聚乙烯基咔唑与Alq3混合薄膜的发光性能与能量传递过程

研究了Alq3与聚乙烯基咔唑(PVK)按不同比例的混合体系制备的薄膜的发光特性.通过对混合薄膜的吸收光谱、激发光谱和发射光谱的分析，研究了PVK与Alq3之间的 能量传递规律.当Alq3与PVK的质量比为1∶7时，能量传递效率最高.用一个由单链模 型扩展到包括杂质的哈密顿量对实验进行模拟，发现该模型能够较好地解释有关的实验结果. 关键词： 吸收光谱 激发光谱 发射光谱 能量传递     

Stress State of Multilayer Thin-Walled Elements with Interfacial Defects of Structure

Based on the discrete-structural theory of thin plates and shells, a calculation model for thin-walled elements consisting of a number of rigid anisotropic layers is put forward. It is assumed that the transverse shear and compression stresses are equal on the interfaces. Elastic slippage is allowed over the interfaces between adjacent layers. The solution to the problem is obtained in a geometrically nonlinear statement with account of the influence of transverse shear and compression strains. The stress-strain state of circular two-layer transversely isotropic plates, both without defects and with a local area of adhesion failure at their center, is investigated numerically and experimentally. It is found that the kinematic and static contact conditions on the interfaces of layered thin-walled structural members greatly affect the magnitude of stresses and strains. With the use of three variants of calculation models, in the cases of perfect and weakened contact conditions between layers, the calculation results for circular plates are compared. It is revealed that the variant suggested in this paper adequately reflects the behavior of layered thin-walled structural elements under large deformations. __________ Translated from Mekhanika Kompozitnykh Materialov, Vol. 41, No. 6, pp. 761–772, November–December, 2005.     

Resolving Discrepancy between Theoretical and Experimental Optical Trapping Forces Using Effects of Beam Waist and Trapping Position Displacement due to Gravity

Optical trapping forces of polystyrene microspheres are analyzed both theoretically and experimentally, and comparisons are made between the two. Discrepancies are mainly caused by straight-ray approximation for axial trapping, and by trapping-position vertical displacement due to gravity for transverse trapping.     

用横波推导简谐波的能量

本文提出用横波推导简谐波能量的方法，并就此进行了具体时推导。     

Design and operation characteristics of a high power transverse flow pulser sustained cw CO2 laser

A transverse flow, transverse discharge cw CO₂ laser in which de discharge is sustained by employing high repetition rate high voltage pulses has been developed. Pulser sustained discharge through electrodes of innovative design provided uniform excitation at electrical input power densities more than 10 W/cc. Laser output power more than 2.5 kW was obtained in a laser gas mixture consisting of 0.5 mbar of CO₂, 16 mbar of N₂ and 38.5 mbar of He. Design details and operational characteristics of this laser are presented.     

An unflexural refined model of deformation of multilayered plates on an undeformable foundation

The stress-strain state of multilayered plates on an undeformable foundation is investigated. The design diagram of a transversely loaded plate is formed by supplementing it with a symmetric one about the contact surface of the foundation. The double-thickness plate obtained becomes loaded bilaterally and symmetrically about its midsurface. In such a way, only unflexural deformations can be modeled, which reduces the number of unknowns and the general order of differentiation of the resolving system of equations. The refined continual model developed takes into account the deformations of transverse shear and transverse compression in high iterative approximations. The cases of a rigid contact between the foundation and the plate and frictionless slip of the plate over the foundation are considered. Calculations confirm the efficiency of such an approach, which allows one to obtain solutions qualitatively and quantitatively close to three-dimensional ones. __________ Translated from Mekhanika Kompozitnykh Materialov, Vol. 42, No. 5, pp. 643–654, September–October, 2006.     

二极管激光侧泵浦单横模100Hz电光调Q激光器

介绍了二极管激光侧泵浦单横模１００Ｈｚ电光调Ｑ激光器的实验结果。泵浦源为一个线阵准连续１００Ｗ二极管激光器，激光工作介质为ＮｄＹＡＧ薄梯形板条，板条与泵浦源间用柱透镜耦合，ＫＤ＊Ｐ电光晶体调Ｑ。在１００Ｈｚ重复频率下，获得单脉冲能量２．３７ｍＪ，脉宽小于７ｎｓ，光束质量因子Ｍ２＝１．１的１．０６μｍ激光，光－光效率为８．５％，斜效率为１８．７％。     

厄米-双曲余弦-高斯光束的瞄准稳定性

用失调叠加积分的方法 ,对厄米双曲余弦高斯光束的瞄准稳定性作了研究 ,得到了厄米双曲余弦高斯光束失调因子 ηm2 的精确解析公式和近似解析公式 ,并用数值计算了相对横向偏移和相对角向偏移对失调因子ηm2 的影响以及对精确解析公式和近似解析公式的适用范围作了分析和说明。     

Stress concentration around a circular hole in a transversely isotropic spherical shell

Analytical expressions for the stresses near a circular hole in a transversely isotropic shallow spherical shell under uniform pressure are derived. The form of the solution depends on the range of change in the compliance to transverse shear. The influence of the relative radius of the hole and the compliance to transverse shear on the stress concentration is analyzed.__________Translated from Prikladnaya Mekhanika, Vol. 40, No. 12, pp. 99–106, December 2004.     

Operational characteristics and power scaling of a transverse flow transversely excited CW CO<Subscript>2</Subscript> laser

Transverse flow transversely excited (TFTE) CO₂ lasers are easily scalable to multikilowatt level. The laser power can be scaled up by increasing the volumetric gas flow and discharge volume. It was observed in a TFTE CW CO₂ laser having single row of pins as an anode and tubular cathode that the laser power was not increasing when the discharge volume and the gas volumetric flow were increased by increasing the electrode separation keeping the gas flow velocity constant. The discharge voltage too remained almost constant with the change of electrode separation at the same gas flow velocity. This necessitated revision of the scaling laws for designing this type of high power CO₂ laser. Experimental results of laser performance for different electrode separations are discussed and the modifications in the scaling laws are presented.