全文获取类型
收费全文 | 1646篇 |
免费 | 160篇 |
国内免费 | 247篇 |
专业分类
化学 | 573篇 |
晶体学 | 1篇 |
力学 | 87篇 |
综合类 | 1篇 |
数学 | 87篇 |
物理学 | 360篇 |
无线电 | 944篇 |
出版年
2024年 | 11篇 |
2023年 | 56篇 |
2022年 | 42篇 |
2021年 | 71篇 |
2020年 | 49篇 |
2019年 | 29篇 |
2018年 | 36篇 |
2017年 | 65篇 |
2016年 | 57篇 |
2015年 | 51篇 |
2014年 | 90篇 |
2013年 | 132篇 |
2012年 | 84篇 |
2011年 | 119篇 |
2010年 | 87篇 |
2009年 | 109篇 |
2008年 | 103篇 |
2007年 | 104篇 |
2006年 | 124篇 |
2005年 | 87篇 |
2004年 | 61篇 |
2003年 | 68篇 |
2002年 | 61篇 |
2001年 | 38篇 |
2000年 | 40篇 |
1999年 | 33篇 |
1998年 | 28篇 |
1997年 | 29篇 |
1996年 | 47篇 |
1995年 | 23篇 |
1994年 | 18篇 |
1993年 | 23篇 |
1992年 | 18篇 |
1991年 | 17篇 |
1990年 | 12篇 |
1989年 | 11篇 |
1988年 | 6篇 |
1987年 | 2篇 |
1986年 | 1篇 |
1985年 | 2篇 |
1984年 | 1篇 |
1982年 | 1篇 |
1981年 | 1篇 |
1979年 | 1篇 |
1978年 | 1篇 |
1971年 | 1篇 |
1970年 | 2篇 |
1967年 | 1篇 |
排序方式: 共有2053条查询结果,搜索用时 8 毫秒
1.
CMOS光接收机主放大器设计 总被引:1,自引:0,他引:1
利用CMOS工艺设计一种用于SDH STM 4速率级(622 Mb/s)光纤用户网的光接收机放大电路。此电路由输入/输出缓冲、主放大单元、偏置补偿电路4部分组成。通过直接耦合技术提高增益,降低功耗;利用有源电感负载提高系统带宽。采用商用SmartSpice电路仿真软件和CSMC HJ 0.6μm工艺参数对该电路进行仿真。结果表明,该电路在5 V工作电压下中频增益为81 dB,3 dB带宽为470 MHz。 相似文献
2.
José E. Valdés 《Operations Research Letters》2006,34(1):49-52
Components C1 and C2 form a series system. Suppose we can allocate the spare R1 in parallel with C1 and the spare R2 in parallel with C2, or otherwise, allocate R1 with C2 and R2 with C1. In this paper, we compare these two options using hazard rate ordering. 相似文献
3.
4.
自动线性跟踪Butterworth有源滤波器研究 总被引:2,自引:0,他引:2
滤波是通信、测试、数据采集和实时控制等领域至关重要的环节。通常的模拟滤波器,由于截止频率固定,在某些宽频率动态范围且有实时性要求的应用场合,往往达不到预期的滤波效果,有时甚至影响整个系统的正常运行。本文从有源滤波器的机理分析入手,提出了一种由单片机参与的滤波系统,它能自动跟踪输入信号频率,线性地选择合适的滤波器截止频率,弥补了原有滤波器的不足。 相似文献
5.
N. Segovia M. A. Armienta C. Valdes M. Mena J. L. Seidel M. Monnin P. Pea M. B. E. Lopez A. V. Reyes 《Radiation measurements》2003,36(1-6):379-383
Soil radon has been monitored at two fixed stations in the northern flank of Popocatepetl Volcano, a high risk volcano located 60 km SE from Mexico City. Water samples from three springs were also studied for radon as well as major and trace elements. Radon in the soil was recorded using track detectors. Radon in the water samples was evaluated using the liquid scintillation method and an Alphaguard. The major elements were determined through conventional chemical methods and trace elements using an ICP-MS equipment. Soil radon levels were low, indicating a moderate diffuse degassing through the flanks of the volcano. Groundwater radon had almost no relation with the eruptive stages. Water chemistry was stable in the reported time (2000–2002). 相似文献
6.
