全文获取类型
收费全文 | 1708篇 |
免费 | 305篇 |
国内免费 | 272篇 |
专业分类
化学 | 681篇 |
晶体学 | 47篇 |
力学 | 53篇 |
综合类 | 13篇 |
数学 | 1篇 |
物理学 | 497篇 |
无线电 | 993篇 |
出版年
2024年 | 7篇 |
2023年 | 39篇 |
2022年 | 36篇 |
2021年 | 55篇 |
2020年 | 36篇 |
2019年 | 42篇 |
2018年 | 35篇 |
2017年 | 55篇 |
2016年 | 51篇 |
2015年 | 65篇 |
2014年 | 107篇 |
2013年 | 87篇 |
2012年 | 90篇 |
2011年 | 102篇 |
2010年 | 103篇 |
2009年 | 106篇 |
2008年 | 109篇 |
2007年 | 77篇 |
2006年 | 77篇 |
2005年 | 83篇 |
2004年 | 88篇 |
2003年 | 86篇 |
2002年 | 82篇 |
2001年 | 59篇 |
2000年 | 50篇 |
1999年 | 47篇 |
1998年 | 50篇 |
1997年 | 54篇 |
1996年 | 56篇 |
1995年 | 54篇 |
1994年 | 56篇 |
1993年 | 50篇 |
1992年 | 52篇 |
1991年 | 42篇 |
1990年 | 43篇 |
1989年 | 38篇 |
1988年 | 4篇 |
1987年 | 5篇 |
1986年 | 3篇 |
1985年 | 1篇 |
1984年 | 1篇 |
1983年 | 1篇 |
1982年 | 1篇 |
排序方式: 共有2285条查询结果,搜索用时 613 毫秒
1.
对石英音叉增强型光声光谱(QEPAS)系统中常用的石英音叉进行了有限元模态计算,获得石英音叉前6阶振型与模态频率,认知了第4阶对称摆动振型为有效振动,利用单因素法分析了石英音叉的音臂长度l1、音臂宽度w1、音臂厚度t、音臂切角θ、音臂圆孔直径d及音臂圆孔高度h对低阶有效共振频率(Fre)的影响,敏感度依次为: l1> w1>d>θ>t>h,考虑实际设计情形,筛选出了l1,w1,d与h四个石英音叉设计变量,采用Box-Behnken实验设计方案与RSM(response surface methodology)方法,以Fre为函数目标,建立l1,w1,d与h的二次回归响应面模型,得到了参数之间的交互作用,利用Design-Expert软件对响应面模型进行设计参数反求,结果表明,在15 000 Hz≤Fre≤25 000 Hz计算区域内误差较小,基本满足QEPAS系统的计算需求,所提出的研究与设计方法具有一定通用性,可为QEPAS系统中石英音叉结构参数设计提供参考。 相似文献
2.
本文简要叙述利用流变仪对覆铜箔层压板生产工序中的胶液和半固化片参数进行控制,从而更好地保证胶液和 半固化片性状的一致性,以有利于控制板材流胶和品质。 相似文献
3.
4.
本文概述了石英晶体元件采用国际标准的情况,简要分析了IEC1178:IECQ石英晶体元件规范,根据我国压电行业标准化实际情况,提出了进一步开展采用国际标准工作的意义。 相似文献
5.
叙述了真空蒸发金属膜的形成过程和膜层结构,运用金属原子迁移理论分析了挠性力平衡力速度传感器石英摆片导带“断裂”故障,提出了增强可靠性的技术途径。 相似文献
6.
7.
本文进一步讨论了我们新近提出的等近邻数键球谐函数方法,并通过分子动力学模拟研究了熔融LiCl及其急冷过程。对计算机模拟各时间步产生的瞬态构型进行平均,计算了不同温度下键序Ql谱.将模拟Ql谱与线性组合模型Ql谱比较,观察到模拟Ql谱与含90%局部正四面体结构的组合模型十分相似,表明熔融Licl及其急冷非晶中局部键取向序明显倾向于正四面体序。急冷过程中不同温度下局部键取向序可用同一线性组合模型描述,但模型方差随模拟温度明显变化。方差随温度而降低,且在发生玻璃态转变时有一显著下降。不同温度下的键角分布也作了计算,观察到键角分布在109°(正四面体局部结构键角)附近且分布峰随温度升高而展宽,与键序Ql得到的结论一致。 相似文献
8.
9.
《声学学报:英文版》2003,22(4):339-345
The properties of Quasi-longitudinal leaky surface acoustic wave(QLLSAW) on Y-rotated cut quartz substrates were presented. The phase velocity of QLLSAW on the quartz substrate along some orientations can be up from 6200 m/s to 7100 m/s, circa 100% above that of regular SAW. Both theoretical and experimental results show that QLLSAW propagating along some promising orientations for SAW devices are of small power flow angle and low tem-perature coefficient, for example, along the Euler angle (0°155.25°? 42°?, the measurements of phase velocity and temperature coefficient of delay of QLLSAW are 6201 m/s and 12.9 ppm/℃. The experimental results show that QLLSAW had little absorption by liquid loading on the substrate surface, which proved that the direction of particle motion is the same as wave vector and parallel to the surface of the substrates, i.e., the wave is of the properties of longitudinal wave. 相似文献
10.
We investigate magnetic and crystalline microstructures of melt-spun (Fe0.675Pt0.325)100-xBx (x=12, 14, 16, 18,20) nanocomposite ribbons after optimal thermal treatment using a magnetic force microscope. The magnetic microstructures are characterized by darker spots adjacent to brighter ones in a sub-micro scale and in random distribution. It is found that the strength of the exchange coupling interaction between the crystals in the 10-100 nm scale, implied by the maximum value (δM)max of the Henkel plot, could be roughly described by the ratio of the average width of the magnetic spots w^- to the average crystal size D^- for the ribbons. Moreover, we find that the intrinsic coercivity jHc of the ribbons is sensitive to their crystal sizes, and the smaller D^-, the higher jHc. Finally, by using roughness analysis, the curve of the root mean square values (δФ)rms of the phase shift of the magnetic force images versus the boron content x is obtained, which is qualitatively consistent with that of the magnetization σ12 kOe of the ribbons versus x. 相似文献