柜的布线要求。     

微波陶瓷基印制板制造工艺性研究

对微波陶瓷基印制板的制造工艺流程进行了简单的介绍,对所采用的工艺技术的有效性进行了较为详细的论述。     

对基于交换网络分层结构的软件无线电方案的改进

通过比较各种软件无线电结构的优缺点,针对既具有交换网络结构又具有分层结构优点的基于交换网络的分层无线电结构方案,提出了部分改进思想。