A surface-mounted device assembly technique for small optics based on laser reflow soldering 总被引:4,自引:0,他引:4
L. Stauffer A. Würsch B. Gchter K. Siercks I. Verettas S. Rossopoulos R. Clavel 《Optics and Lasers in Engineering》2005,43(3-5):365
The three-dimensional miniaturized optical surface-mounted device (TRIMO-SMD) is a new flexible and automated assembly technique for small optical components (maximum diameter for a lens is 2 mm) based on laser reflow soldering technique. This technology can be compared to the electronic SMD technique but applied to micro-optical devices. We present some recent developments of TRIMO-SMD in its application to industrial products. 相似文献
8.
Dai Lu David Rutledge Milan Kovacevic Jon Hacker 《International Journal of Infrared and Millimeter Waves》2002,23(5):693-704
This paper presents an active patch array designed at 24 GHz. It can be used as a front-end component for a phased array. A series resonant array structure is chosen which is compact and easy excite. With 5 elements, the array proved a 12-dB antenna gain. A power amplifier and a low noise amplifier are designed on a single GaAs chip (PALNA). Bias switch is used in the PALNA, which greatly reduces the switch loss in a transceiver and increases the efficiency. 20-dB small signal gain is achieved in both power amplifier and low noise amplifier. The active patch array is built by the combination of the patch array and PALNA. The measured active gain of this antenna is 35-dB for the PA mode and 31-dB for the LNA mode. This active patch array can obtain an EIRP of 34 dBm with a total radiated power of 22dBm and a maximum PAE of 32%. To check the noise performance, we applied sources at both normal temperature and 77K (liquid nitrogen) and extracted the noise figure (3.5 dB) of the active antenna by the Y factor method. The results proved that the active antenna is working efficiently as both a transmitting and receiving antenna. 相似文献
9.
This paper presents an electromechanical wheel suspension, where the upper arm of the suspension has been provided with an electric levelling and a damper actuator, both are allowed to work in a fully active mode. A control structure for the proposed suspension is described. The complex design task involving the control of the electric damper and its machine parameters is tackled by genetic optimisation. During this process, these parameters are optimised to keep the power dissipation of the electric damper as low as possible, while maintaining acceptable comfort and road-holding capabilities. The results of the evaluations carried out demonstrate that the proposed suspension can easily adopt its control parameters to obtain a better compromise of performance than that offered by passive suspensions. If the vehicle is to maintain acceptable performance during severe driving conditions, the damper has to be unrealistically large. However, if the electric damper is combined with a hydraulic damper, the size of the electric damper is significantly reduced. In addition, the design of the electric damper with the suggested control structure, including how it regenerates energy, is discussed. 相似文献
10.
X. Y. You 《Heat and Mass Transfer》2003,40(1-2):75-81
Active feedback control for the onset of Rayleigh-Bénard Convection in temperature-dependent-viscosity liquids is investigated.
In this paper, three major problems are addressed: (1) The results of Tang-Bau control are improved by considering the effects
of temperature-dependent viscosity; (2) A more efficient two-plate control strategy is presented. A phenomenon of coalescence
of the unstable modes is observed as the controller gain is large enough; (3) A simple way to estimate the critical Rayleigh
number under the effects of temperature-dependent viscosity is described. Numerical results show that the effects of temperature-dependent
viscosity on the critical Rayleigh number should be taken into account in some cases and the onset of Rayleigh-Bénard convection
can be effectively delayed or advanced by the active feedback control strategies studied here. 相似文献